Thalidomide plus dexamethasone as a maintenance therapy after autologous hematopoietic stem cell transplantation improves progression-free survival in multiple myeloma

Despite the good response of stem cell transplant (SCT) in the treatment of multiple myeloma (MM), most patients relapse or do not achieve complete remission, suggesting that additional treatment is needed. We assessed the impact of thalidomide in maintenance after SCT in untreated patients with MM. A hundred and eight patients (<70 years old) were randomized to receive maintenance with dexamethasone (arm A; n = 52) or dexamethasone with thalidomide (arm B; n = 56; 200 mg daily) for 12 months or until disease progression. After a median follow-up of 27 months, an intention to treat analysis showed a 2-year progression-free survival (PFS) of 30% in arm A (95% CI 2238) and 64% in arm B (95% CI 5771; P = 0.002), with median PFS of 19 months and 36 months, respectively. In patients who did not achieve at least a very good partial response, the PFS at 2 years was significantly higher when in use of thalidomide (19 vs. 59%; P = 0.002). Overall survival at 2 years was not significantly improved (70 vs. 85% in arm A and arm B, respectively; P = 0.27). The addition of thalidomide to dexamethasone as maintenance improved the PFS mainly in patients who did not respond to treatment after SCT. Am. J. Hematol. (c) 2012 Wiley Periodicals, Inc.

The Influence of Environmental Temperature and Air Humidity on the Maintenance of Sterility of Surgical Instruments Sterilized in Different Wraps

State of Sao Paulo Research Foundation (FAPESP), Brazil

Improvement in ARDS experimental model installation: Low mortality rate and maintenance of hemodynamic stability

Introduction: Many experimental models using lung lavage have been developed for the study of acute respiratory distress syndrome (ARDS). The original technique has been modified by many authors, resulting in difficulties with reproducibility. There is insufficient detail on the lung injury models used, including hemodynamic stability during animal preparation and drawbacks encountered such as mortality. The authors studied the effects of the pulmonary recruitment and the use of fixed tidal volume (Vt) or fixed inspiratory pressure in the experimental ARDS model installation. Methods: Adult rabbits were submitted to repeated lung lavages with 30 ml/kg warm saline until the ARDS definition (PaO2/FiO(2) <= 100) was reached. The animals were divided into three groups, according to the technique used for mechanical ventilation: 1) fixed Vt of 10 ml/kg; 2) fixed inspiratory pressure (IP) with a tidal volume of 10 ml/kg prior to the first lung lavage; and 3) fixed Vt of 10 ml/kg with pulmonary recruitment before the first lavage. Results: The use of alveolar recruitment maneuvers, and the use of a fixed Vt or IP between the lung lavages did not change the number of lung lavages necessary to obtain the experimental model of ARDS or the hemodynamic stability of the animals during the procedure. A trend was observed toward an increased mortality rate with the recruitment maneuver and with the use of a fixed IP. Discussion: There were no differences between the three study groups, with no disadvantage in method of lung recruitment, either fixed tidal volume or fixed inspiratory pressure, regarding the number of lung lavages necessary to obtain the ARDS animal model. Furthermore, the three different procedures resulted in good hemodynamic stability of the animals, and low mortality rate. (C) 2012 Elsevier Inc. All rights reserved.

Integrating on-line process control and imperfect corrective maintenance: An economical design

Existing studies of on-line process control are concerned with economic aspects, and the parameters of the processes are optimized with respect to the average cost per item produced. However, an equally important dimension is the adoption of an efficient maintenance policy. In most cases, only the frequency of the corrective adjustment is evaluated because it is assumed that the equipment becomes "as good as new" after corrective maintenance. For this condition to be met, a sophisticated and detailed corrective adjustment system needs to be employed. The aim of this paper is to propose an integrated economic model incorporating the following two dimensions: on-line process control and a corrective maintenance program. Both performances are objects of an average cost per item minimization. Adjustments are based on the location of the measurement of a quality characteristic of interest in a three decision zone. Numerical examples are illustrated in the proposal. (c) 2012 Elsevier B.V. All rights reserved.

Mutations in CTC1, encoding conserved telomere maintenance component 1, cause Coats plus

Coats plus is a highly pleiotropic disorder particularly affecting the eye, brain, bone and gastrointestinal tract. Here, we show that Coats plus results from mutations in CTC1, encoding conserved telomere maintenance component 1, a member of the mammalian homolog of the yeast heterotrimeric CST telomeric capping complex. Consistent with the observation of shortened telomeres in an Arabidopsis CTC1 mutant and the phenotypic overlap of Coats plus with the telomeric maintenance disorders comprising dyskeratosis congenita, we observed shortened telomeres in three individuals with Coats plus and an increase in spontaneous gamma H2AX-positive cells in cell lines derived from two affected individuals. CTC1 is also a subunit of the alpha-accessory factor (AAF) complex, stimulating the activity of DNA polymerase-alpha primase, the only enzyme known to initiate DNA replication in eukaryotic cells. Thus, CTC1 may have a function in DNA metabolism that is necessary for but not specific to telomeric integrity.

