Influence of megasonic agitation on the electrodeposition of high aspect ratio blind vias

This paper presents preliminary studies in electroplating using megasonic agitation to avoid the formation of voids within high aspect ratio microvias that are used for the redistribution of interconnects in high density interconnection technology in printed circuit boards. Through this technique, uniform deposition of metal on the side walls of the vias is possible. High frequency acoustic streaming at megasonic frequencies enables the decrease of the Nernst diffusion layer down to the sub-micron range, allowing thereby conformal electrodeposition in deep grooves. This effect enables the normally convection free liquid near the surface to be agitated. Higher throughput and better control of the material properties of the deposits can be achieved for the manufacturing of embedded interconnections and metal-based MEMS. For optimal filling performance of the microvias, a full design of experiments (DOE) and a multi-physics numerical simulation have been conducted to analyse the influence of megasonic agitation on the plating quality of the microvias. Megasonic based deposition has been found to increase the deposition rate as well as improving the quality of the metal deposits.

Multilevel mesh partitioning for optimising aspect ratio

Multilevel algorithms are a successful class of optimisation techniques which address the mesh partitioning problem. They usually combine a graph contraction algorithm together with a local optimisation method which refines the partition at each graph level. To date these algorithms have been used almost exclusively to minimise the cut-edge weight, however it has been shown that for certain classes of solution algorithm, the convergence of the solver is strongly influenced by the subdomain aspect ratio. In this paper therefore, we modify the multilevel algorithms in order to optimise a cost function based on aspect ratio. Several variants of the algorithms are tested and shown to provide excellent results.

An analysis of the passenger to cabin crew ratio and exit reliability based on past survivable aviation accidents

A hotly debated issue in the area of aviation safety is the number of cabin crew members required to evacuate an aircraft in the event of an emergency. Most countries regulate the minimum number required for the safe operation of an aircraft, but these rulings are based on little if any scientific evidence. Another issue of concern is the failure rate of exits and slides. This paper examines these issues using the latest version of Aircraft Accident Statistics and Knowledge database AASK V4.0, which contains information from 105 survivable crashes and more than 2,000 survivors, including accounts from 155 cabin crew members.

Predicting toxic gas concentrations resulting from enclosure fires using local equivalence ratio concept linked to fire field models

A practical CFD method is presented in this study to predict the generation of toxic gases in enclosure fires. The model makes use of local combustion conditions to determine the yield of carbon monoxide, carbon dioxide, hydrocarbon, soot and oxygen. The local conditions used in the determination of these species are the local equivalence ratio (LER) and the local temperature. The heat released from combustion is calculated using the volumetric heat source model or the eddy dissipation model (EDM). The model is then used to simulate a range of reduced-scale and full-scale fire experiments. The model predictions for most of the predicted species are then shown to be in good agreement with the test results

Two simple constant ratio approximation algorithms for minimizing the total weighted completion time on a single machine with a fixed non-availability interval

In this note, we consider the scheduling problem of minimizing the sum of the weighted completion times on a single machine with one non-availability interval on the machine under the non-resumable scenario. Together with a recent 2-approximation algorithm designed by Kacem [I. Kacem, Approximation algorithm for the weighted flow-time minimization on a single machine with a fixed non-availability interval, Computers & Industrial Engineering 54 (2008) 401–410], this paper is the first successful attempt to develop a constant ratio approximation algorithm for this problem. We present two approaches to designing such an algorithm. Our best algorithm guarantees a worst-case performance ratio of 2+ε. © 2008 Elsevier B.V. All rights reserved.

Paying the price for loss of light

Considers the Court of Appeal ruling in Forsyth-Grant v Allen on the principles to be applied in assessing damages for the loss of light. Outlines the method for calculating damages for loss of right to light, the type of amenity which will be included in calculations for loss of amenity and the process applied in this case for assessing damages arising from the loss of profits that would have been made by the owner of the right to light if they had negotiated to relax the covenant, with reference to case law. Notes the limits to damages available for hypothetical loss and the difference between this award of profits and an account of profits.

Megasonic agitation for enhanced electrodeposition of copper

In this paper we propose an agitation method based on megasonic acoustic streaming to overcome the limitations in plating rate and uniformity of the metal deposits during the electroplating process. Megasonic agitation at a frequency of 1 MHz allows the reduction of the thickness of the Nernst diffusion layer to less than 600 nm. Two applications that demonstrate the benefits of megasonic acoustic streaming are presented: the formation of uniform ultra-fine pitch flip-chip bumps and the metallisation of high aspect ratio microvias. For the latter application, a multi-physics based numerical simulation is implemented to describe the hydrodynamics introduced by the acoustic waves as they travel inside the deep microvias.

A price worth paying?: Women and work – choice, constraint or satisficing

Purpose – Are women held back or holding back? Do women choose their jobs/careers or are they structurally or normatively constrained? The purpose of this paper is to shed fresh light on these questions and contribute to an on-going debate that has essentially focused on the extent to which part-time work is women’s choice, the role of structural and organisational constraints and the role of men in excluding women. Design/methodology/approach – The paper uses data from interviews with 80 working women – both full-time and part-time – performing diverse work roles in a range of organisations in the south east of England. Findings – It was found that many women do not make strategic job choices, rather they often ‘‘fall into’’ jobs that happen to be available to them. Some would not have aspired to their present jobs without male encouragement; many report incidents of male exclusion; and virtually all either know or suspect that they are paid less than comparable men. Those working reduced hours enjoy that facility, yet they are aware that reduced hours and senior roles are seen as incompatible. In short, they recognise both the positive and negative aspects of their jobs, whether they work full or part-time, whether they work in male-dominated or female-dominated occupations, and whatever their position in the organisational hierarchy. Accordingly, the paper argues that the concept of ‘‘satisficing’’, i.e. a decision which is good enough but not optimal, is a more appropriate way to view women’s working lives than are either choice or constraint theories. Originality/value – There is an ongoing, and often polarised, debate between those who maintain that women choose whether to give preference to work or home/family and others who maintain that women, far from being self-determining actors, are constrained structurally and normatively. Rather than supporting these choice or constraint theories, this paper argues that ‘‘satisficing’’ is a more appropriate and nuanced concept to explain women’s working lives.

Memorandum submitted by the University of Greenwich: are the consumer price increases for electricity imposed in January 2008 justified?

This paper examines whether increases to published wholesale prices justify the retail electricity price increases imposed on residential consumers in January 2008. The study is based on analysis of two questions: Is the reported wholesale price a reliable indicator of the cost electricity retailers are paying to buy power; and is the corporate structure of the British electricity sector competitive? [Taken from first paragraph of summary]