Understanding the Reaction Mechanism of Nanocomposite Thermites

Nanocomposite energetics are a relatively new class of materials that combine nanoscale fuels and oxidizers to allow for the rapid release of large amounts of energy. In thermite systems (metal fuel with metal oxide oxidizer), the use of nanomaterials has been illustrated to increase reactivity by multiple orders of magnitude as a result of the higher specific surface area and smaller diffusion length scales. However, the highly dynamic and nanoscale processes intrinsic to these materials, as well as heating rate dependencies, have limited our understanding of the underlying processes that control reaction and propagation. For my dissertation, I have employed a variety of experimental approaches that have allowed me to probe these processes at heating rates representative of free combustion with the goal of understanding the fundamental mechanisms. Dynamic transmission electron microscopy (DTEM) was used to study the in situ morphological change that occurs in nanocomposite thermite materials subjected to rapid (10^11 K/s) heating. Aluminum nanoparticle (Al-NP) aggregates were found to lose their nanostructure through coalescence in as little as 10 ns, which is much faster than any other timescale of combustion. Further study of nanoscale reaction with CuO determined that a condensed phase interfacial reaction could occur within 0.5-5 µs in a manner consistent with bulk reaction, which supports that this mechanism plays a dominant role in the overall reaction process. Ta nanocomposites were also studied to determine if a high melting point (3280 K) affects the loss of nanostructure and rate of reaction. The condensed phase reaction pathway was further explored using reactive multilayers sputter deposited onto thin Pt wires to allow for temperature jump (T-Jump) heating at rates of ~5x10^5 K/s. High speed video and a time of flight mass spectrometry (TOFMS) were used to observe ignition temperature and speciation as a function of bilayer thickness. The ignition process was modeled and a low activation energy for effective diffusivity was determined. T-Jump TOFMS along with constant volume combustion cell studies were also used to determine the effect of gas release in nanoparticle systems by comparing the reaction properties of CuO and Cu2O.

Combustion Instability and Active Control: Alternative Fuels, Augmentors, and Modeling Heat Release

Experimental and analytical studies were conducted to explore thermo-acoustic coupling during the onset of combustion instability in various air-breathing combustor configurations. These include a laboratory-scale 200-kW dump combustor and a 100-kW augmentor featuring a v-gutter flame holder. They were used to simulate main combustion chambers and afterburners in aero engines, respectively. The three primary themes of this work includes: 1) modeling heat release fluctuations for stability analysis, 2) conducting active combustion control with alternative fuels, and 3) demonstrating practical active control for augmentor instability suppression. The phenomenon of combustion instabilities remains an unsolved problem in propulsion engines, mainly because of the difficulty in predicting the fluctuating component of heat release without extensive testing. A hybrid model was developed to describe both the temporal and spatial variations in dynamic heat release, using a separation of variables approach that requires only a limited amount of experimental data. The use of sinusoidal basis functions further reduced the amount of data required. When the mean heat release behavior is known, the only experimental data needed for detailed stability analysis is one instantaneous picture of heat release at the peak pressure phase. This model was successfully tested in the dump combustor experiments, reproducing the correct sign of the overall Rayleigh index as well as the remarkably accurate spatial distribution pattern of fluctuating heat release. Active combustion control was explored for fuel-flexible combustor operation using twelve different jet fuels including bio-synthetic and Fischer-Tropsch types. Analysis done using an actuated spray combustion model revealed that the combustion response times of these fuels were similar. Combined with experimental spray characterizations, this suggested that controller performance should remain effective with various alternative fuels. Active control experiments validated this analysis while demonstrating 50-70\% reduction in the peak spectral amplitude. A new model augmentor was built and tested for combustion dynamics using schlieren and chemiluminescence techniques. Novel active control techniques including pulsed air injection were implemented and the results were compared with the pulsed fuel injection approach. The pulsed injection of secondary air worked just as effectively for suppressing the augmentor instability, setting up the possibility of more efficient actuation strategy.

LUNG CANCER IN NEPAL: THE ROLE OF TRADITIONAL TOBACCO PRODUCTS AND COMBUSTION RELATED HOUSEHOLD AIR POLLUTION

The burden of chronic diseases such as cancer is increasing in low and middle income countries around the globe. Nepal, one of the world’s poorest countries, is no exception to this trend, with lung cancer as the leading causes of cancer deaths. Despite this, limited data is available on the environmental and behavioral risk factors that contribute to the lung cancer etiology in Nepal. The objectives of this dissertation are to: 1) investigate the ethnic differences in consumption of local tobacco products and their role in lung cancer risk in Nepal; 2) evaluate urinary metabolite of 1,3-butadiene as a biomarker of exposure to combustion related household air pollution (CRHAP); 3) investigate the association between CRHAP exposure and lung cancer risk using urinary metabolite of 1,3-butadiene as a biomarker of exposure; 4) investigate the association between CRHAP exposure and lung cancer risk using questionnaire based measure of exposure. Lung cancer cases (n=606) and frequency matched controls (N=606) were recruited from B.P. Koirala Memorial Cancer Hospital. We obtained biological samples and information on lifestyles including cooking habits and type of fuels used. We used liquid chromatograph tandem mass spectrometer (LC-MS/MS) to quantify urinary metabolites of 1,3-butadiene in urine samples. We employed a combination of logistic and linear regression models to detect any exposure-disease associations while controlling for known confounding variables. Overall, we found that ethnic groups in Nepal use different tobacco products that have different differing cancer potency -we observed the highest odds ratios for the traditional tobacco products. The biomarker analysis showed strong evidence that monohydroxybutyl mercapturic acid is associated with biomass fuel use among participants. However, we did not find significant association between urinary MHMBA and lung cancer risk. When we used questionnaire based measure of exposure to household air pollution, we observed significant, dose-response associations between CRHAP exposure and lung cancer risk, particularly among never-smokers. Our results show that important role of local tobacco products in lung cancer risk in Nepal. Furthermore, we demonstrate that CRHAP exposure is a risk factor for lung cancer risk, independent of tobacco smoking.

