Environmental selection and resource allocation determine spatial patterns in picophytoplankton cell size

Here we describe a new trait-based model for cellular resource allocation that we use to investigate the relative importance of different drivers for small cell size in phytoplankton. Using the model, we show that increased investment in nonscalable structural components with decreasing cell size leads to a trade-off between cell size, nutrient and light affinity, and growth rate. Within the most extreme nutrient-limited, stratified environments, resource competition theory then predicts a trend toward larger minimum cell size with increasing depth. We demonstrate that this explains observed trends using a marine ecosystem model that represents selection and adaptation of a diverse community defined by traits for cell size and subcellular resource allocation. This framework for linking cellular physiology to environmental selection can be used to investigate the adaptive response of the marine microbial community to environmental conditions and the adaptive value of variations in cellular physiology.

How should sparse marine in situ measurements be compared to a continuous model: an example

This work demonstrates an example of the importance of an adequate method to sub-sample model results when comparing with in situ measurements. A test of model skill was performed by employing a point-to-point method to compare a multi-decadal hindcast against a sparse, unevenly distributed historic in situ dataset. The point-to-point method masked out all hindcast cells that did not have a corresponding in situ measurement in order to match each in situ measurement against its most similar cell from the model. The application of the point-to-point method showed that the model was successful at reproducing the inter-annual variability of the in situ datasets. Furthermore, this success was not immediately apparent when the measurements were aggregated to regional averages. Time series, data density and target diagrams were employed to illustrate the impact of switching from the regional average method to the point-to-point method. The comparison based on regional averages gave significantly different and sometimes contradicting results that could lead to erroneous conclusions on the model performance. Furthermore, the point-to-point technique is a more correct method to exploit sparse uneven in situ data while compensating for the variability of its sampling. We therefore recommend that researchers take into account for the limitations of the in situ datasets and process the model to resemble the data as much as possible.

A multicomponent model of phytoplankton size structure

Size-fractionated filtration (SFF) is a direct method for estimating pigment concentration in various size classes. It is also common practice to infer the size structure of phytoplankton communities from diagnostic pigments estimated by high-performance liquid chromatography (HPLC). In this paper, the three-component model of Brewin et al. (2010) was fitted to coincident data from HPLC and from SFF collected along Atlantic Meridional Transect cruises. The model accounted for the variability in each data set, but the fitted model parameters differed for the two data sets. Both HPLC and SFF data supported the conceptual framework of the three-component model, which assumes that the chlorophyll concentration in small cells increases to an asymptotic maximum, beyond which further increase in chlorophyll is achieved by the addition of larger celled phytoplankton. The three-component model was extended to a multicomponent model of size structure using observed relationships between model parameters and assuming that the asymptotic concentration that can be reached by cells increased linearly with increase in the upper bound on the cell size. The multicomponent model was verified using independent SFF data for a variety of size fractions and found to perform well (0.628 ≤ r ≤ 0.989) lending support for the underlying assumptions. An advantage of the multicomponent model over the three-component model is that, for the same number of parameters, it can be applied to any size range in a continuous fashion. The multicomponent model provides a useful tool for studying the distribution of phytoplankton size structure at large scales.

Trait-based representation of diatom functional diversity in a plankton functional type model of the eutrophied southern North Sea

We introduce a trait-based description of diatom functional diversity to an existing plankton functional type (PFT) model, implemented for the eutrophied coastal ecosystem in the Southern Bight of the North Sea. The trait-based description represents a continuum of diatom species, each characterized by a distinct cell volume, and includes size dependence of four diatom traits: the maximum growth rate, the half-saturation constants for nutrient uptake, the photosynthetic efficiency, and the relative affinity of copepods for diatoms. Through competition under seasonally varying forcing, the fitness of each diatom varies throughout time, and the outcome of competition results in a changing community structure. The predicted seasonal change in mean cell volume of the community is supported by field observations: smaller diatoms, which are more competitive in terms of resource acquisition, prevail during the first spring bloom, whereas the summer bloom is dominated by larger species which better resist grazing. The size-based model is used to determine the ecological niche of diatoms in the area and identifies a range of viable sizes that matches observations. The general trade-off between small, competitive diatoms and large, grazing-resistant species is a convenient framework to study patterns in diatom functional diversity. PFT models and trait-based approaches constitute promising complementary tools to study community structure in marine ecosystems.