Refractometry Studies of the Optical Properties of Polymer Films and the Development of Polymer Coated Refractive Index Sensors

Sensors for real-time monitoring of environmental contaminants are essential for protecting ecosystems and human health. Refractive index sensing is a non-selective technique that can be used to measure almost any analyte. Miniaturized refractive index sensors, such as silicon-on-insulator (SOI) microring resonators are one possible platform, but require coatings selective to the analytes of interest. A homemade prism refractometer is reported and used to characterize the interactions between polymer films and liquid or vapour-phase analytes. A camera was used to capture both Fresnel reflection and total internal reflection within the prism. For thin-films (d = 10 μm - 100 μm), interference fringes were also observed. Fourier analysis of the interferogram allowed for simultaneous extraction of the average refractive index and film thickness with accuracies of ∆n = 1-7 ×10-4 and ∆d < 3-5%. The refractive indices of 29 common organic solvents as well as aqueous solutions of sodium chloride, sucrose, ethylene glycol, glycerol, and dimethylsulfoxide were measured at λ = 1550 nm. These measurements will be useful for future calibrations of near-infrared refractive index sensors. A mathematical model is presented, where the concentration of analyte adsorbed in a film can be calculated from the refractive index and thickness changes during uptake. This model can be used with Fickian diffusion models to measure the diffusion coefficients through the bulk film and at the film-substrate interface. The diffusion of water and other organic solvents into SU-8 epoxy was explored using refractometry and the diffusion coefficient of water into SU-8 is presented. Exposure of soft baked SU-8 films to acetone, acetonitrile and methanol resulted in rapid delamination. The diffusion of volatile organic compound (VOC) vapours into polydimethylsiloxane and polydimethyl-co-polydiphenylsiloxane polymers was also studied using refractometry. Diffusion and partition coefficients are reported for several analytes. As a model system, polydimethyl-co-diphenylsiloxane films were coated onto SOI microring resonators. After the development of data acquisition software, coated devices were exposed to VOCs and the refractive index response was assessed. More studies with other polymers are required to test the viability of this platform for environmental sensing applications.

Defences of the Niagara Frontier (1764-1870) : An Historical Survey of Fort George, Fort Erie & Fort Mississauga

The intention of the Niagara Parks Commission to undertake restorations of Fort George, Fort Mississauga and Fort Erie has inspired this survey. The aim has not been to create an historical narrative - so many already exist - but rather to present an accurate description of the original appearance, structure and design of each of the Niagara Forts. This it is hoped may be of some practical assistance to those in charge of the actual work of restoration. In the case of Fort Mississauga which was maintained as a military post until 1857, vary complete information has been available. Fort George and Fort Erie were abandoned for military purposes after the War of 1812 and fewer plans and contemporary accounts have survived. While the work of research, involving the collection of every possible plan of the works and every drawing of their appearance as well as the piecing together of material, has been more difficult in the case of the latter forts, it is felt that the essential information has been secured. The use of a number of military terms in the description of the fortifications has been unavoidable and a glossary of these is included on page 66. The list of plans and illustrations is as complete as possible.