A METHODOLOGY TO EVALUATE OBSOLETE INVENTORY IN HEALTH CARE

Many organizations are currently facing inventory management problems such as distributing inventory on-time and maintain the correct inventory levels to satisfy the customer or end users. Organizations understand the need for maintaining the accurate inventory levels but sometimes fall short leading a wide performance gap in maintaining inventory accurately. The inventory inaccuracy can consume much of the investment on purchasing inventory and many times leads to excessive inventory. The research objective of thesis is to provide a decision making criteria to the management for closing or maintaining the warehouse based on basic purchasing and holding cost information. The specific objectives provide information regarding the impact of inventory carrying cost, obsolete inventory, inventory turns. The methodology section explains about the carrying cost ratio that would help inventory managers to adopt best practices to avoid obsolete inventory and also reduce excessive inventory levels. The research model was helpful in providing a decision making criteria based on the performance metric developed. This research model and performance metric had been validated by analysis of warehouse data and results indicated a shift from two-echelon inventory supply chain to a one-echelon or Just In Time (JIT) based inventory supply chain. The recommendations from the case study were used by a health care organization to reorganize the supply chain resulting in the reduction of excessive inventory.

Improving IRT parameter estimates with small sample sizes: Evaluating the efficacy of a new data augmentation technique

The 3PL model is a flexible and widely used tool in assessment. However, it suffers from limitations due to its need for large sample sizes. This study introduces and evaluates the efficacy of a new sample size augmentation technique called Duplicate, Erase, and Replace (DupER) Augmentation through a simulation study. Data are augmented using several variations of DupER Augmentation (based on different imputation methodologies, deletion rates, and duplication rates), analyzed in BILOG-MG 3, and results are compared to those obtained from analyzing the raw data. Additional manipulated variables include test length and sample size. Estimates are compared using seven different evaluative criteria. Results are mixed and inconclusive. DupER augmented data tend to result in larger root mean squared errors (RMSEs) and lower correlations between estimates and parameters for both item and ability parameters. However, some DupER variations produce estimates that are much less biased than those obtained from the raw data alone. For one DupER variation, it was found that DupER produced better results for low-ability simulees and worse results for those with high abilities. Findings, limitations, and recommendations for future studies are discussed. Specific recommendations for future studies include the application of Duper Augmentation (1) to empirical data, (2) with additional IRT models, and (3) the analysis of the efficacy of the procedure for different item and ability parameter distributions.

COMPLETE CONTROL OF NUISANCE BIRDS IN AIRPORT HANGARS

Fogging of ReJeX-iT7 TP-40 offers a very efficient method for the control and dispersal of nuisance birds from many diverse areas. The amount of the repellent is greatly reduced over any other control method. The method is direct and is independent of the activity of the birds. The applications with any fogger, thermal or mechanical, that can deliver droplets of less than 20 microns, can be manually or fully automated and pose only minimal risks to operators or animals. All birds that became a nuisance and safety problem in the hangars of TWA and AA at LaGuardia, and TWA warehouse at Newark Airport were successfully driven out by fogging ReJeX-iT7 TP-40 with a Curtis Dyna-Fog AGolden Eagle@ thermal fogger.