PLGA microspheres containing bee venom proteins for preventive immunotherapy

Bee venom (BV) allergy is potentially dangerous for allergic individuals because a single bee sting may induce an anaphylactic reaction, eventually leading to death. Currently, venom immunotherapy (VIT) is the only treatment with long-lasting effect for this kind of allergy and its efficiency has been recognized worldwide. This therapy consists of subcutaneous injections of gradually increasing doses of the allergen. This causes patient lack of compliance due to a long time of treatment with a total of 30-80 injections administered over years. In this article we deal with the characterization of different MS-PLGA formulations containing BV proteins for VIT. The PLGA microspheres containing BV represent a strategy to replace the multiple injections, because they can control the solute release. Physical and biochemical methods were used to analyze and characterize their preparation. Microspheres with encapsulation efficiencies of 49-75% were obtained with a BV triphasic release profile. Among them, the MS-PLGA 34 kDa-COOH showed to be best for VIT because they presented a low initial burst (20%) and a slow BV release during lag phase. Furthermore, few conformational changes were observed in the released BV. Above all, the BV remained immunologically recognizable, which means that they could continuously stimulate the immune system. Those microspheres containing BV could replace sequential injections of traditional VIT with the remarkable advantage of reduced number of injections. (C) 2011 Elsevier B.V. All rights reserved.

Model-based reuse for crosscutting frameworks: assessing reuse and maintenance effort

Abstract Background Over the last years, a number of researchers have investigated how to improve the reuse of crosscutting concerns. New possibilities have emerged with the advent of aspect-oriented programming, and many frameworks were designed considering the abstractions provided by this new paradigm. We call this type of framework Crosscutting Frameworks (CF), as it usually encapsulates a generic and abstract design of one crosscutting concern. However, most of the proposed CFs employ white-box strategies in their reuse process, requiring two mainly technical skills: (i) knowing syntax details of the programming language employed to build the framework and (ii) being aware of the architectural details of the CF and its internal nomenclature. Also, another problem is that the reuse process can only be initiated as soon as the development process reaches the implementation phase, preventing it from starting earlier. Method In order to solve these problems, we present in this paper a model-based approach for reusing CFs which shields application engineers from technical details, letting him/her concentrate on what the framework really needs from the application under development. To support our approach, two models are proposed: the Reuse Requirements Model (RRM) and the Reuse Model (RM). The former must be used to describe the framework structure and the later is in charge of supporting the reuse process. As soon as the application engineer has filled in the RM, the reuse code can be automatically generated. Results We also present here the result of two comparative experiments using two versions of a Persistence CF: the original one, whose reuse process is based on writing code, and the new one, which is model-based. The first experiment evaluated the productivity during the reuse process, and the second one evaluated the effort of maintaining applications developed with both CF versions. The results show the improvement of 97% in the productivity; however little difference was perceived regarding the effort for maintaining the required application. Conclusion By using the approach herein presented, it was possible to conclude the following: (i) it is possible to automate the instantiation of CFs, and (ii) the productivity of developers are improved as long as they use a model-based instantiation approach.

Pathogenicity of Nc-Bahia and Nc-1 strains of Neospora caninum in experimentally infected cows and buffaloes in early pregnancy

Neospora caninum is a protozoan parasite known as an important cause of bovine abortion worldwide. Little is currently known about how different strains of N. caninum vary in their pathogenicity. In this study, we compared a Brazilian strain, Nc-Bahia, with the first isolate of this coccidian, Nc-1. Eight cows and seven buffaloes were submitted to fixed-time artificial insemination protocols for a better control of pregnancy. Group 1 was inoculated with Nc-Bahia (n=8; five cows and three buffaloes), and Group 2 was inoculated with Nc-1 (n=5; two cows and three buffaloes). One nonpregnant female of each species was left uninfected as sentinel controls for potential environmental infection. All inoculated animals received 5×108 tachyzoites of N. caninum, by intravenous route, on the 70th day of gestation. Uninfected animals remained seronegative throughout the experiment, indicating no exogenous infection, whereas all inoculated animals became seropositive to N. caninum. In Group 1, abortion was found in only one cow on 42 days postinfection (dpi; frequency of abortion=12.5 %), whilst all animals from Group 2 aborted on 35 dpi (frequency of abortion= 100 %). Parasite DNA was detected by seminested PCR in maternal, foetal and placental tissues, confirming vertical transmission in Groups 1 and 2, although histological lesions had different frequencies and degrees of severity between the groups. There was evidence of lower pathogenicity of Nc- Bahia compared to Nc-1 when used in experimental infection, as it caused fewer abortions, as well as less frequent and milder histological lesions. This was the first time Nc-Bahia has been used for experimental infection.