The Influence Of Temperature And Salinity On Energy Partitioning In The Marine Nematode Diplolaimelloides-Bruciei

Measurements of population growth, generation time, fecundity and respiration in laboratory culture have been made, in relation to temperature and salinity, for the nematode Diplolaimelloides bruciei Hopper, a species normally associated with decayed material of the marsh grass Spartina. The intrinsic rate of increase (r) is high: it is related to temperature between 5° and 25°C by a sigmoid function which is steepest between 10° and 15°C, and is maximum at 26‰ salinity. Generation time is related to temperature by a power function and is shortest at 26‰ salinity. The effect of temperature on generation time is consistent with other data for marine nematodes, and the steep slope of r against temperature is largely due to the marked effect of temperature on fecundity. A sex ratio of 2:1 in favour of males is maintained regardless of culture conditions or population density. Respiration increases exponentially with temperature between 5° and 25°C, with a very high Q10 (3.94), but is not affected by salinity. At 30°C respiration is no higher than at 25°C. A high and relatively stable production efficiency (P/A) is maintained between 10 and 30°C with a maximum of 87% at 15°C; there is a stable reproductive effort (Pr/A) of about 10%. At 5°C both these ratios are zero. Data for the harpacticoid copepod Tachidius discipes, derived from the literature, show that this too has a high and stable production efficiency, which may be a characteristic of meiofaunal species in general, but in this species efficiency is relatively high at 5°C. Many features of the energy balance in D. bruciei can be related to an opportunistic mode of life.

Low colloidal associations of aluminium and titanium in surface waters of the tropical Atlantic

The distribution of dissolved, soluble and colloidal fractions of Al and Ti was assessed by ultrafiltration studies in the upper water column of the eastern tropical North Atlantic. The dissolved fractions of both metals were found to be dominated by the soluble phase smaller than 10 kDa. The colloidal associations were very low (0.2–3.4%) for Al and not detectable for Ti. These findings are in some contrast to previous estimations for Ti and to the predominant occurrence of both metals as hydrolyzed species in seawater. However, low tendencies to form inorganic colloids can be expected, as in seawater dissolved Al and dissolved Ti are present within their inorganic solubility levels. In addition, association with functional organic groups in the colloidal phase is unlikely for both metals. Vertical distributions of the dissolved fractions showed surface maxima with up to 43 nM of Al and 157 pM of Ti, reflecting their predominant supply from atmospheric sources to the open ocean. In the surface waters, excess dissolved Al over dissolved Ti was present compared to the crustal source, indicating higher solubility and thus elevated inputs of dissolved Al from atmospheric mineral particles. At most stations, subsurface minima of Al and Ti were observed and can be ascribed to scavenging processes and/or biological uptake. The dissolved Al concentrations decreased by 80–90% from the surface maximum to the subsurface minimum. Estimated residence times in the upper 100 m of the water column ranged between 1.6 and 4 years for dissolved Al and between 14 and 17 years for dissolved Ti. The short residence times are in some contrast to the low colloidal associations of Al and Ti and the assumed role of colloids as intermediates in scavenging processes. This suggests that either the removal of both metals occurs predominantly via direct transfer of the hydrolyzed species into the particulate fraction or that the colloidal phase is rapidly turned over in the upper water column.

Frequent locations of oceanic fronts as an indicator of pelagic diversity: application to marine protected areas and renewables

Frequent locations of thermal fronts in UK shelf seas were identified using an archive of 30,000 satellite images acquired between 1999 and 2008, and applied as a proxy for pelagic diversity in the designation of Marine Protected Areas (MPAs). Networks of MPAs are required for conservation of critical marine habitats within Europe, and there are similar initiatives worldwide. Many pelagic biodiversity hotspots are related to fronts, for example cetaceans and basking sharks around the Isle of Man, Hebrides and Cornwall, and hence remote sensing can address this policy need in regions with insufficient species distribution data. This is the first study of UK Continental Shelf front locations to use a 10-year archive of full-resolution (1.1 km) AVHRR data, revealing new aspects of their spatial and seasonal variability. Frontal locations determined at sea or predicted by ocean models agreed closely with the new frequent front maps, which also identified many additional frontal zones. These front maps were among the most widely used datasets in the recommendation of UK MPAs, and would be applicable to other geographic regions and to other policy drivers such as facilitating the deployment of offshore renewable energy devices with minimal environmental impact.