Structure- and Ligand-Based Structure-Activity Relationships for a Series of Inhibitors of Aldolase

Aldolase has emerged as a promising molecular target for the treatment of human African trypanosomiasis. Over the last years, due to the increasing number of patients infected with Trypanosoma brucei, there is an urgent need for new drugs to treat this neglected disease. In the present study, two-dimensional fragment-based quantitative-structure activity relationship (QSAR) models were generated for a series of inhibitors of aldolase. Through the application of leave-one-out and leave-many-out cross-validation procedures, significant correlation coefficients were obtained (r(2) = 0.98 and q(2) = 0.77) as an indication of the statistical internal and external consistency of the models. The best model was employed to predict pK(i) values for a series of test set compounds, and the predicted values were in good agreement with the experimental results, showing the power of the model for untested compounds. Moreover, structure-based molecular modeling studies were performed to investigate the binding mode of the inhibitors in the active site of the parasitic target enzyme. The structural and QSAR results provided useful molecular information for the design of new aldolase inhibitors within this structural class.

The impact of the Bolsa Escola/Familia conditional cash transfer program on enrollment, dropout rates and grade promotion in Brazil

We examine the impact of Brazil's Bolsa Escola/Familia program on Brazilian children's education outcomes. Bolsa provides cash payments to poor households if their children (ages 6 to 15) are enrolled in school. Using school census data to compare changes in enrollment, dropping out and grade promotion across schools that adopted Bolsa at different times, we estimate that the program has: increased enrollment by about 5.5% (6.5%) in grades 1-4 (grades 5-8); lowered dropout rates by 0.5 (0.4) percentage points in grades 1-4 (grades 5-8); and raised grade promotion rates by 0.9 (0.3) percentage points in grades 1-4 (grades 5-8). About one third of Brazil's children participate in Bolsa, so assuming no spillover effects onto non-participants implies that Bolsa's impacts are three times higher than these estimates. However, simple calculations using enrollment impacts suggest that Bolsa's benefits in terms of increased wages may not exceed its costs. (C) 2011 Elsevier B.V. All rights reserved.

In Vitro Macroscopic and Endoscopic Analysis of Three-Rooted Maxillary Premolars and Two-Rooted Mandibular Premolars in the Same Individual: a Case Report

The recent addition of endoscopy in dental practice has enabled clinicians to have an excellent view of the operative field, yielding highly successful visualization of anatomical structures that are difficult to access, both in oral surgery and endodontics. The purpose of this report is to provide an in vitro macroscopic, radiographic, and endoscopic description of the anatomic variation of the roots of maxillary and mandibular first premolars in the same patient. A 22-year-old patient was referred by an orthodontist for the extraction of all the first premolars. Once extracted, the premolars were examined macroscopically and then analyzed radiographically after trepanation and filled root canal systems. Subsequently, a diaphanization process was carried out and the samples were sectioned at the middle and apical third for observation by endoscope. It was found that both the maxillary first premolars had three roots, and mandibular first premolars had two roots, all with complete root formation. Apical deltas or accessory canals were not identified in the radiographic images; however, through endoscope at the middle third, it was possible to observe an accessory canal to the first maxillary and mandibular right premolars. Thus, it can be concluded that the view through the endoscope allows better identification of accessory canals than X-rays.

Glycosaminoglycan profiles in the uterus of adult ovariectomized rats treated with estrogen and progestagen

Objectives: To evaluate the effects of conjugated equine estrogens (CE) alone or in combination with medroxyprogesterone acetate (MPA) on glycosaminoglycans (GAGs) in the cervix and horns of the rat uterus. Study design: Thirty days after ovariectomy, adult rats were randomly divided into four groups: Cl, control (treated with drug vehicle); GII CE (50 mu g/kg per day); GIII, MPA (0.2 mg/kg per day), and GIV, CE + MPA (doses as in GII and Gill). Drugs and vehicle were given by gavage during 28 days. Afterwards the animals were anesthetized, the cervix and uterine horns were dissected out and the middle portion fixed in 10% formaldehyde solution; other portions were fixed in acetone for histological examination and glycosaminoglycan quantification, respectively. Agarose gel electrophoresis was used for sulfated GAG analyses, and hyaluronic acid was assayed with an ELISA-like method. Statistical analysis was done by the Student's t test and the Tukey-Kramer test (P < 0.05). Results: The cervix and uterine horn structures presented signs of atrophy in the control group (GI). The other groups, mainly groups III and IV, had histological aspects of proliferation. In all groups the concentration of sulfated GAGs (especially dermatan sulfate) was higher than that of non-sulfated GAGs, both in cervix and in uterine horns. Estrogens increased sulfated GAG concentration at the cervix and the horn, whereas in uterine horns the amounts of sulfated GAGs were decreased after estrogens plus MPA treatment. The concentration of hyaluronic acid in uterine horns was higher than in cervices. Conclusions: The profiling and amounts of glycosaminoglycans in the two portions of the rat uterus are uneven. Dermatan sulfate occurs in higher concentrations in both cervix and uterine horns. Sulfated GAGs in rat cervix were increased by estrogens plus MPA, but were decreased by MPA alone in uterine horns. (C) 2012 Elsevier Ireland Ltd. All rights reserved.

