Multi-physics modelling for design optimization and manufacturing on high-performance parallel systems

Abstract not available

Mesh partitioning and load balancing for distributed memory parallel systems

A method is outlined for optimising graph partitions which arise in mapping unstructured mesh calculations to parallel computers. The method employs a relative gain iterative technique to both evenly balance the workload and minimise the number and volume of interprocessor communications. A parallel graph reduction technique is also briefly described and can be used to give a global perspective to the optimisation. The algorithms work efficiently in parallel as well as sequentially and when combined with a fast direct partitioning technique (such as the Greedy algorithm) to give an initial partition, the resulting two-stage process proves itself to be both a powerful and flexible solution to the static graph-partitioning problem. Experiments indicate that the resulting parallel code can provide high quality partitions, independent of the initial partition, within a few seconds. The algorithms can also be used for dynamic load-balancing, reusing existing partitions and in this case the procedures are much faster than static techniques, provide partitions of similar or higher quality and, in comparison, involve the migration of a fraction of the data.

Scalable unstructured mesh decomposition

As the efficiency of parallel software increases it is becoming common to measure near linear speedup for many applications. For a problem size N on P processors then with software running at O(N=P ) the performance restrictions due to file i/o systems and mesh decomposition running at O(N) become increasingly apparent especially for large P . For distributed memory parallel systems an additional limit to scalability results from the finite memory size available for i/o scatter/gather operations. Simple strategies developed to address the scalability of scatter/gather operations for unstructured mesh based applications have been extended to provide scalable mesh decomposition through the development of a parallel graph partitioning code, JOSTLE [8]. The focus of this work is directed towards the development of generic strategies that can be incorporated into the Computer Aided Parallelisation Tools (CAPTools) project.

A parallel method for solving pentadiagonal systems of linear equations

A new parallel approach for solving a pentadiagonal linear system is presented. The parallel partition method for this system and the TW parallel partition method on a chain of P processors are introduced and discussed. The result of this algorithm is a reduced pentadiagonal linear system of order P \Gamma 2 compared with a system of order 2P \Gamma 2 for the parallel partition method. More importantly the new method involves only half the number of communications startups than the parallel partition method (and other standard parallel methods) and hence is a far more efficient parallel algorithm.

Automatic generation of portable multi-dimensionally decomposed parallel structured mesh software

Abstract not available

Modelling continuum mechanics phenomena using three dimensional unstructured meshes on massively parallel processors

The difficulties encountered in implementing large scale CM codes on multiprocessor systems are now fairly well understood. Despite the claims of shared memory architecture manufacturers to provide effective parallelizing compilers, these have not proved to be adequate for large or complex programs. Significant programmer effort is usually required to achieve reasonable parallel efficiencies on significant numbers of processors. The paradigm of Single Program Multi Data (SPMD) domain decomposition with message passing, where each processor runs the same code on a subdomain of the problem, communicating through exchange of messages, has for some time been demonstrated to provide the required level of efficiency, scalability, and portability across both shared and distributed memory systems, without the need to re-author the code into a new language or even to support differing message passing implementations. Extension of the methods into three dimensions has been enabled through the engineering of PHYSICA, a framework for supporting 3D, unstructured mesh and continuum mechanics modeling. In PHYSICA, six inspectors are used. Part of the challenge for automation of parallelization is being able to prove the equivalence of inspectors so that they can be merged into as few as possible.