Measurement, Simulation, and Analysis of the Mechanical Response of Railroad Track

Increased railroad traffic volumes, speeds, and axle loads have created a need to better measure track quality. Previous research has indicated that the vertical track deflection provides a meaningful indicator of track integrity. The measured deflection can be related to the bending stresses in the rail as well as characterize the mechanical response of the track. This investigation summarizes the simulation, analysis and development of a measurement system at the University of Nebraska (UNL) to measure vertical track deflection in real-time from a car moving at revenue speeds. The UNL system operates continuously over long distances and in revenue service. Using a camera and two line lasers, the system establishes three points of the rail shape beneath the loaded wheels and over a distance of 10 ft. The resulting rail shape can then be related to the actual bending stress in the rail and estimate the track support through beam theory. Finite element simulations are used to characterize the track response as related to the UNL measurement system. The results of field tests using bondable resistance strain gages illustrate the system’s capability of approximating the actual rail bending stresses under load.

Elimination of All-Optical Cycles in Wavelength-Routed Optical Networks

A transparent (wide-area) wavelength-routed optical network may be constructed by using wavelength cross-connect switches connected together by fiber to form an arbitrary mesh structure. The network is accessed through electronic stations that are attached to some of these cross-connects. These wavelength cross-connect switches have the property that they may configure themselves into unspecified states. Each input port of a switch is always connected to some output port of the switch whether or not such a connection is required for the purpose of information transfer. Due to the presence of these unspecified states, there exists the possibility of setting up unintended alloptical cycles in the network (viz., a loop with no terminating electronics in it). If such a cycle contains amplifiers [e.g., Erbium- Doped Fiber Amplifiers (EDFA’s)], there exists the possibility that the net loop gain is greater than the net loop loss. The amplified spontaneous emission (ASE) noise from amplifiers can build up in such a feedback loop to saturate the amplifiers and result in oscillations of the ASE noise in the loop. Such all-optical cycles as defined above (and hereafter referred to as “white” cycles) must be eliminated from an optical network in order for the network to perform any useful operation. Furthermore, for the realistic case in which the wavelength cross-connects result in signal crosstalk, there is a possibility of having closed cycles with oscillating crosstalk signals. We examine algorithms that set up new transparent optical connections upon request while avoiding the creation of such cycles in the network. These algorithms attempt to find a route for a connection and then (in a post-processing fashion) configure switches such that white cycles that might get created would automatically get eliminated. In addition, our call-set-up algorithms can avoid the possibility of crosstalk cycles.

Optical Components for WDM Lightwave Networks

Recently, there has been growing interest in developing optical fiber networks to support the increasing bandwidth demands of multimedia applications, such as video conferencing and World Wide Web browsing. One technique for accessing the huge bandwidth available in an optical fiber is wavelength-division multiplexing (WDM). Under WDM, the optical fiber bandwidth is divided into a number of nonoverlapping wavelength bands, each of which may be accessed at peak electronic rates by an end user. By utilizing WDM in optical networks, we can achieve link capacities on the order of 50 THz. The success of WDM networks depends heavily on the available optical device technology. This paper is intended as a tutorial on some of the optical device issues in WDM networks. It discusses the basic principles of optical transmission in fiber and reviews the current state of the art in optical device technology. It introduces some of the basic components in WDM networks, discusses various implementations of these components, and provides insights into their capabilities and limitations. Then, this paper demonstrates how various optical components can be incorporated into WDM optical networks for both local and wide-area applications. Last, the paper provides a brief review of experimental WDM networks that have been implemented.

Optical Communication Networks for the Next-Generation Internet

Computer and telecommunication networks are changing the world dramatically and will continue to do so in the foreseeable future. The Internet, primarily based on packet switches, provides very flexible data services such as e-mail and access to the World Wide Web. The Internet is a variable-delay, variable- bandwidth network that provides no guarantee on quality of service (QoS) in its initial phase. New services are being added to the pure data delivery framework of yesterday. Such high demands on capacity could lead to a “bandwidth crunch” at the core wide-area network, resulting in degradation of service quality. Fortunately, technological innovations have emerged which can provide relief to the end user to overcome the Internet’s well-known delay and bandwidth limitations. At the physical layer, a major overhaul of existing networks has been envisaged from electronic media (e.g., twisted pair and cable) to optical fibers - in wide-area, metropolitan-area, and even local-area settings. In order to exploit the immense bandwidth potential of optical fiber, interesting multiplexing techniques have been developed over the years.

