Anodic oxidation of InP in KOH electrolytes

The anodic behavior of InP in 1 mol dm-3 KOH was investigated and compared with its behavior at higher concentrations of KOH. At concentrations of 2 mol dm-3 KOH or greater, selective etching of InP occurs leading to thick porous InP layers near the surface of the sustrate. In contrast, in 1 mol dm-3 KOH, no such porous layers are formed but a thin surface film is formed at potentials in the range 0.6 V to 1.3 V. The thickness of this film was determined by spectroscopic ellipsometry as a function of the upper potential and the measured film thickness corresponds to the charge passed up to a potential of 1.0 V. Anodization to potentials above 1.5 V in 1 mol dm- 3 KOH results in the growth of thick, porous oxide films (~ 1.2 µm). These films are observed to crack, ex-situ, due to shrinkage after drying in ambient air. Comparisons between the charge density and film thickness measurements indicate a porosity of approximately 77% for such films.

An investigation into reactivity and selectivity in cycloadditions of 1,3-dipoles with formamidines

The objective of this research was to investigate the synthesis of nitrile oxides and to study their reactivity in 1,3-dipolar cycloadditions with formamidines. Chapter one looks at the literature surrounding the 1,3-dipolar cycloaddition reaction. It explores the generation of 1,3-dipoles (mainly nitrile oxides) and dipolarophiles (predominantly amidines). It discusses the potential synthetic uses of the 1,3-dipolar cycloadducts. It examines both and inter- and intra-molecular cycloaddition reactions. It recognises the use of the 1,3-dipolar cycloadditions as a successful method in building natural products and oxadiazolines. The decomposition of oxadiazolines as a route to nitriles is also outlined in this chapter. Chapter two discusses the results of this research candidate. The preparation of nitrile oxide precursors - hydroximoyl halides - is outlined at first. The generation of nitrile oxides is then demonstrated, followed by the preparation of furoxans. Methods for preparing the reference materials (nitriles and ureas), which result from decomposition of oxadiazolines, then follow. The preparation of series of Δ2-1,2,4- oxadiazolines via the 1,3-dipolar cycloaddition reaction is illustrated in this chapter. The selectivity of the addition of nitrile oxides to dipolarophiles was tested by competition reactions, which are also described in this chapter. NMR techniques were used in the study of the kinetics of the 1,3-dipolar cycloadditions used for the preparation of a series of Δ2-1,2,4-oxadiazolines, which is addressed in this chapter. Chapter three charts the experimental procedures followed to gain results which are discussed in chapter two. It also outlines all analytical data produced during the course of this research.