The use of recycled demolition aggregate in precast concrete products – Phase III: Concrete pavement flags

A study undertaken at the University of Liverpool has investigated the potential for using construction and demolition waste (C&DW) derived aggregate in the manufacture of a range of precast concrete products, i.e. building and paving blocks and pavement flags. Phase III, which is reported here, investigated
concrete pavement flags. This was subsequent to studies on building and paving blocks. Recycled demolition aggregate can be used to replace newly quarried limestone aggregate, usually used in coarse (6 mm) and fine (4 mm-to-dust) gradings. The first objective was, as was the case with concrete building
and paving blocks, to replicate the process used by industry in fabricating concrete pavement flags in the laboratory. The ‘‘wet’’ casting technique used by industry for making concrete flags requires a very workable mix so that the concrete flows into the mould before it is compressed. Compression squeezes out water from the top as well as the bottom of the mould. This industrial casting procedure was successfully replicated in the laboratory by using an appropriately modified cube crushing machine and a special mould typical of what is used by industry. The mould could be filled outside of the cube crushing machine and then rolled onto a steel frame and into the machine for it to be compressed. The texture and mechanical properties of the laboratory concrete flags were found to be similar to the factory ones. The experimental work involved two main series of tests, i.e. concrete flags made with concrete- and
masonry-derived aggregate. Investigation of flexural strength was required for concrete paving flags. This is different from building blocks and paving blocks which required compressive and tensile splitting strength respectively. Upper levels of replacement with recycled demolition aggregate were determined
that produced similar flexural strength to paving flags made with newly quarried aggregates, without requiring an increase in the cement content. With up to 60% of the coarse or 40% of the fine fractions replaced with concrete-derived aggregates, the target mean flexural strength of 5.0 N/mm2 was still
achieved at the age of 28 days. There was similar detrimental effect by incorporating the fine masonry-derived aggregate. A replacement level of 70% for coarse was found to be satisfactory and also conservative. However, the fine fraction replacement could only be up to 30% and even reduced to 15% when used for mixes where 60% of the coarse fraction was also masonry-derived aggregate.

Risk of Barrett's oesophagus, oesophageal adenocarcinoma and reflux oesophagitis and the use of nitrates and asthma medications

To investigate the relationship between use of asthma medication and nitrates and risk of reflux oesophagitis, Barrett's oesophagus and oesophageal adenocarcinoma.

Change in the use of and attitude to peak flow measurement among general practitioners in Northern Ireland between 1989 and 1994

In 1994 we repeated a study first performed in 1989 to assess the change in general practitioners' use of and attitudes to peak flow measurement. Of 232 general practitioners surveyed, 199 (86%) and 192 (83%) responded in 1989 and 1994 respectively. The percentage who reported having patients using domiciliary peak flow monitoring rose form 58.3 (95% confidence limits 51.4 to 65.2)% to 97.9 (95.9 to 99.9)%. The percentage who reported 'usually' using peak flow measurements for the diagnosis and management of asthma rose from 81.9 (76.5 to 87.3)% to 93.2 (89.6 to 96.8)% and from 83.3 (78.1 to 88.5)% to 95.8 (92.9 to 98.7)% respectively. An unchanged proportion took peak flow meters on house calls. General practitioners have become more aware of the potential of peak flow measurements but are still unlikely to have a meter available to assess patients seen at home. They are therefore likely to be ill-equipped to manage acute exacerbations of asthma in this setting.

Cows, milk and religion: the use of dairy produce in early societies

This review of documentary sources, particularly from Early Mesopotamia, Egypt, India and Europe seeks to show how the range of dairy products varied in different areas and to demonstrate that in many societies, cows and dairying played an important role in early religious practice. The range of dairy products consumed also varied greatly between different societies and the use of milk did not automatically imply that dairying technology was applied to its full potential. Also, in some cultures the consumption of milk was confined to certain sections of society.

Specular resentment : San-Antonio, Céline and the use of proletarian rhetoric in literary criticism

The charge of »Ressentiment« can in today's world – less from traditionally conservative quarters than from the neo-positivist discourses of particular forms of liberalism – be used to undermine the argumentative credibility of political opponents, dissidents and those who call for greater »justice«. The essays in this volume draw on the broad spectrum of cultural discourse on »Ressentiment«, both in historical and contemporary contexts. Starting with its conceptual genesis, the essays also show contemporary nuances of »Ressentiment« as well as its influence on aesthetic and literary discourse in the 20th century.

The use of Ecological and Carbon Footprint Analysis in regional policy making: application and insights using the REAP model

This paper builds on and extends previous research to contribute to ongoing discussion on the use of resource and carbon accounting tools in regional policy making. The Northern Visions project has produced the first evidence-based footpath setting out the actions that need to be taken to achieve the step changes in the Ecological and Carbon Footprint of Northern Ireland. A range of policies and strategies were evaluated using the Resources and Energy Analysis Programme. The analysis provided the first regional evidence base that current sustainable development policy commitments would not lead to the necessary reductions in either the Ecological Footprint or carbon dioxide emissions. Building on previous applications of Ecological Footprint analysis in regional policy making, the research has demonstrated that there is a valuable role for Ecological and Carbon Footprint Analysis in policy appraisal. The use of Ecological and Carbon Footprint Analysis in regional policy making has been evaluated and recommendations made on ongoing methodological development. The authors hope that the research can provide insights for the ongoing use Ecological and Carbon Footprint Analysis in regional policy making and help set out the priorities for research to support this important policy area

The use of material flow analysis and the ecological footprint in regional policy-making: application and insights from Northern Ireland.

