Restrictions on Aliens in the United Kingdom, 1914-1919 : a Study of the Origins and Political Background of the Aliens Restrictions Acts of 1914 and 1919.

At first glance the Aliens Restriction Act of 1914, which was introduced and passed on the first day of World War One, seems a hasty and ill-prepared piece of legislation. Actually, when examined in the light of Arthur Marwick's thesis that war is a forcing house for pre-existent social and governmental ideas, it becomes clear that the act was not after all the product of hastily formed notions. In point of fact it followed the precedent of detailed draft clauses produced in 1911 by a sub-committee of the Committee of Imperial Defence established to consider the treatment of aliens in the event of war. Indeed the draft clauses and the restrictions embodied in the 1914 act were strikingly similar to restrictions on aliens legislated in 1793. Hostility to aliens had been growing from 1905 to 1914 and this hostility blossomed into xeno-phobia on the outbreak of war, a crucial precondition for the specifically anti-enemy fears of the time. In 1919 the Aliens Restriction (Amendment) Bill was introduced into parliament to extend temporarily the provisions of the 1914 act thus permitting the Home Secretary to plan permanent, detailed legislation. Two minority groups of MPs with extreme views on the treatment of aliens were prominent in the debates on this bill. The extreme Liberal group which advocated leniency in the treatment of aliens had little effect on the final form of the bill, but the extreme Conservative group, which demanded severe restrictions on aliens, succeeded in persuading the government to include detailed restrictions. Despite its allegedly temporary nature, the Aliens Restriction (Amendment) Act of 1919 was renewed annually until 1971.

Refractometry Studies of the Optical Properties of Polymer Films and the Development of Polymer Coated Refractive Index Sensors

Sensors for real-time monitoring of environmental contaminants are essential for protecting ecosystems and human health. Refractive index sensing is a non-selective technique that can be used to measure almost any analyte. Miniaturized refractive index sensors, such as silicon-on-insulator (SOI) microring resonators are one possible platform, but require coatings selective to the analytes of interest. A homemade prism refractometer is reported and used to characterize the interactions between polymer films and liquid or vapour-phase analytes. A camera was used to capture both Fresnel reflection and total internal reflection within the prism. For thin-films (d = 10 μm - 100 μm), interference fringes were also observed. Fourier analysis of the interferogram allowed for simultaneous extraction of the average refractive index and film thickness with accuracies of ∆n = 1-7 ×10-4 and ∆d < 3-5%. The refractive indices of 29 common organic solvents as well as aqueous solutions of sodium chloride, sucrose, ethylene glycol, glycerol, and dimethylsulfoxide were measured at λ = 1550 nm. These measurements will be useful for future calibrations of near-infrared refractive index sensors. A mathematical model is presented, where the concentration of analyte adsorbed in a film can be calculated from the refractive index and thickness changes during uptake. This model can be used with Fickian diffusion models to measure the diffusion coefficients through the bulk film and at the film-substrate interface. The diffusion of water and other organic solvents into SU-8 epoxy was explored using refractometry and the diffusion coefficient of water into SU-8 is presented. Exposure of soft baked SU-8 films to acetone, acetonitrile and methanol resulted in rapid delamination. The diffusion of volatile organic compound (VOC) vapours into polydimethylsiloxane and polydimethyl-co-polydiphenylsiloxane polymers was also studied using refractometry. Diffusion and partition coefficients are reported for several analytes. As a model system, polydimethyl-co-diphenylsiloxane films were coated onto SOI microring resonators. After the development of data acquisition software, coated devices were exposed to VOCs and the refractive index response was assessed. More studies with other polymers are required to test the viability of this platform for environmental sensing applications.