A feasibility study evaluating docetaxel-based sequential and combination regimens in the adjuvant therapy of node-positive breast cancer

BACKGROUND AND PURPOSE: Docetaxel is an active agent in the treatment of metastatic breast cancer. We evaluated the feasibility of docetaxel-based sequential and combination regimens as adjuvant therapies for patients with node-positive breast cancer. PATIENTS AND METHODS: Three consecutive groups of patients with node-positive breast cancer or locally-advanced disease, aged < or = 70 years, received one of the following regimens: a) sequential A-->T-->CMF: doxorubicin 75 mg/m2 q 3 weeks x 3, followed by docetaxel 100 mg/m2 q 3 weeks x 3, followed by i.v. CMF days 1 + 8 q 4 weeks x 3; b) sequential accelerated A-->T-->CMF: A and T were administered at the same doses q 2 weeks; c) combination therapy: doxorubicin 50 mg/m2 + docetaxel 75 mg/m2 q 3 weeks x 4, followed by CMF x 4. When indicated, radiotherapy was administered during or after CMF, and tamoxifen started after the end of CMF. RESULTS: Seventy-nine patients have been treated. Median age was 48 years. A 30% rate of early treatment discontinuation was observed in patients receiving the sequential accelerated therapy (23% during A-->T), due principally to severe skin toxicity. Median relative dose-intensity was 100% in the three treatment arms. The incidence of G3-G4 major toxicities by treated patients, was as follows: skin toxicity a: 5%; b: 27%; c: 0%; stomatitis a: 20%; b: 20%; c: 3%. The incidence of neutropenic fever was a: 30%; b: 13%; c: 48%. After a median follow-up of 18 months, no late toxicity has been reported. CONCLUSIONS: The accelerated sequential A-->T-->CMF treatment is not feasible due to an excess of skin toxicity. The sequential non accelerated and the combination regimens are feasible and under evaluation in a phase III trial of adjuvant therapy.

Surface area, porosity and water adsorption properties of fine volcanic ash particles

Our understanding on how ash particles in volcanic plumes react with coexisting gases and aerosols is still rudimentary, despite the importance of these reactions in influencing the chemistry and dynamics of a plume. In this study, six samples of fine ash (<100 μm) from different volcanoes were measured for their specific surface area, as, porosity and water adsorption properties with the aim to provide insights into the capacity of silicate ash particles to react with gases, including water vapour. To do so, we performed high-resolution nitrogen and water vapour adsorption/desorption experiments at 77 K and 303 K, respectively. The nitrogen data indicated as values in the range 1.1-2.1 m2/g, except in one case where as of 10 m2/g was measured. This high value is attributed to incorporation of hydrothermal phases, such as clay minerals, in the ash surface composition. The data also revealed that the ash samples are essentially non-porous, or have a porosity dominated by macropores with widths >500 Å All the specimens had similar pore size distributions, with a small peak centered around 50 Å These findings suggest that fine ash particles have relatively undifferentiated surface textures, irrespective of the chemical composition and eruption type. Adsorption isotherms for water vapour revealed that the capacity of the ash samples for water adsorption is systematically larger than predicted from the nitrogen adsorption as values. Enhanced reactivity of the ash surface towards water may result from (i) hydration of bulk ash constituents; (ii) hydration of surface compounds; and/or (iii) hydroxylation of the surface of the ash. The later mechanism may lead to irreversible retention of water. Based on these experiments, we predict that volcanic ash is covered by a complete monolayer of water under ambient atmospheric conditions. In addition, capillary condensation within ash pores should allow for deposition of condensed water on to ash particles before water reaches saturation in the plume. The total mass of water vapour retained by 1 g of fine ash at 0.95 relative water vapour pressure is calculated to be ∼10-2 g. Some volcanic implications of this study are discussed. © Springer-Verlag 2004.

A binding site for the cyclic adenosine 3',5'-monophosphate-response element-binding protein as a regulatory element in the grp78 promoter.

The 78-kDa glucose-regulated protein (GRP78) is ubiquitously expressed in many cell types. Its promoter contains multiple protein-binding sites and functional elements. In this study we examined a high affinity protein-binding site spanning bp -198 to -180 of the rat grp78 promoter, using nuclear extracts from both B-lymphoid and HeLa cells. This region contains a sequence TGACGTGA which, with the exception of one base, is identical to the cAMP-response element (CRE). Site-directed mutagenesis reveals that this sequence functions as a major basal level regulatory element in hamster fibroblast cells and is also necessary to maintain high promoter activity under stress-induced conditions. By gel mobility shift analysis, we detect two specific protein complexes. The major specific complex I, while immunologically distinct from the 42-kDa CRE-binding protein (CREB), binds most strongly to the grp site, but also exhibits affinity for the CRE consensus sequence. As such, complex I may consist of other members of the CREB/activating transcription factor protein family. The minor specific complex II consists of CREB or a protein antigenically related to it. A nonspecific complex III consists of the Ku autoantigen, an abundant 70- to 80-kDa protein complex in HeLa nuclear extracts. By cotransfection experiments, we demonstrate that in F9 teratocarcinoma cells, the grp78 promoter can be transactivated by the phosphorylated CREB or when the CREB-transfected cells are treated with the calcium ionophore A23187. The differential regulation of the grp78 gene by cAMP in specific cell types and tissues is discussed.