Drift:for tape

nominated for Prix Leonce Petitot, NOROIT, Arras, France

SWAT-1: The effectiveness of a 'site visit' intervention on recruitment rates in a multi-centre randomised trial

Background: Recruitment rates in multi-centre randomised trials often fall below target recruitment rates, causing problems for study outcomes. The Studies Within A Trial (SWAT) Programme, established by the All-Ireland Hub for Trials Methodology Research in collaboration with the Medical Research Council Network of Hubs in the United Kingdom and others, is developing methods for evaluating aspects of trial methodology through the conduct of research within research. A recently published design for a SWAT-1 provides a protocol for evaluating the effect of a site visit by the principal investigator on recruitment in multi-centre trials.

Methods: Using the SWAT-1 design, the effect of a site visit, with the sole purpose of discussing trial recruitment, on recruitment rates in a large multicentre trial in the Republic of Ireland was evaluated. A controlled before and after intervention comparison was used, where the date of the site visit provides the time point for the intervention, and for the comparison to control sites. Site A received the intervention. Site B and Site C acted as the controls. Z-scores for proportions were calculated to determine within site recruitment differences. Odds ratios and 95% confidence intervals were calculated to determine between site recruitment differences.

Results: Recruitment rates were increased in Site A post-intervention (17% and 14% percentage point increases at 1 and 3 months, respectively). No differences in recruitment occurred in Site B or in Site C. Comparing between site differences, at 3 months post-intervention, a statistically significant difference was detected in favour of higher recruitment in Site A (34% versus 25%; odds ratio 1.57, 95% confidence interval 1.09 to 2.26).

Conclusions: This is the first reported example of a study in the SWAT programme.. It provides evidence that a site visit, combined with a scheduled meeting, increases recruitment in a clinical trial. Using this example, other researchers might be encouraged to consider conducting a similar study, allowing the findings of future SWAT-1s to be compared and combined, so that higher level evidence on the effect of a site visit by the principal investigator can be obtained.

Radiative rates for E1, E2, M1, and M2 transitions in the Br-like ions Sr IV, Y V, Zr VI, Nb VII, and Mo VIII

Energies and lifetimes are reported for the lowest 375 levels of five Br-like ions, namely SrIV, YV, ZrVI, NbVII, and MoVIII, mostly belonging to the 4s²4p⁵, 4s²4p⁴4ℓ, 4s4p⁶, 4s²4p⁴5ℓ, 4s²4p³4d², 4s4p⁵4ℓ, and 4s4p⁵5ℓ configurations. Extensive configuration interaction has been included and the general-purpose relativistic atomic structure package (grasp) has been adopted for the calculations. Additionally, radiative rates are listed among these levels for all E1, E2, M1, and M2 transitions. From a comparison with the measurements, the majority of our energy levels are assessed to be accurate to better than 2%, although discrepancies between theory and experiment for a few are up to 6%. An accuracy assessment of the calculated radiative rates (and lifetimes) is more difficult, because no prior results exist for these ions.

Energy levels, radiative rates and lifetimes for transitions in Br-like ions with 38 ≤ Z ≤ 42

Energy levels and radiative rates for transitions in five Br-like ions (Sr IV, Y V, Zr VI, Nb VII and Mo VIII) are calculated with the general-purpose relativistic atomic structure package (GRASP). Extensive configuration interaction has been included and results are presented among the lowest 31 levels of the 4s²4p⁵, 4s²4p⁴4d and 4s4p⁶ configurations. Lifetimes for these levels have also been determined, although unfortunately no measurements are available with which to compare. However, recently theoretical results have been reported by Singh et al (2013 Phys. Scr. 88 035301) using the same GRASP code. But their reported data for radiative rates and lifetimes cannot be reproduced and show discrepancies of up to five orders of magnitude with the present calculations.

Energy levels, radiative rates and electron impact excitation rates for transitions in Be-like Cl XIV, K XVI and Ge XXIX

Results for energy levels, radiative rates and electron impact excitation (effective) collision strengths for transitions in Be-like Cl XIV, K XVI and Ge XXIX are reported. For the calculations of energy levels and radiative rates the general-purpose relativistic atomic structure package is adopted, while for determining the collision strengths and subsequently the excitation rates, the Dirac atomic R-matrix code is used. Oscillator strengths, radiative rates and line strengths are listed for all E1, E2, M1 and M2 transitions among the lowest 98 levels of the n ≤ 4 configurations. Furthermore, lifetimes are provided for all levels and comparisons made with available theoretical and experimental results. Resonances in the collision strengths are resolved in a fine energy mesh and averaged over a Maxwellian velocity distribution to obtain the effective collision strengths. Results obtained are listed over a wide temperature range up to 10^7.8 K, depending on the ion.

