Single-Element and Competitive Metal Mobility Measured with Column Infiltration and Batch Tests

The distribution coefficient, K-d, is often used to quantify heavy metal mobility in soils. Batch sorption or column infiltration tests may be used to measure K-d. The latter are closer to natural soil conditions, but are difficult to conduct in clays. This difficulty can be overcome by using a laboratory centrifuge. An acceleration of 2600 gravities was applied to columns of London Clay, an Eocene clay sub-stratum, and Cu, Ni, and Zn mobility was measured in centrifuge infiltration tests, both as single elements and in dual competition. Single-element K-d values were also obtained from batch sorption tests, and the results from the two techniques were compared. It was found that K-d values obtained by batch tests vary considerably depending on the metal concentration, while infiltration tests provided a single K-d value for each metal. This was typically in the lower end of the range of the batch test K-d values. For both tests, the order of mobility was Ni > Zn > Cu. Metals became more mobile in competition than when in single-element systems: Ni K-d decreased 3.3 times and Zn K-d 3.4 times when they competed with Cu, while Cu decreased only 1.2 times when in competition with either Ni or Zn. Our study showed that competitive sorption between metals increases the mobility of those metals less strongly bound more than it increases the mobility of more strongly bound metals.

A population-based association study of SNPs of GSTP1, MnSOD, GPX2 and Barrett's esophagus and esophageal adenocarcinoma

Oxidative stress appears to be important in the pathogenesis of Barrett's esophagus (BE) and esophageal adenocarcinoma (EAC). Single-nucleotide polymorphisms (SNPs) of antioxidant enzyme genes may play a part in determining individual susceptibility to these diseases. The Factors Influencing the Barrett's Adenocarcinoma Relationship (FINBAR) study is a population-based, case-control study of BE and EAC in Ireland. DNA from EAC (n = 207), BE (> or =3 cm BE at endoscopy with specialized intestinal metaplasia on biopsy, n = 189) and normal population controls (n = 223) were analyzed. Several SNPs spanning the genes for glutathione S-transferase P1 (GSTP1), manganese superoxide dismutase (MnSOD) and glutathione peroxidase 2 (GPX2) were genotyped using multiplex polymerase chain reaction and SNaPshottrade mark. The chi(2) test was used to compare genotype and allele frequencies between case and control subjects. Linkage disequilibrium between SNPs was quantified using Lewontin's D' value and haplotype frequency estimates obtained using Haploview. Eleven SNPs were genotyped (six for GSTP1, three for MnSOD and two for GPX2); all were in Hardy-Weinberg equilibrium. None was significantly associated with EAC or BE even before Bonferroni correction. Odds ratios for EAC for individual SNPs ranged from 0.68 [95% confidence interval (CI) 0.43-1.08] to 1.25 (95% CI 0.73-2.16), and for BE from 0.84 (95% CI 0.52-1.30) to 1.30 (95% CI 0.85-1.97). SNPs in all three genes were in strong linkage disequilibrium (D' > 0.887) but haplotype analysis did not show any significant association with EAC or BE. SNPs involving the GSTP1, MnSOD and GPX2 genes were not associated with BE or EAC. Further studies aimed at identifying susceptibility genes should focus on different antioxidant genes or different pathways.

A comparison of two informative SNP-based strategies for typing Pseudomonas aeruginosa isolates from patients with cystic fibrosis

BACKGROUND: Molecular typing is integral for identifying Pseudomonas aeruginosa strains that may be shared between patients with cystic fibrosis (CF). We conducted a side-by-side comparison of two P. aeruginosa genotyping methods utilising informative-single nucleotide polymorphism (SNP) methods; one targeting 10 P. aeruginosa SNPs and using real-time polymerase chain reaction technology (HRM10SNP) and the other targeting 20 SNPs and based on the Sequenom MassARRAY platform (iPLEX20SNP).

METHODS: An in-silico analysis of the 20 SNPs used for the iPLEX20SNP method was initially conducted using sequence type (ST) data on the P. aeruginosa PubMLST website. A total of 506 clinical isolates collected from patients attending 11 CF centres throughout Australia were then tested by both the HRM10SNP and iPLEX20SNP assays. Type-ability and discriminatory power of the methods, as well as their ability to identify commonly shared P. aeruginosa strains, were compared.