This paper aims to contribute to the ongoing debate on the use of resource accounting tools in regional policy making. The Northern Limits project applied Material Flow Analysis and Ecological Footprinting to regional policy making in Northern Ireland over a number of years. The early phase of the research informed the regions first sustainable development strategy which was published in 2006 with key targets relating to the Ecological Footprint and improving the resource efficiency of the economy. Phase II identified the next steps required to address data availability and quality and the use of MFA and EF in providing a measurement and monitoring framework for the strategy and in the development of the strategy implementation plan. The use of MFA and Ecological Footprinting in sustainable regional policy making and the monitoring of its implementation is an ongoing process which has raised a number of research issues which can inform the ongoing application and development of these and other resource accounting tools to within Northern Ireland, provide insights for their use in other regions and help set out the priorities for research to support this important policy area.

A study of the use of the trimesium salt of glyphosate to desiccate and ret flax and linseed (Linum usitatissimum) and of its effects on the yield of straw, seed and fibre

A replicated field plot experiment was carried out in Northern Ireland in 1996 with flax, cv Ariane, and linseed, cv Flanders, each grown at seed rates of 500, 1000 and 1500 seeds/m(2), in which a comparison was made between netting of the standing crop, following desiccation by the trimesium salt of glyphosate (Touchdown, Zeneca Ltd.), and water or dew retting of the pulled crop. Application at 4 litres/ha on 9 August, 33 days after the mid-point of flowering (MPF), achieved both desiccation and partial retting of the crop within 14 days. Over 16 % clean long fibre was extracted by scutching the stand-netted flax straw, yielding 800 kg/ha fibre, while water retting achieved 20 extraction and 980 kg/ha yield and dew netting 8.5 % and 420 kg/ha respectively. The dew retting was uneven, resulting in high losses during fibre extraction, while water retting for 7 days at 25 degreesC did not achieve complete retting resulting in a high content of woody fragments in the fibre. Fibre yields increased by almost 50 % with the high v. low seed rate. Linseed was less well retted than flax and contained higher levels of impurity in the extracted long fibre which, after retting, yielded 120 to 310 kg/ha at extraction rates of 2.9 % to 7.5 %.

In a second experiment in 1998 flax cvs. Viola and Evelyn were treated with the timesium salt of glyphosate at rates of 2, 4 or 6 litres/ha 10, 20, 30 or 40 days after MPF on 5 July. Viola desiccated satisfactorily at all spray dates with 4 and 6 litres/ha glyphosate. The 20-day treatment desiccated more slowly than the 30-day and the 2 litres/ha rate did not achieve complete desiccation, but the trimesium salt of glyphosate achieved better desiccation at this timing than that found in earlier studies with the original form of glyphosate. Evelyn desiccated more slowly and less evenly than Viola particularly at the 20-day and 40-day timings. Spraying at MPF + 10 days interrupted early development of the seed and fibre significantly reducing yields. Due to slower desiccation the 20-day timing was no better than the 30-day, which was well retted by harvest 44 days after spraying, and gave the highest yield of clean long fibre. The spraying 40 days after MPF was considered too late in the season to be of practical use. It was concluded that retting of standing flax following desiccation with the trimesium salt of glyphosate was more effective than with the earlier formulation and that resting of the standing crop could achieve equivalent or better retting with similar fibre yields to traditional retting methods. The optimum spray timing was found to be about 30 days after MPF with 4 or 6 litres/ha, the lower rate being adequate for glyphosate responsive varieties such as Viola.

A review on the use of corneal implants for the treatment of presbyopia

In recent years there has seen an increased interest in refractive surgery for the correction of presbyopia. This can be attributed to a number of factors such as the increased demand from patients to have perfect vision without the need for glasses, spurred on by the success of high street refractive laser surgery. Also the World Health Organisation (WHO) estimated in 2005 that over a 1.04 billion people worldwide are affected by presbyopia (Holden et al. 2008). This vast number of people is valued as a potential market and is a huge enticement to the ophthalmic industry to try and develop devices and products to treat this condition. Recent advances in technology have renewed interest in the implantation of corneal inlays for surgical treatment of presbyopia. Dexl et al. (2011) suggest that the reason for this is the further development of biomaterial technology, advances in femtosecond laser and the need for a reversible presbyopic treatment.

First report of the use of a saxitoxin-protein conjugate to develop a DNA aptamer to a small molecule toxin

Saxitoxin (STX) is a low molecular weight neurotoxin mainly produced by certain marine dinoflagellates that, along with its family of similarly related paralytic shellfish toxins, may cause the potentially fatal intoxication known as paralytic shellfish poisoning. Illness and fatality rates are low due to the effective monitoring programs that determine when toxins exceed the established regulatory action level and effectuate shellfish harvesting closures accordingly. Such monitoring programs rely on the ability to rapidly screen large volumes of samples. Many of the screening assays currently available employ antibodies or live animals. This research focused on developing an analytical recognition element that would eliminate the challenges associated with the limited availability of antibodies and the use of animals. Here we report the discovery of a DNA aptamer that targets STX. Concentration-dependent and selective binding of the aptamer to STX was determined using a surface plasmon resonance sensor. Not only does this work represent the first reported aptamer to STX, but also the first aptamer to any marine biotoxin. A novel strategy of using a toxin-protein conjugate for DNA aptamer selection was successfully implemented to overcome the challenges associated with aptamer selection to small molecules. Taking advantage of such an approach could lead to increased diversity and accessibility of aptamers to low molecular weight toxins, which could then be incorporated as analytical recognition elements in diagnostic assays for foodborne toxin detection. The selected STX aptamer sequence is provided here, making it available to any investigator for use in assay development for the detection of STX.