Changes on emitter discharge under different water temperature and pressure

The study was conducted at the Research Laboratory of Hydraulic and Irrigation Group in the Rural Engineering Department, Technical University of Madrid (Universidad Politecnica de Madrid), Madrid, Spain. Water temperatures of 20, 30, 40 degrees C and system pressures often encountered in irrigation practices of 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180, 190 and 200 k Pa were applied to determine the effects of different water temperatures and pressures on emitter discharge. Non-pressure compensating in-line emitter which has turbulent flow regime with a long-path (labyrinth), emitter discharge was 4 L h(-1) at system pressure of 100 kPa according to the manufacturer recommended, was used. Emitters were spaced 20 cm along the drip laterals with 16 mm diameter. Discharge equations and coefficients of variation related to temperatures of 20, 30 and 40 degrees C were obtained as q = 0.375H(0.51), q = 0.358H(0.52), q = 0.346H(0.53) and 2.68, 2.09, 3.65, respectively. Discharge of the emitter was affected by different system pressures and increased as potentially (R = 0993-0996). In general. the emitter discharge increased with increasing temperature. However, especially in the common system pressures of 90-120 k Pa, differences of obtained emitter discharges between the different water temperatures were not significant (1%).

Approach to the Patient with Persistent Hyperprolactinemia and Negative Sellar Imaging

Hyperprolactinemia is a common cause of menstrual disturbances affecting young women. There is a diversity of causes, from physiological, such as pregnancy, to pharmacological and pathological, such as hypothyroidism. Renal and hepatic failure, intercostal nerve stimulation by trauma or surgery, prolactinomas, other tumors in the hypothalamus-pituitary region, as well as macroprolactinemia can also be considered. Identifying the correct cause is important to establish the correct treatment. Should all these causes be ruled out and pituitary imaging revealed as negative, idiopathic hyperprolactinemia is therefore diagnosed. In symptomatic patients, treatment with dopaminergic agonists is indicated. As for the asymptomatic hyperprolactinemic individuals, macroprolactinemia should be screened, and once it is detected, there is no need for pituitary imaging study or for dopaminergic agonist use. (J Clin Endocrinol Metab 97: 2211-2216, 2012)

Microtensile bond strength of composite resin to glass-infiltrated alumina composite conditioned with Er,Cr:YSGG laser

Tribochemical silica-coating is the recommended conditioning method for improving glass-infiltrated alumina composite adhesion to resin cement. High-intensity lasers have been considered as an alternative for this purpose. This study evaluated the morphological effects of Er,Cr:YSGG laser irradiation on aluminous ceramic, and verified the microtensile bond strength of composite resin to ceramic following silica coating or laser irradiation. In-Ceram Alumina ceramic blocks were polished, submitted to airborne particle abrasion (110 mu m Al(2)O(3)), and conditioned with: (CG) tribochemical silica coating (110 mu m SiO(2)) + silanization (control group); (L1-L10) Er,Cr:YSGG laser (2.78 mu m, 20 Hz, 0.5 to 5.0 W) + silanization. Composite resin blocks were cemented to the ceramic blocks with resin cement. These sets were stored in 37A degrees C distilled water (24 h), embedded in acrylic resin, and sectioned to produce bar specimens that were submitted to microtensile testing. Bond strength values (MPa) were statistically analyzed (alpha a parts per thousand currency sign0.05), and failure modes were determined. Additional ceramic blocks were conditioned for qualitative analysis of the topography under SEM. There were no significant differences among silicatization and laser treatments (p > 0.05). Microtensile bond strength ranged from 19.2 to 27.9 MPa, and coefficients of variation ranged from 30 to 55%. Mixed failure of adhesive interface was predominant in all groups (75-96%). No chromatic alteration, cracks or melting were observed after laser irradiation with all parameters tested. Surface conditioning of glass-infiltrated alumina composite with Er,Cr:YSGG laser should be considered an innovative alternative for promoting adhesion of ceramics to resin cement, since it resulted in similar bond strength values compared to the tribochemical treatment.

Evaluation of peak cough flow in Brazilian healthy adults

Abstract Introduction In this study we aimed to evaluate the peak cough flow (PCF) in healthy Brazilian subjects. Methods We evaluated 484 healthy subjects between 18 and 40 years old. Subjects were seated and oriented were asked to perform a maximal inspiration followed by a quick, short and explosive expiration on the peak flow meter. Three measures were carried out and recorded the average of the three results for each individual. Results The PCF values ranged between 240 and 500 L/min. The PCF values were lower in females than in males. The PCF was inversely proportional to age. Conclusion The values for Brazilian adult healthy subjects regarding PCF were between 240 and 500 L/min.