Temperature Sensing Using Colloidal-Core Photonic Crystal Fiber

We report on a temperature sensor based on the monitoring of the luminescence spectrum of CdSe/ZnS nanocrystals, dispersed in mineral oil and inserted into the core of a photonic crystal fiber. The high overlap between the pump light and the nanocrystals as well as the luminescence guiding provided by the fiber geometry resulted in relatively high luminescence powers and improved optical signal-to-noise ratio (OSNR). Also, both core end interfaces were sealed so as to generate a more stable and robust waveguide structure. Temperature sensitivity experiments indicated a 70 pm/degrees C spectral shift over the 5 degrees C to 90 degrees C range.

Changes on emitter discharge under different water temperature and pressure

The study was conducted at the Research Laboratory of Hydraulic and Irrigation Group in the Rural Engineering Department, Technical University of Madrid (Universidad Politecnica de Madrid), Madrid, Spain. Water temperatures of 20, 30, 40 degrees C and system pressures often encountered in irrigation practices of 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180, 190 and 200 k Pa were applied to determine the effects of different water temperatures and pressures on emitter discharge. Non-pressure compensating in-line emitter which has turbulent flow regime with a long-path (labyrinth), emitter discharge was 4 L h(-1) at system pressure of 100 kPa according to the manufacturer recommended, was used. Emitters were spaced 20 cm along the drip laterals with 16 mm diameter. Discharge equations and coefficients of variation related to temperatures of 20, 30 and 40 degrees C were obtained as q = 0.375H(0.51), q = 0.358H(0.52), q = 0.346H(0.53) and 2.68, 2.09, 3.65, respectively. Discharge of the emitter was affected by different system pressures and increased as potentially (R = 0993-0996). In general. the emitter discharge increased with increasing temperature. However, especially in the common system pressures of 90-120 k Pa, differences of obtained emitter discharges between the different water temperatures were not significant (1%).

Quartz OSL sensitivity as a proxy for storm activity on the southern Brazilian coast during the Late Holocene

Natural cycles of irradiation during burial and bleaching due to solar exposure during transport increase the Optically Stimulated Luminescence (OSL) sensitivity of quartz sand grains. The relationship between the OSL sensitivity and sediment transport allows to discriminate quartz sand grains with different depositional histories. In this paper, we evaluate the variation of OSL sensitivity in quartz grains deposited during the progradation of the Ilha Comprida barrier on the southern Brazilian, coast. Changes in sand sensitivity recorded by barrier growth since 6 ka ago are controlled by the variation in the proportion of low versus high sensitivity quartz grains. Low sensitivity grains with short sedimentary history are supplied by the Ribeira de Iguape River and reach the barrier through southward alongshore currents during fair weather conditions. Storm conditions shift the alongshore currents to northeast and permit the transport of high sensitivity grains with long sedimentary history from distal southern coastal sectors to the barrier. Therefore, the input of distal sediments for the Ilha Comprida barrier depends on the frequency and intensity of storms. Thus, the OSL sensitivity can be used as proxy for storm activity. The variation of OSL sensitivity through time indicates that the Ilha Comprida barrier changed from a relatively stable to an unstable storm pattern around 2 ka ago. Periods with increased storm activity peaked around AD 500, AD 1500 and AD 1850, approximately on the boundaries of the Medieval Climate Anomaly and the Little Ice Age. (C) 2012 Elsevier B.V. All rights reserved.