Energy levels, radiative rates, and lifetimes for transitions in W LVIII

Energy levels and radiative rates are reported for transitions in Cl-like W LVIII. Configuration interaction (CI) has been included among 44 configurations (generating 4978 levels) over a wide energy range up to 363 Ryd, and the general-purpose relativistic atomic structure package (grasp) adopted for the calculations. Since no other results of comparable complexity are available, calculations have also been performed with the flexible atomic code (fac), which help in assessing the accuracy of our results. Energies are listed for the lowest 400 levels (with energies up to ~98 Ryd), which mainly belong to the 3s²3p⁵, 3s3p⁶, 3s²3p⁴3d, 3s²3p³3d², 3s3p⁴3d², 3s²3p²3d³, and 3p⁶3d configurations, and radiative rates are provided for four types of transitions, i.e.E1, E2, M1, and M2. Our energy levels are assessed to be accurate to better than 0.5%, whereas radiative rates (and lifetimes) should be accurate to better than 20% for a majority of the strong transitions.

Energy levels, radiative rates, and lifetimes for transitions in W XL

Energy levels and radiative rates are reported for transitions in Br-like tungsten, W XL, calculated with the general-purpose relativistic atomic structure package (grasp). Configuration interaction (CI) has been included among 46 configurations (generating 4215 levels) over a wide energy range up to 213 Ryd. However, for conciseness results are only listed for the lowest 360 levels (with energies up to ~43 Ryd), which mainly belong to the 4s²4p⁵,4s²4p⁴4d,4s²4p⁴4f,4s4p⁶,4p⁶4d,4s4p⁵4d,4s²4p³4d², and 4s²4p³4d4f configurations, and provided for four types of transitions, E1, E2, M1, and M2. Comparisons are made with existing (but limited) results. However, to fully assess the accuracy of our data, analogous calculations have been performed with the flexible atomic code, including an even larger CI than in grasp. Our energy levels are estimated to be accurate to better than 0.02 Ryd, whereas results for radiative rates (and lifetimes) should be accurate to better than 20% for a majority of the strong transitions.

Energy levels, radiative rates and electron impact excitation rates for transitions in AlX

Energy levels, radiative rates and lifetimes are calculated among the lowest 98 levels of the n ≤4 configurations of Be-like Al X. The GRASP (General-purpose Relativistic Atomic Structure Package) is adopted and data are provided for all E1, E2, M1 and M2 transitions. Similar data are also obtained with the FAC (Flexible Atomic Code) to assess the accuracy of the calculations. Based on comparisons between calculations with the two codes as well as with available measurements, our listed energy levels are assessed to be accurate to better than 0.3 per cent. However, the accuracy for radiative rates and lifetimes is estimated to be about 20 per cent. Collision strengths are also calculated for which the DARC (Dirac Atomic R-matrix Code) is used. A wide energy range (up to 380 Ryd) is considered and resonances resolved in a fine energy mesh in the thresholds region. The collision strengths are subsequently averaged over a Maxwellian velocity distribution to determine effective collision strengths up to a temperature of 1.6 × 10⁷ K. Our results are compared with the previous (limited) atomic data and significant differences (up to a factor of 4) are noted for several transitions, particularly those which are not allowed in jj coupling. 

Energy levels, radiative rates and electron impact excitation rates for transitions in Si II

Energies for the lowest 56 levels, belonging to the 3s² 3p, 3s 3p², 3p³, 3s² 3d, 3s 3p 3d, 3s² 4ℓ and 3s² 5ℓ configurations of Si II, are calculated using the General-purpose Relativistic Atomic Structure Package (GRASP) code. Analogous calculations have also been performed (for up to 175 levels) using the FlexibleAtomicCode (FAC). Furthermore, radiative rates are calculated for all E1, E2, M1 and M2 transitions. Extensive comparisons are made with available theoretical and experimental energy levels, and the accuracy of the present results is assessed to be better than 0.1Ryd. Similarly, the accuracy for radiative rates (and subsequently lifetimes) is estimated to be better than 20 per cent for most of the (strong) transitions. Electron impact excitation collision strengths are also calculated, with the Dirac Atomic R-matrix Code (DARC), over a wide energy range up to 13 Ryd. Finally, to determine effective collision strengths, resonances are resolved in a fine energy mesh in the thresholds region. These collision strengths are averaged over a Maxwellian velocity distribution and results listed over a wide range of temperatures, up to 10^5.5 K. Our data are compared with earlier R-matrix calculations and differences noted, up to a factor of 2, for several transitions. Although scope remains for improvement, the accuracy for our results of collision strengths and effective collision strengths is assessed to be about 20 per cent for a majority of transitions. 