SOVLENT REACTIVITY AND INTERFACE EVOLUTION AT MODEL ELECTRODES FOR ENERGY APPLICATIONS

The Li-ion rechargeable battery (LIB) is widely used as an energy storage device, but has significant limitations in battery cycle life and safety. During initial charging, decomposition of the ethylene carbonate (EC)-based electrolytes of the LIB leads to the formation of a passivating layer on the anode known as the solid electrolyte interphase (SEI). The formation of an SEI has great impact on the cycle life and safety of LIB, yet mechanistic aspects of SEI formation are not fully understood. In this dissertation, two surface science model systems have been created under ultra-high vacuum (UHV) to probe the very initial stage of SEI formation at the model carbon anode surfaces of LIB. The first model system, Model System I, is an lithium-carbonate electrolyte/graphite C(0001) system. I have developed a temperature programmed desorption/temperature programmed reaction spectroscopy (TPD/TPRS) instrument as part of my dissertation to study Model System I in quantitative detail. The binding strengths and film growth mechanisms of key electrolyte molecules on model carbon anode surfaces with varying extents of lithiation were measured by TPD. TPRS was further used to track the gases evolved from different reduction products in the early-stage SEI formation. The branching ratio of multiple reaction pathways was quantified for the first time and determined to be 70.% organolithium products vs. 30% inorganic lithium product. The obtained branching ratio provides important information on the distribution of lithium salts that form at the very onset of SEI formation. One of the key reduction products formed from EC in early-stage SEI formation is lithium ethylene dicarbonate (LEDC). Despite intensive studies, the LEDC structure in either the bulk or thin-film (SEI) form is unknown. To enable structural study, pure LEDC was synthesized and subject to synchrotron X-ray diffraction measurements (bulk material) and STM measurements (deposited films). To enable studies of LEDC thin films, Model System II, a lithium ethylene dicarbonate (LEDC)-dimethylformamide (DMF)/Ag(111) system was created by a solution microaerosol deposition technique. Produced films were then imaged by ultra-high vacuum scanning tunneling microscopy (UHV-STM). As a control, the dimethylformamide (DMF)-Ag(111) system was first prepared and its complex 2D phase behavior was mapped out as a function of coverage. The evolution of three distinct monolayer phases of DMF was observed with increasing surface pressure — a 2D gas phase, an ordered DMF phase, and an ordered Ag(DMF)2 complex phase. The addition of LEDC to this mixture, seeded the nucleation of the ordered DMF islands at lower surface pressures (DMF coverages), and was interpreted through nucleation theory. A structural model of the nucleation seed was proposed, and the implication of ionic SEI products, such as LEDC, in early-stage SEI formation was discussed.

Cortisol Reactivity and Observed Parenting among Mothers of Children with and without ADHD

Parenting is a robust predictor of developmental outcomes among children with ADHD. Early parenting predicts the persistence and course of ADHD and comorbid problems above and beyond risk associated with shared genetic effects. Yet, on average, mothers of children with ADHD are less positive and more negative in their parent-child interactions compared to mothers of non-disordered children. Little is known about psychobiological markers which may be associated with individual variations in maternal parenting in families of children with ADHD. Neurobiological models of parenting suggest that maternal cortisol levels following a stressor may be positively associated with hostile and intrusive parenting; however, to date no studies have examined maternal cortisol reactivity and parenting in school-age, or clinical samples of, children. Mothers’ regulation of physiological stress responses may be particularly important for families of children with ADHD, as parenting a child with chronically challenging behaviors represents a persistent environmental stressor. The current study sought to extend the existing literature by providing an empirical examination of the relationship between maternal cortisol reactivity following two laboratory stressors and parenting among mothers of children with and without ADHD. It was hypothesized that child ADHD group would moderate the relationship between cortisol reactivity and self-reported and observed parenting. Greater total cortisol output and greater increase in cortisol during the TSST were associated with decreased positive parenting and increased negative and directive parenting, with the exception of parental involvement, which was associated with increased cortisol output during the TSST. Conversely, cortisol output during the PCI was associated with increased positive parenting, increased parental involvement, and decreased negative parenting. In contrast to the TSST, a greater decrease in cortisol during the PCI indicated more positive parenting and parental involvement. These associations were specific to mothers of children with ADHD, with the exception of maternal directiveness, which was specific to comparison mothers. Findings add to our understanding of physiological processes associated with maternal parenting and contribute to an integrative biological, psychological, and cognitive process model of parenting in families of children with ADHD.