A review of the effectiveness and meaningfulness of education interventions to enable children, young people and their families to self-care for their gastrostomy tubes in the community.

A systematic review of qualitative and quantitative evidence of the effectiveness and meaningfulness of education interventions to enable children, young people and their families to self-care for their gastrostomy tubes in the community

Volumetric consequences of particle loss by grading entropy.

Chemical and biological processes, such as dissolution in gypsiferous sands and biodegradation in waste refuse, result in mass or particle loss, which in turn lead to changes in solid and void phase volumes and grading. Data on phase volume and grading changes have been obtained from oedometric dissolution tests on sand–salt mixtures. Phase volume changes are defined by a (dissolution-induced) void volume change parameter (Λ). Grading changes are interpreted using grading entropy coordinates, which allow a grading curve to be depicted as a single data point and changes in grading as a vector quantity rather than a family of distribution curves. By combining Λ contours with pre- to post-dissolution grading entropy coordinate paths, an innovative interpretation of the volumetric consequences of particle loss is obtained. Paths associated with small soluble particles, the loss of which triggers relatively little settlement but large increase in void ratio, track parallel to the Λ contours. Paths associated with the loss of larger particles, which can destabilise the sand skeleton, tend to track across the Λ contours.

Moisture conditions in timber cladding: field trial data for Sitka spruce.

Exposure trials on timber cladding are valuable for informing facade designers. This paper describes a trial using Sitka spruce (Picea sitchensis). Sitka spruce is the only UK-grown timber available in sufficient volume to supply the growing cladding market, but its suitability is unclear. Data indicated that the moisture content range in timber cladding was wider than generally accepted. The minimum of around 10% moisture content appeared to be similar for all details tested. The maximum was influenced by construction detailing but was around 30%. From a theoretical standpoint, the range, and rate, of moisture content fluctuation observed meant that the commonly quoted average value was largely irrelevant. The mode was a more representative statistic; most of the data were skewed towards the wood's fibre saturation point. Sitka spruce is, therefore, at risk of fungal decay and is only suitable as external cladding in the UK if treated with preservative