Virtual Topology Reconfiguration of Wavelength-routed Optical WDM Networks

The bandwidth requirements of the Internet are increasing every day and there are newer and more bandwidth-thirsty applications emerging on the horizon. Wavelength division multiplexing (WDM) is the next step towards leveraging the capabilities of the optical fiber, especially for wide-area backbone networks. The ability to switch a signal at intermediate nodes in a WDM network based on their wavelengths is known as wavelength-routing. One of the greatest advantages of using wavelength-routing WDM is the ability to create a virtual topology different from the physical topology of the underlying network. This virtual topology can be reconfigured when necessary, to improve performance. We discuss the previous work done on virtual topology design and also discuss and propose different reconfiguration algorithms applicable under different scenarios.

The Impact of Green Supply Chain Practices on Supply Chain Performance

Supply Chain Management (SCM) has become a critical factor to sustain organization’s competitive advantages. In this regard, many firms and researchers have attempted to find out factors that affect either positively or negatively on SCM. Recently, Green Supply Chain Management (GSCM) has been receiving the spotlight in many studies. Social and political concerns about the environment in Korea emerged in the early 1990s when Korean government established new environmental regulations in order to implement environmental management throughout the entire supply chain. The Korean government established national GSCM strategies. However, there has been minimal research on measuring GSCM performance among Korean enterprises. It is critical to conduct the research on the relationship between GSCM practices and supply chain performance among Korean firms. In this research, the relationship among Korean enterprises will be empirically tested. The supply chain performance measurement system includes three dimensions: resource, output, and flexibility.

OPENING REMARKS - THIRD VERTEBRATE PEST CONFERENCE

To open this Third Vertebrate Pest Conference is a real privilege. It is a pleasure to welcome all of you in attendance, and I know there are others who would like to be meeting with us, but, for one reason or another cannot be. However, we can serve them by taking back the results of discussion and by making available the printed transactions of what is said here. It has been the interest and demand for the proceedings of the two previous conferen- ces which, along with personal contacts many of you have with the sponsoring committee, have gauged the need for continuing these meetings. The National Pest Control Association officers who printed the 1962 proceedings still are supplying copies of that conference. Two reprintings of the 1964 conference have been necessary and repeat orders from several universities indicate that those proceedings have become textbooks for special classes. When Dr. Howard mentioned in opening the first Conference in 1962 that publication of those papers would make a valuable handbook of animal control, he was prophetic, indeed. We are pleased that this has happened, but not surprised, since to many of us in this specialized field, the conferences have provided a unique opportunity to meet colleagues with similar interests, to exchange information on control techniques and to be informed by research workers of problem solving investigations as well as to hear of promising basic research. The development of research is a two-way street and we think these conferences also identify areas of inadequate knowledge, thereby stimulating needed research. We have represented here a number of types of specialists—animal ecologists, public health and transmissible disease experts, control methods specialists, public agency administration and enforcement staffs, agricultural extension people, manufacturing and sale industry representatives, commercial pest control operators, and others—and in addition to improving communications among these professional groups an equally important purpose of these conferences is to improve understanding between them and the general public. Within the term general public are many individuals and also organizations dedicated to appreciation and protection of certain animal forms or animal life in general. Proper concepts of vertebrate pest control do not conflict with such views. It is worth repeating for the record the definition of "vertebrate pest" which has been stated at our previous conferences. "A vertebrate pest is any native or introduced, wild or feral, non-human spe- cies of vertebrate animal that is currently troublesome locally or over a wide area to one or more persons either by being a general nuisance, a health hazard or by destroying food or natural resources. In other words, vertebrate pest status is not an inherent quality or fixed classification but is a circumstantial relationship to man's interests." I believe progress has been made in reducing the misunderstanding and emotion with which vertebrate pest control was formerly treated whenever a necessity for control was stated. If this is true, I likewise believe it is deserved, because control methods and programs have progressed. Control no longer refers only to population reductions by lethal means. We have learned something of alternate control approaches and the necessity for studying the total environment; where reduction of pest animal numbers is the required solution to a problem situation we have a wider choice of more selective, safe and efficient materials. Although increased attention has been given to control methods, research when we take a close look at the severity of animal damage to so many facets of our economy, particularly to agricultural production and public health, we realize it still is pitifully small and slow. The tremendous acceleration of the world's food and health requirements seems to demand expediting vertebrate pest control to effectively neutralize the enormous impact of animal damage to vital resources. The efforts we are making here at problem delineation, idea communication and exchange of methodology could well serve as both nucleus and rough model for a broader application elsewhere. I know we all hope this Third Conference will advance these general objectives, and I think there is no doubt of its value in increasing our own scope of information.