Essays on Firm Heterogeneity with Empirical Applications in Economic History and Agricultural Economics

This thesis uses models of firm-heterogeneity to complete empirical analyses in economic history and agricultural economics. In Chapter 2, a theoretical model of firm heterogeneity is used to derive a statistic that summarizes the welfare gains from the introduction of a new technology. The empirical application considers the use of mechanical steam power in the Canadian manufacturing sector during the late nineteenth century. I exploit exogenous variation in geography to estimate several parameters of the model. My results indicate that the use of steam power resulted in a 15.1 percent increase in firm-level productivity and a 3.0-5.2 percent increase in aggregate welfare. Chapter 3 considers various policy alternatives to price ceiling legislation in the market for production quotas in the dairy farming sector in Quebec. I develop a dynamic model of the demand for quotas with farmers that are heterogeneous in their marginal cost of milk production. The econometric analysis uses farm-level data and estimates a parameter of the theoretical model that is required for the counterfactual experiments. The results indicate that the price of quotas could be reduced to the ceiling price through a 4.16 percent expansion of the aggregate supply of quotas, or through moderate trade liberalization of Canadian dairy products. In Chapter 4, I study the relationship between farm-level productivity and participation in the Commercial Export Milk (CEM) program. I use a difference-in-difference research design with inverse propensity weights to test for causality between participation in the CEM program and total factor productivity (TFP). I find a positive correlation between participation in the CEM program and TFP, however I find no statistically significant evidence that the CEM program affected TFP.

Process Monitoring and Defect Detection of Additive Manufacturing Using Inline Coherent Imaging

With applications ranging from aerospace to biomedicine, additive manufacturing (AM) has been revolutionizing the manufacturing industry. The ability of additive techniques, such as selective laser melting (SLM), to create fully functional, geometrically complex, and unique parts out of high strength materials is of great interest. Unfortunately, despite numerous advantages afforded by this technology, its widespread adoption is hindered by a lack of on-line, real time feedback control and quality assurance techniques. In this thesis, inline coherent imaging (ICI), a broadband, spatially coherent imaging technique, is used to observe the SLM process in 15 - 45 $\mu m$ 316L stainless steel. Imaging of both single and multilayer builds is performed at a rate of 200 $kHz$, with a resolution of tens of microns, and a high dynamic range rendering it impervious to blinding from the process beam. This allows imaging before, during, and after laser processing to observe changes in the morphology and stability of the melt. Galvanometer-based scanning of the imaging beam relative to the process beam during the creation of single tracks is used to gain a unique perspective of the SLM process that has been so far unobservable by other monitoring techniques. Single track processing is also used to investigate the possibility of a preliminary feedback control parameter based on the process beam power, through imaging with both coaxial and 100 $\mu m$ offset alignment with respect to the process beam. The 100 $\mu m$ offset improved imaging by increasing the number of bright A-lines (i.e. with signal greater than the 10 $dB$ noise floor) by 300\%. The overlap between adjacent tracks in a single layer is imaged to detect characteristic fault signatures. Full multilayer builds are carried out and the resultant ICI images are used to detect defects in the finished part and improve upon the initial design of the build system. Damage to the recoater blade is assessed using powder layer scans acquired during a 3D build. The ability of ICI to monitor SLM processes at such high rates with high resolution offers extraordinary potential for future advances in on-line feedback control of additive manufacturing.