Tree species-area and species-diameter relationships at three lowland rain forest sites in Sumatra

Data from three forest sites in Sumatra (Batang Ule, Pasirmayang and Tebopandak) have been analysed and compared for the effects of sample area cut-off, and tree diameter cut-off. An 'extended inverted exponential model' is shown to be well suited to fitting tree-species-area curves. The model yields species carrying capacities of 680 for Batang Ule, 380 species for Pasirmayang, and 35 for Tebopandak (tree diameter >10cm). It would seem that in terms of species carrying capacity, Tebopandak and Pasirmayang are rather similar, and both less diverse than the hilly Batang Ule site. In terms of conservation policy, this would mean that rather more emphasis should be put on conserving hilly sites on a granite substratum. For Pasirmayang with tree diameter >3cm, the asymptotic species number estimate is 567, considerably higher than the estimate of 387 species for trees with diameter >10cm. It is clear that the diameter cut-off has a major impact on the estimate of the species carrying capacity. A conservative estimate of the total number of tree species in the Pasirmayang region is 632 species! In sampling exercises, the diameter cut-off should not be chosen lightly, and it may be worth adopting field sampling procedures which involve some subsampling of the primary sample area, where the diameter cut-off is set much lower than in the primary plots.

Microwave cure of conductive adhesives for flip-chip & microsystems applications

The curing of conductive adhesives and underfills can save considerable time and offer cost benefits for the microsystems and electronics packaging industry. In contrast to conventional ovens, curing by microwave energy generates heat internally within each individual component of an assembly. The rate at which heat is generated is different for each of the components and depends on the material properties as well as the oven power and frequency. This leads to a very complex and transient thermal state, which is extremely difficult to measure experimentally. Conductive adhesives need to be raised to a minimum temperature to initiate the cross-linking of the resin polymers, whilst some advanced packaging materials currently under investigation impose a maximum temperature constraint to avoid damage. Thermal imagery equipment integrated with the microwave oven can offer some information on the thermal state but such data is based on the surface temperatures. This paper describes computational models that can simulate the internal temperatures within each component of an assembly including the critical region between the chip and substrate. The results obtained demonstrate that due to the small mass of adhesive used in the joints, the temperatures reached are highly dependent on the material properties of the adjacent chip and substrate.

Hypertension - a contemporary approach to nursing care

The incidence of hypertension is increasing as the number of patients with obesity and diabetes mellitus increases. Hypertension results when the peripheral vascular resistance is increased, the blood viscosity is elevated and/or the flow of blood through the main arteries is impeded. Chronic hypertension results in enlarged heart, myocardial damage and lung and renal abnormalities. While some causative factors such as obesity can be controlled, others for example genetics are more difficult to treat because often there is more than one factor involved. This paper explores how essential and secondary factors contribute to the incidence of hypertension and the physiological changes resulting from raised blood pressure. It proposes that although traditional treatment has some success, nurse-led clinics are having better success not only in controlling raised blood pressure but also in reducing cardiac, pulmonary and renal morbidity. It is more cost-effective, staff is more productive and clients are more compliant with treatment.