Estimating the flow rate capacity of an overturned rail carriage end exit in the presence of smoke

While incidents requiring the rapid egress of passengers from trains are infrequent, perhaps the most challenging scenario for passengers involves the evacuation from an overturned carriage subjected to fire. In this paper we attempt to estimate the flow rate capacity of an overturned rail carriage end exit. This was achieved through two full-scale evacuation experiments, in one of which the participants were subjected to non-toxic smoke. The experiments were conducted as part of a pilot study into evacuation from rail carriages. In reviewing the experimental results, it should be noted that only a single run of each trial was undertaken with a limited — though varied — population. As a result it is not possible to test the statistical significance of the evacuation times quoted and so the results should be treated as indicative rather than definitive. The carriage used in the experiments was a standard class Mark IID which, while an old carriage design, shares many features with those carriages commonly found on the British rail network. In the evacuation involving smoke, the carriage end exit was found to achieve an average flow rate capacity of approximately 5.0 persons/min. The average flow rate capacity of the exit without smoke was found to be approximately 9.2 persons/min. It was noted that the presence of smoke tended to reduce significantly the exit flow rate. Due to the nature of the experimental conditions, these flow rates are considered optimistic. Finally, the authors make several recommendations for improving survivability in rail accidents. Copyright © 2000 John Wiley & Sons, Ltd.

Multilevel refinement strategies for the capacity vehicle routing problem

We discuss the application of the multilevel (ML) refinement technique to the Vehicle Routing Problem (VRP), and compare it to its single-level (SL) counterpart. Multilevel refinement recursively coarsens to create a hierarchy of approximations to the problem and refines at each level. A SL algorithm, which uses a combination of standard VRP heuristics, is developed first to solve instances of the VRP. A ML version, which extends the global view of these heuristics, is then created, using variants of the construction and improvement heuristics at each level. Finally some multilevel enhancements are developed. Experimentation is used to find suitable parameter settings and the final version is tested on two well-known VRP benchmark suites. Results comparing both SL and ML algorithms are presented.

Influence of carbonation on the acid neutralization capacity of cements and cement-solidified/stabilized electroplating sludge

Portland cement (PC) and blended cements containing pulverized fuel ash (PFA) or granulated blast-furnace slag (GGBS) were used to solidify/stabilize an electroplating sludge in this work. The acid neutralization capacity (ANC) of the hydrated pastes increased in the order of PC > PC/GGBS > PC/PFA. The GGBS or PFA replacement (80 wt%) reduced the ANC of the hydrated pastes by 30–50%. The ANC of the blended cement-solidified electroplating sludge (cement/sludge 1:2) was 20–30% higher than that of the hydrated blended cement pastes. Upon carbonation, there was little difference in the ANC of the three cement pastes, but the presence of electroplating sludge (cement/sludge 1:2) increased the ANC by 20%. Blended cements were more effective binders for immobilization of Ni, Cr and Cu, compared with PC, whereas Zn was encapsulated more effectively in the latter. Accelerated carbonation improved the immobilization of Cr, Cu and Zn, but not Ni. The geochemical code PHREEQC, with the edited database from EQ3/6 and HATCHES, was used to calculate the saturation index and solubility of likely heavy metal precipitates in cement-based solidification/stabilization systems. The release of heavy metals could be related to the disruption of cement matrices and the remarkable variation of solubility of heavy metal precipitates at different pH values.

