A craniometric study of population dynamics and social organisation in the European upper Palaeolithic and Mesolithic

The purpose of this study is to explore aspects of social organisation during the Upper Palaeolithic and Mesolithic periods using craniometric data. Different hypotheses were tested using geometric morphometrics, alongside traditional craniometric data. The clustering of individuals from the same site, as well as a correspondence to an isolation-by-distance model—particular in the Mesolithic samples—points to population structure within these groups. Moreover, discontinuities in cranial traits between the early Upper Palaeolithic and later periods could suggest that the Last Glacial Maximum had a disruptive effect on populations in Europe. Differences in social organisation can often result from cultural norms regarding post-marital residence. Such differences can be tested by comparing cranial data to that of geographic information. Greater variation in male cranial traits relative to females, after controlling for location, suggests that the overall pattern of residence during the Upper Palaeolithic and Mesolithic was one of matrilocality. It has been suggested that coastal occupation was density dependent and these populations show a greater degree of sedentism than their inland counterparts. Moreover, it has been proposed that coastal areas were not continuously occupied until the Late Pleistocene due to spatial restrictions that would adversely affect reproductive opportunities. This study corroborates the pattern seen in cranial traits corresponded with that of a more sedentary population. The results are consistent with the hypothesis that coastal populations are more sedentary than inland populations during these periods. This study adds new information regarding the social dynamics of prehistoric populations in Europe and sheds light on some of the conditions that may have paved the way for the transition to agriculture

The influence of thermal plasma profiles on low-frequency Alfvén eigenmode dynamics in a tokamak

The confinement of fast particles, present in a tokamak plasma as nuclear fusion products and through external heating, will be essential for any future fusion reactor. Fast particles can be expelled from the plasma through their interaction with Alfvén eigenmode (AE) instabilities. AEs can exist in gaps in the Alfvén continuum created by plasma equilibrium non-uniformities. In the ASDEX Upgrade tokamak, low-frequency modes in the frequency range from f ≈ 10 − 90kHz, including beta-induced Alfvén eigenmodes (BAEs) and lower frequency modes with mixed Alfvén and acoustic polarisations, have been observed. These exist in gaps in the Alfvén continuum opened up by geodesic curvature and finite plasma compressibility. In this thesis, a kinetic dispersion relation is solved numerically to investigate the influence of thermal plasma profiles on the evolution of these low-frequency modes during the sawtooth cycle. Using information gained from various experimental sources to constrain the equilibrium reconstructions, realistic safety factor profiles are obtained for the analysis using the CLISTE code. The results for the continuum accumulation point evolution are then compared with experimental results from ASDEX Upgrade during periods of ICRH only as well as for periods with both ICRH and ECRH applied simultaneously. It is found that the diamagnetic frequency plays an important role in influencing the dynamics of BAEs and low-frequency acoustic Alfvén eigenmodes, primarily through the presence of gradients in the thermal plasma profiles. Different types of modes that are observed during discharges heated almost exclusively by ECRH were also investigated. These include electron internal transport barrier (eITB) driven modes, which are observed to coincide with the occurrence of an eITB in the plasma during the low-density phase of the discharge. Also observed are BAE-like modes and edge-TAEs, both of which occur during the H-mode phase of the discharge.

Kinetics and coverage dependent reaction mechanisms of the copper atomic layer deposition from copper dimethylamino-2-propoxide and diethylzinc

Atomic layer deposition (ALD) has been recognized as a promising method to deposit conformal and uniform thin film of copper for future electronic devices. However, many aspects of the reaction mechanism and the surface chemistry of copper ALD remain unclear. In this paper, we employ plane wave density functional theory (DFT) to study the transmetalation ALD reaction of copper dimethylamino-2-propoxide [Cu(dmap)2] and diethylzinc [Et2Zn] that was realized experimentally by Lee et al. [ Angew. Chem., Int. Ed. 2009, 48, 4536−4539]. We find that the Cu(dmap)2 molecule adsorbs and dissociates through the scission of one or two Cu–O bonds into surface-bound dmap and Cu(dmap) fragments during the copper pulse. As Et2Zn adsorbs on the surface covered with Cu(dmap) and dmap fragments, butane formation and desorption was found to be facilitated by the surrounding ligands, which leads to one reaction mechanism, while the migration of ethyl groups to the surface leads to another reaction mechanism. During both reaction mechanisms, ligand diffusion and reordering are generally endothermic processes, which may result in residual ligands blocking the surface sites at the end of the Et2Zn pulse, and in residual Zn being reduced and incorporated as an impurity. We also find that the nearby ligands play a cooperative role in lowering the activation energy for formation and desorption of byproducts, which explains the advantage of using organometallic precursors and reducing agents in Cu ALD. The ALD growth rate estimated for the mechanism is consistent with the experimental value of 0.2 Å/cycle. The proposed reaction mechanisms provide insight into ALD processes for copper and other transition metals.