Simulating Granite Emplacement and Deformation with Centrifuge Analogue Modelling

The Greater Himalayan leucogranites are a discontinuous suite of intrusions emplaced in a thickened crust during the Miocene southward ductile extrusion of the Himalayan metamorphic core. Melt-induced weakening is thought to have played a critical role in strain localization that facilitated the extrusion. Recent advancements in centrifuge analogue modelling techniques allow for the replication of a broader range of crustal deformation behaviors, enhancing our understanding of large hot orogens. Polydimethylsiloxane (PDMS) is commonly used in centrifuge experiments to model weak melt zones. Difficulties in handling PDMS had, until now, limited its emplacement in models prior to any deformation. A new modelling technique has been developed where PDMS is emplaced into models that have been subjected to some shortening. This technique aims to better understand the effects of melt on strain localization and potential decoupling between structural levels within an evolving orogenic system. Models are subjected to an early stage of shortening, followed by the introduction of PDMS, and then a final stage of shortening. Theoretical percentages of partial melt and their effect on rock strength are considered when adding a specific percentage of PDMS in each model. Due to the limited size of the models, only PDMS sheets of 3 mm thickness were used, which varied in length and width. Within undeformed packages, minimal surface and internal deformation occurred when PDMS is emplaced in the lower layer of the model, showing a vertical volume increase of ~20% within the package; whereas the emplacement of PDMS into the middle layer showed internal dragging of the middle laminations into the lower layer and a vertical volume increase ~30%. Emplacement of PDMS results in ~7% shortening for undeformed and deformed models. Deformed models undergo ~20% additional shortening after two rounds of deformation. Strain localization and decoupling between units occur in deformed models where the degree of deformation changes based on the amount of partial melt present. Surface deformation visible by the formation of a bulge, mode 1 extension cracks and varying surface strain ellipses varies depending if PDMS is present. Better control during emplacement is exhibited when PDMS is added into cooler models, resulting in reduced internal deformation within the middle layer.

The Influence of Geological Process on Interpreting Ediacaran Fossils in the Catalina Formation, Bonavista Peninsula, Newfoundland

Understanding the nature of the earliest complex fossils has presented many challenges over the past century since Billings first described Ediacaran fossils from Newfoundland in 1872. Previous studies have documented abundant Ediacaran fossils in the Bonavista Peninsula of Newfoundland. This thesis focuses on the H14 surface north of Catalina, which contains a nearly monospecific assemblage that includes hundreds of specimens of the rangeomorph, Fractofusus andersoni. Three factors need to be considered when trying to interpret these organisms. The first of these three factors is structural deformation. The area has undergone deformation during the formation of the Appalachian orogenic belt. This has distorted both fossil shape and orientation, requiring retrodeformation to restore the shapes and relationships of fossils to their original form. Two additional taphonomic factors influencing fossil visibility are: partly or completely ash covered fossils and the removal of fossil impressions from the bedding plane by modern weathering. These processes hinder acceptance of some previously published interpretations.