Public-public partnerships (PUPs) in water

Water operators need to be efficient, accountable, honest public institutions providing a universal service. Many water services however lack the institutional strength, the human resources, the technical expertise and equipment, or the financial or managerial capacity to provide these services. They need support to develop these capacities. The vast majority of water operators in the world are in the public sector – 90% of all major cities are served by such bodies. This means that the largest pool of experience and expertise, and the great majority of examples of good practice and sound institutions, are to be found in existing public sector water operators. Because they are public sector, however, they do not have any natural commercial incentive to provide international support. Their incentive stems from solidarity, not profit. Since 1990, however, the policies of donors and development banks have focussed on the private companies and their incentives. The vast resources of the public sector have been overlooked, even blocked by pro-private policies. Out of sight of these global policy-makers, however, a growing number of public sector water companies have been engaged, in a great variety of ways, in helping others develop the capacity to be effective and accountable public services. These supportive arrangements are now called 'public-public partnerships' (PUPs). A public-public partnership (PUP) is simply a collaboration between two or more public authorities or organisations, based on solidarity, to improve the capacity and effectiveness of one partner in providing public water or sanitation services. They have been described as: “a peer relationship forged around common values and objectives, which exclude profit-seeking”.1 Neither partner expects a commercial profit, directly or indirectly. This makes PUPs very different from the public–private partnerships (PPPs) which have been promoted by the international financial institutions (IFIs) like the World Bank. The problems of PPPs have been examined in a number of reports. A great advantage of PUPs is that they avoid the risks of such partnerships: transaction costs, contract failure, renegotiation, the complexities of regulation, commercial opportunism, monopoly pricing, commercial secrecy, currency risk, and lack of public legitimacy.2 PUPs are not merely an abstract concept. The list in the annexe to this paper includes over 130 PUPs in around 70 countries. This means that far more countries have hosted PUPs than host PPPs in water – according to a report from PPIAF in December 2008, there are only 44 countries with private participation in water. These PUPs cover a period of over 20 years, and been used in all regions of the world. The earliest date to the 1980s, when the Yokohama Waterworks Bureau first started partnerships to help train staff in other Asian countries. Many of the PUP projects have been initiated in the last few years, a result of the growing recognition of PUPs as a tool for achieving improvements in public water management. This paper attempts to provide an overview of the typical objectives of PUPs; the different forms of PUPs and partners involved; a series of case studies of actual PUPs; and an examination of the recent WOPs initiative. It then offers recommendations for future development of PUPs.

Industrial water pollution in Dhaka, Bangladesh: strategies and incentives for pollution control in small and medium enterprises

The extent and gravity of the environmental degradation of the water resources in Dhaka due to untreated industrial waste is not fully recognised in international discourse. Pollution levels affect vast numbers, but the poor and the vulnerable are the worst affected. For example, rice productivity, the mainstay of poor farmers, in the Dhaka watershed has declined by 40% over a period of ten years. The study found significant correlations between water pollution and diseases such as jaundice, diarrhoea and skin problems. It was reported that the cost of treatment of one episode of skin disease could be as high as 29% of the weekly earnings of some of the poorest households. The dominant approach to deal with pollution in the SMEs is technocratic. Given the magnitude of the problem this paper argues that to control industrial pollution by SMEs and to enhance their compliance it is necessary to move from the technocratic approach to one which can also address the wider institutional and attitudinal issues. Underlying this shift is the need to adopt the appropriate methodology. The multi-stakeholder analysis enables an understanding of the actors, their influence, their capacity to participate in, or oppose change, and the existing and embedded incentive structures which allow them to pursue interests which are generally detrimental to environmental good. This enabled core and supporting strategies to be developed around three types of actors in industrial pollution, i.e., (i) principal actors, who directly contribute to industrial pollution; (ii) stakeholders who exacerbate the situation; and (iii) potential actors in mitigation. Within a carrot-and-stick framework, the strategies aim to improve environmental governance and transparency, set up a packet to incentive for industry and increase public awareness.