Radiative rates for E1, E2, M1, and M2 transitions among the 3s23p5, 3s3p6, and 3s23p43d configurations of Cl-like W LVIII

We report calculations of energy levels, radiative decay rates, and lifetimes for transitions among the 3s²3p⁵, 3s3p⁶, and 3s²3p⁴3d configurations of Cl-like W LVIII. The general-purpose relativistic atomic structure package (GRASP) has been adopted for our calculations. Comparisons are made with the most recent results of Mohan et al. (Can. J. Phys. 92, 177 (2014). doi:10.1139/cjp-2013-0348) and discrepancies in lifetimes are noted, up to four orders of magnitude in some instances. Our energy levels are estimated to be accurate to better than 0.5%, whereas results for radiative rates and lifetimes should be accurate to better than 20%.

Comment on "multiconfiguration Dirac-Fock energy levels and radiative rates for Br-like tungsten" by S. Aggarwal, A.K.S. Jha, and M. Mohan [Can. J. Phys. 91, 394 (2013)]

We report calculations of energy levels and oscillator strengths for transitions in W XL, undertaken with the general-purpose relativistic atomic structure package (GRASP) and flexible atomic code (FAC). Comparisons are made with existing results and the accuracy of the data is assessed. Discrepancies with the most recent results of S. Aggarwal et al. (Can. J. Phys. 91, 394 (2013)) are up to 0.4 Ryd and up to two orders of magnitude for energy levels and oscillator strengths, respectively. Discrepancies for lifetimes are even larger, up to four orders of magnitude for some levels. Our energy levels are estimated to be accurate to better than 0.5% (i.e., 0.2 Ryd), whereas results for oscillator strengths and lifetimes should be accurate to better than 20%.

Energy levels and radiative rates for transitions in Ti VII

We report calculations of energy levels, radiative rates, oscillator strengths and line strengths for transitions among the lowest 231 levels of Ti VII. The general-purpose relativistic atomic structure package and flexible atomic code are adopted for the calculations. Radiative rates, oscillator strengths and line strengths are provided for all electric dipole (E1), magnetic dipole (M1), electric quadrupole (E2) and magnetic quadrupole (M2) transitions among the 231 levels, although calculations have been performed for a much larger number of levels (159 162). In addition, lifetimes for all 231 levels are listed. Comparisons are made with existing results and the accuracy of the data is assessed. In particular, the most recent calculations reported by Singh et al (2012 Can. J. Phys. 90 833) are found to be unreliable, with discrepancies for energy levels of up to 1 Ryd and for radiative rates of up to five orders of magnitude for several transitions, particularly the weaker ones. Based on several comparisons among a variety of calculations with two independent codes, as well as with the earlier results, our listed energy levels are estimated to be accurate to better than 1% (within 0.1 Ryd), whereas results for radiative rates and other related parameters should be accurate to better than 20%.

Energy levels and radiative rates for transitions in Ti VI

We report on calculations of energy levels, radiative rates, oscillator strengths and line strengths for transitions among the lowest 253 levels of the (1s22s22p6 ) 3s23p5 , 3s3p6 , 3s23p43d, 3s3p53d, 3s23p33d2 , 3s23p44s, 3s23p44p and 3s23p44d configurations of Ti VI. The general-purpose relativistic atomic structure package and flexible atomic code are adopted for the calculations. Radiative rates, oscillator strengths and line strengths are reported for all electric dipole (E1), magnetic dipole (M1), electric quadrupole (E2) and magnetic quadrupole (M2) transitions among the 253 levels, although calculations have been performed for a much larger number of levels. Comparisons are made with existing available results and the accuracy of the data is assessed. Additionally, lifetimes for all 253 levels are listed, although comparisons with other theoretical results are limited to only 88 levels. Our energy levels are estimated to be accurate to better than 1% (within 0.03 Ryd), whereas results for other parameters are probably accurate to better than 20%. A reassessment of the energy level data on the National Institute of Standards and Technology website for Ti VI is suggested.