RESULTS: The in-silico analyses showed that the 1401 STs available on the PubMLST website could be divided into 927 different 20-SNP profiles (D-value = 0.999), and that most STs of national or international importance in CF could be distinguished either individually or as belonging to closely related single- or double-locus variant groups. When applied to the 506 clinical isolates, the iPLEX20SNP provided better discrimination over the HRM10SNP method with 147 different 20-SNP and 92 different 10-SNP profiles observed, respectively. For detecting the three most commonly shared Australian P. aeruginosa strains AUST-01, AUST-02 and AUST-06, the two methods were in agreement for 80/81 (98.8%), 48/49 (97.8%) and 11/12 (91.7%) isolates, respectively.

CONCLUSIONS: The iPLEX20SNP is a superior new method for broader SNP-based MLST-style investigations of P. aeruginosa. However, because of convenience and availability, the HRM10SNP method remains better suited for clinical microbiology laboratories that only utilise real-time PCR technology and where the main interest is detection of the most highly-prevalent P. aeruginosa CF strains within Australian clinics.

Influence of compressive loading on chloride ingress through concrete

Chloride-induced corrosion of steel in concrete is one of most important durability and safety concern for reinforced concrete structures. To study chloride ingress into concrete is thus very important. However, most of the researchers focus on the studying chloride ingress through concrete samples without any loading. In reality concrete structures are subjected to different kinds of loads and therefore studying the effect of such loads on chloride transport is critical. In this work, 28 different concrete mixes were subjected to three levels of compressive load (0%, 50% and 75% of compressive failure load – f) for 24 hours. Further to unloading, these samples were subjected to non-steady state chloride diffusion test as per NT Build 443. The results were compared against the diffusion coefficient obtained for concrete samples that had no previous loading. D value for concretes subjected to 75% f showed a significant increase compared to 0% loading condition, but the increase was insignificant for 50% f. The results indicate that the influence of concrete mixes variables on D is more significant than that of loading level. Surface chloride concentration also increased with the loading level, which might be due to the increased concrete surface area caused by micro cracking.

Can diagnostic triage by general practitioners or rheumatology nurses improve the positive predictive value of referrals to early arthritis clinics?

Objectives: To determine whether diagnostic triage by general practitioners (GPs) or rheumatology nurses (RNs) can improve the positive predictive value of referrals to early arthritis clinics (EACs).

Methods: Four GPs and two RNs were trained in the assessment of early in?ammatory arthritis (IA) by four visits to an EAC supervised by hospital rheumatologists. Patients referred to one of three EACs were recruited for study and assessed independently by a GP, an RN and one of six rheumatologists. Each assessor was asked to record their clinical ?ndings and whether they considered the patient to have IA. Each was then asked to judge the appropriateness of the referral according to predetermined guidelines. The rheumatologists had been shown previously to have a satisfactory level of agreement in the assessment of IA.

Results: Ninety-six patients were approached and all consented to take part in the study. In 49 cases (51%), the rheumatologist judged that the patient had IA and that the referral was appropriate. The assessments of GPs and RNs were compared with those of the rheumatologists. Levels of agreement were measured using the kappa value, where 1.0 represents total unanimity. The kappa value was
0.77 for the GPs when compared with the rheumatologists and 0.79 for the RNs. Signi?cant stiffness in the morning or after rest and objective joint swelling were the most important clinical features enabling the GPs and RNs to discriminate between IA and non-IA conditions.

Conclusion: Diagnostic triage by GPs or RNs improved the positive predictive value of referrals to an EAC with a degree of accuracy approaching that of a group of experienced rheumatologists.

The Cost of Sustainability Capital and the Creation of Sustainable Value by Companies

We develop and apply a valuation methodology to calculate the cost of sustainability capital, and, eventually, sustainable value creation of companies. Sustainable development posits that decisions must take into account all forms of capital rather than just economic capital. We develop a methodology that allows calculation of the costs that are associated with the use of different forms of capital. Our methodology borrows the idea from financial economics that the return on capital has to cover the cost of capital. Capital costs are determined as opportunity costs, that is, the forgone returns that would have been created by alternative investments. We apply and extend the logic of opportunity costs to the valuation not only of economic capital but also of other forms of capital. This allows (a) integrated analysis of use of different forms of capital based on a value-based aggregation of different forms of capital, (b) determination of the opportunity cost of a bundle of different forms of capital used in a company, called cost of sustainability capital, (c) calculation of sustainability efficiency of companies, and (d) calculation of sustainable value creation, that is, the value above the cost of sustainability capital. By expanding the well-established logic of the valuation of economic capital in financial markets to cover other forms of capital, we provide a methodology that allows determination of the most efficient allocation of sustainability capital for sustainable value creation in companies. We demonstrate the practicability of the methodology by the valuation of the sustainability performance of British Petroleum (BP).