Electron-impact excitation of FeII - Collision strengths and effective collision strengths for low-lying fine-structure forbidden transitions

Context. Absorption or emission lines of Fe II are observed in many astrophysical spectra and accurate atomic data are required to interpret these lines. The calculation of electron-impact excitation rates for transitions among even the lowest lying levels of Fe II is a formidable task for theoreticians.

Aims. In this paper, we present collision strengths and effective collision strengths for electron-impact excitation of Fe II for low-lying forbidden transitions among the lowest 16 fine-structure levels arising from the four LS states 3d(6)4s D-6(e), 3d(7) F-4(e), 3d(6)4s D-4(e), and 3d(7) P-4(e). The effective collision strengths are calculated for a wide range of electron temperatures of astrophysical importance from 30-100 000 K.

Methods. The parallel suite of Breit-Pauli codes are utilised to compute the collision cross sections for electron-impact excitation of Fe II and relativistic terms are included explicitly in both the target and the scattering approximation. 100 LS or 262-jj levels formed from the basis configurations 3d(6)4s, 3d(7), and 3d(6)4p were included in the wavefunction representation of the target, including all doublet, quartet, and sextet terms. Collision strengths for a total of 34191 individual transitions were computed.

Results. A detailed comparison is made with previous theoretical works and significant differences were found to occur in the effective collision strengths, particularly at low temperatures.

Light and electron microscopy of microstructure and fractography of an ultrahigh-strength martensitic steel

Microstructure, tensile properties and fractography have been examined in the oil-quenched samples of a low-alloy ultrahigh strength 4340 steel. Intergranular fracture was revealed to locate at the fracture origin. However, neither the quenched Charpy V-notched impact samples nor the tempered tensile samples showed such intergranular fracture behavior. The effects of loading rate and precipitation are discussed.

Hot deformation characteristics of a nitride strengthened martensitic heat resistant steel

Constitutive equations including an Arrhenius term have been applied to analyze the hot deformation behavior of a nitride-strengthened (NS) martensitic heat resistant steel in temperature range of 900–1200 °C and strain rate range of 0.001–10 /s. On the basis of analysis of the deformation data, the stress–strain curves up to the peak were divided into four regions, in sequence, representing four processes, namely hardening, dynamic recovery (DRV), dynamic strain induced transformation (DSIT), and dynamic recrystallization (DRX), according to the inflection points in ∂θ/∂σ∂θ/∂σ and ∂(∂θ/∂σ)/∂σ∂(∂θ/∂σ)/∂σ curves. Some of the inflection points have their own meanings. For examples, the minimum of ∂θ/∂σ∂θ/∂σ locates the start of DRV and the maximum of it indicates the start of DRX. The results also showed that the critical strain of DRX was sensitive to ln(Z) below 40, while the critical stress of DRX was sensitive to it above 40. The final microstructures under different deformation conditions were analyzed in terms of softening processes including DRV, DRX, metadynamic crystallization (MDRX) and DSIT.

Laves-phase in the China Low Activation Martensitic steel after long-term creep exposure

Creep test at 600 °C under 130 MPa for the China Low Activation Martensitic (CLAM) steel was performed up to 7913 h in this study. According to the stress level, the crept specimen was divided into three regions in order to investigate the influence of stress on Laves-phase formation. In addition to the expected M23C6 carbide and MX carbonitride, the amount and the size of Laves phase in these three regions on the crept specimen were characterized by transmission electron microscopy. Laves phase could be found in all the regions and the creep stress could promote the formation of Laves phase.

FRENKEL-KONTOROVA DOMAIN-WALL PHASE-TRANSITIONS IN AN ADSORBED LAYER - POTASSIUM ON CO(10(1)OVER-BAR-0)

As the potassium fractional coverage of a cobalt {1010BAR} surface is increased over the range 0.2 to 0.6 monolayer the adlayer passes through a series of phase transitions. A commensurate phase is formed at exactly 0.5 monolayer, and corresponds to adatoms bonded in high-symmetry hollow sites on the unreconstructed cobalt surface, with an effective adatom radius lying between the ionic and covalent radii of potassium. A detailed structural study shows that the structural transitions can be characterised within a one-dimensional Frenkel-Kontorova model, with small lateral displacements of adatoms away from hollow sites in the low and high coverage phases. The low coverage phases progress from a distributed vacancy structure to a low density domain-wall structure; while the high coverage phase formed above half a monolayer is a high density asymmetric domain-wall structure.

Traditions and transitions: teenagers’ perceptions of parading in Belfast

The purpose of this article is to explore and illuminate teenagers' experiences of, and attitudes to, parades in Belfast. The research draws on responses from 125 teenagers located in interface areas (areas where Catholics and Protestants live side by side but apart) to government supported attempts to rebrand Orangefest (traditional parade associated with Protestant/Unionist/Loyalist community) and St Patrick's Day (traditional parade associated with Catholic/Nationalist/Republican community) as all-inclusive community events. For the most part, young people access these parades in pre-existing, single identity peer groups and view these parades as either inclusive or exclusive calling into question the extent to which Belfast's city centre can be viewed as shared space.