Characterization of carbonated tricalcium silicate and its sorption capacity for heavy metals: A micron-scale composite adsorbent of active silicate gel and calcite

Adsorption-based processes are widely used in the treatment of dilute metal-bearing wastewaters. The development of versatile, low-cost adsorbents is the subject of continuing interest. This paper examines the preparation, characterization and performance of a micro-scale composite adsorbent composed of silica gel (15.9 w/w%), calcium silicate hydrate gel (8.2 w/w%) and calcite (75.9 w/w%), produced by the accelerated carbonation of tricalcium silicate (C(3)S, Ca(3)SiO(5)). The Ca/Si ratio of calcium silicate hydrate gel (C-S-H) was determined at 0.12 (DTA/TG), 0.17 ((29)Si solid-state MAS/NMR) and 0.18 (SEM/EDS). The metals-retention capacity for selected Cu(II), Pb(II), Zn(II) and Cr(III) was determined by batch and column sorption experiments utilizing nitrate solutions. The effects of metal ion concentration, pH and contact time on binding ability was investigated by kinetic and equilibrium adsorption isotherm studies. The adsorption capacity for Pb(II), Cr(III), Zn(II) and Cu(II) was found to be 94.4 mg/g, 83.0 mg/g, 52.1 mg/g and 31.4 mg/g, respectively. It is concluded that the composite adsorbent has considerable potential for the treatment of industrial wastewater containing heavy metals.

Sustainability and local tourism branding in England's South Downs

This paper reports on a stakeholder consultation exercise that examined the tourism industry's perception of developing a local tourism branding scheme within the South Downs' protected areas in south-east England. The research shows that such schemes could offer potential benefits that are recognisable by the tourism industry, while helping to meet the statutory aims of the protected area. The paper records the perceptions of small tourism businesses, their fears, awareness of tourism impacts, perceptions of sustainable tourism and of local branding, and key criteria connected to the future organisation of a local tourism branding scheme. The conclusion lists the recommendations for the implementation of a local branding scheme, including grassroots stakeholder consultation that encourages ownership and participation, institutional frameworks that support capacity-building and the importance of developing core values within a local brand.

Radio propagation modeling for capacity optimization in wireless relay MIMO systems with partial CSI

The enormous growth of wireless communication systems makes it important to evaluate the capacity of such channels. Multiple Input Multiple Output (MIMO) wireless communication systems are shown to yield significant performance improvement to data rates when compared to the traditional Single Input Single Output (SISO) wireless systems. The benefits of multiple antenna elements at the transmitter and receiver have become necessary to the research and the development of the next generation of mobile communication systems. In this paper we propose the use of Relaying MIMO wireless communication systems for use over long throughput. We investigate how Relays can be used in a "demodulate-and-forward" operation when the transmitter is equipped with spatially correlated multiple antenna elements and the receiver has only partial knowledge of the statistics of the channel. We show that Relays between the source and destination nodes of a wireless communication system in MIMO configuration improve the throughput of the system when compared to the typical MIMO systems, or achieve the desired channel capacity with significantly lower power resources needed.

Strategies for water pollution control in Dhaka, Bangladesh: an institutional and economic analysis

This paper presents primary data based on research carried out as part of a large World Bank project. Results from our survey show that water pollution in Dhaka watershed has reached alarming levels and is posing significant threats to health and economic activity, particularly among the poor and vulnerable. Rice productivity in the watershed area, for example, has declined by 40% in recent years and vegetable cultivation in the riverbeds has been severely damaged. We also found significant correlation between water pollution and diseases such as jaundice, diarrhoea and skin problems. It was reported that the cost of treatment of skin diseases for one episode could be as high as 29% of the weekly earnings of poor households. Given the magnitude of the contamination problem, a multi-agent stakeholder approach was necessary to analyse the institutional and economic constraints that would need to be addressed in order to improve environmental management. This approach, in turn, enabled core strategies to be developed. The strategies were better understood around three types of actors in industrial pollution, i.e. (1) principal actors, who contribute directly to industrial pollution; (2) stakeholders, who exacerbate the situation by inaction; and (3) the potential actors in mitigation of water contamination. Within a carrot-and-stick framework, nine strategies leading to the strengthening of environmental management were explored. They aim at improving governance and transparency within public agencies and private industry through the setting up of incentive structures to advance compliance and enforcement of environmental standards. Civil society and the population at large are, on the other hand, encouraged to contribute actively to the mitigation of water pollution by improving the management of environmental information and by raising public awareness.