Análise energética da madeira e do carvão de híbridos entre Corymbia citriodora (Hook.) K.D. Hill & L.A.S. Johnson e Corymbia torelliana (F. Muell.) K.D. Hill & L.A.S. Johnson

This research aimed to evaluate the wood and charcoal quality of hybrids clone of the crossing C. citriodora with C. torelliana in two different locations for charcoal production. Seven with 3,75 years old clones, planted at country of Itamarandiba – MG, and six 6,42 years old clones, planted in Dionísio – MG, were studied. For wood and charcoal quality analysis, samples were collected along the stem of the trees until the commercial height. Properties study of the wood was done by chemical analysis, basic density, superior heat power, and thermogravimetric analysis. The wood samples were carbonized in laboratory conditions with heating rate of 1.67 0 C.min -1 , starting at 100 0 C until 450 0 C and keeping on this temperature for 30 minutes. It were determined the carbonizations gravimetric yield, all in dry basis. The wood quality was evaluated based on the chemical immediate analysis, relative apparent density, and gross heating value. The experiment was installed according to the completely randomized design, with five repetitions. The collected data were submitted to analysis of variance and, when the evaluated effects were significant by “F” test, was applied the Scott-Knott test at 5% probability for multiple comparisons. For correlation analysis, Pearson correlation coefficient, tested by the "t" test at 5% probability was used. Results showed variability of wood between the genetic materials evaluated in relation to place and plant crossing. The thermal analysis of the wood showed significant variation between clones and it was possible to differentiate two stages of degradation (hemicelluloses and cellulose). The majority of the clones presented satisfactory properties for the charcoal production, while, clone 3, planted in Itamarandiba, obtained the best performance due it have the higher yield and energetic efficiency, thus, achieving the best potential for charcoal production. However, clone 9, planted in Dionísio, was the less indicated for charcoal production since it presented the lowest energetic efficiency, gravimetric yield, and densities.

Macauba palm (acrocomia aculeata) cake from biodiesel processing: an efficient and low cost substrate for the adsorption of dyes

The potential of natural and heat-treated Macauba palm cake as adsorbent for the removal of Methylene Blue (MB) and Congo Red (CR) from solution has been investigated. Equilibrium adsorption was attained in <7 h and the process was favored at pH 5.0 for MB and pH 6.5 for CR with an adsorbent (g):adsorbate (mL) ratio of 1:200 and an initial concentration of adsorbate of 25 mg L−1. The maximum adsorption capacities of the natural and heat-treated materials were, respectively, 25.80 and 32.30 mg g−1 for MB, and 32.00 and 20.30 mg g−1 for CR. The isotherm model proposed by Sips represented most adequately the adsorption of MB and CR. The adsorptions of the dyes were best described in terms of a pseudo second-order reaction. Thermodynamic parameters such as ΔHo, ΔSo and ΔGo were calculated. The adsorption process was found to be endothermic and spontaneous. Macauba palm cake is adequate for the removal of waste dye from industrial effluents by virtue of its abundance, low cost and efficiency of adsorption.