Radiative rates for E1, E2, M1, and M2 transitions in the Br-like ions Sr IV, Y V, Zr VI, Nb VII, and Mo VIII

Energies and lifetimes are reported for the lowest 375 levels of five Br-like ions, namely SrIV, YV, ZrVI, NbVII, and MoVIII, mostly belonging to the 4s²4p⁵, 4s²4p⁴4ℓ, 4s4p⁶, 4s²4p⁴5ℓ, 4s²4p³4d², 4s4p⁵4ℓ, and 4s4p⁵5ℓ configurations. Extensive configuration interaction has been included and the general-purpose relativistic atomic structure package (grasp) has been adopted for the calculations. Additionally, radiative rates are listed among these levels for all E1, E2, M1, and M2 transitions. From a comparison with the measurements, the majority of our energy levels are assessed to be accurate to better than 2%, although discrepancies between theory and experiment for a few are up to 6%. An accuracy assessment of the calculated radiative rates (and lifetimes) is more difficult, because no prior results exist for these ions.

Energy levels, radiative rates and lifetimes for transitions in Br-like ions with 38 ≤ Z ≤ 42

Energy levels and radiative rates for transitions in five Br-like ions (Sr IV, Y V, Zr VI, Nb VII and Mo VIII) are calculated with the general-purpose relativistic atomic structure package (GRASP). Extensive configuration interaction has been included and results are presented among the lowest 31 levels of the 4s²4p⁵, 4s²4p⁴4d and 4s4p⁶ configurations. Lifetimes for these levels have also been determined, although unfortunately no measurements are available with which to compare. However, recently theoretical results have been reported by Singh et al (2013 Phys. Scr. 88 035301) using the same GRASP code. But their reported data for radiative rates and lifetimes cannot be reproduced and show discrepancies of up to five orders of magnitude with the present calculations.

Energy levels, radiative rates and electron impact excitation rates for transitions in Be-like Cl XIV, K XVI and Ge XXIX

Results for energy levels, radiative rates and electron impact excitation (effective) collision strengths for transitions in Be-like Cl XIV, K XVI and Ge XXIX are reported. For the calculations of energy levels and radiative rates the general-purpose relativistic atomic structure package is adopted, while for determining the collision strengths and subsequently the excitation rates, the Dirac atomic R-matrix code is used. Oscillator strengths, radiative rates and line strengths are listed for all E1, E2, M1 and M2 transitions among the lowest 98 levels of the n ≤ 4 configurations. Furthermore, lifetimes are provided for all levels and comparisons made with available theoretical and experimental results. Resonances in the collision strengths are resolved in a fine energy mesh and averaged over a Maxwellian velocity distribution to obtain the effective collision strengths. Results obtained are listed over a wide temperature range up to 10^7.8 K, depending on the ion.

Energy levels, radiative rates, and lifetimes for transitions in W LVIII

Energy levels and radiative rates are reported for transitions in Cl-like W LVIII. Configuration interaction (CI) has been included among 44 configurations (generating 4978 levels) over a wide energy range up to 363 Ryd, and the general-purpose relativistic atomic structure package (grasp) adopted for the calculations. Since no other results of comparable complexity are available, calculations have also been performed with the flexible atomic code (fac), which help in assessing the accuracy of our results. Energies are listed for the lowest 400 levels (with energies up to ~98 Ryd), which mainly belong to the 3s²3p⁵, 3s3p⁶, 3s²3p⁴3d, 3s²3p³3d², 3s3p⁴3d², 3s²3p²3d³, and 3p⁶3d configurations, and radiative rates are provided for four types of transitions, i.e.E1, E2, M1, and M2. Our energy levels are assessed to be accurate to better than 0.5%, whereas radiative rates (and lifetimes) should be accurate to better than 20% for a majority of the strong transitions.

Energy levels, radiative rates, and lifetimes for transitions in W XL

Energy levels and radiative rates are reported for transitions in Br-like tungsten, W XL, calculated with the general-purpose relativistic atomic structure package (grasp). Configuration interaction (CI) has been included among 46 configurations (generating 4215 levels) over a wide energy range up to 213 Ryd. However, for conciseness results are only listed for the lowest 360 levels (with energies up to ~43 Ryd), which mainly belong to the 4s²4p⁵,4s²4p⁴4d,4s²4p⁴4f,4s4p⁶,4p⁶4d,4s4p⁵4d,4s²4p³4d², and 4s²4p³4d4f configurations, and provided for four types of transitions, E1, E2, M1, and M2. Comparisons are made with existing (but limited) results. However, to fully assess the accuracy of our data, analogous calculations have been performed with the flexible atomic code, including an even larger CI than in grasp. Our energy levels are estimated to be accurate to better than 0.02 Ryd, whereas results for radiative rates (and lifetimes) should be accurate to better than 20% for a majority of the strong transitions.

Energy levels, radiative rates and electron impact excitation rates for transitions in AlX

Energy levels, radiative rates and lifetimes are calculated among the lowest 98 levels of the n ≤4 configurations of Be-like Al X. The GRASP (General-purpose Relativistic Atomic Structure Package) is adopted and data are provided for all E1, E2, M1 and M2 transitions. Similar data are also obtained with the FAC (Flexible Atomic Code) to assess the accuracy of the calculations. Based on comparisons between calculations with the two codes as well as with available measurements, our listed energy levels are assessed to be accurate to better than 0.3 per cent. However, the accuracy for radiative rates and lifetimes is estimated to be about 20 per cent. Collision strengths are also calculated for which the DARC (Dirac Atomic R-matrix Code) is used. A wide energy range (up to 380 Ryd) is considered and resonances resolved in a fine energy mesh in the thresholds region. The collision strengths are subsequently averaged over a Maxwellian velocity distribution to determine effective collision strengths up to a temperature of 1.6 × 10⁷ K. Our results are compared with the previous (limited) atomic data and significant differences (up to a factor of 4) are noted for several transitions, particularly those which are not allowed in jj coupling.