Improvement in ARDS experimental model installation: Low mortality rate and maintenance of hemodynamic stability

Introduction: Many experimental models using lung lavage have been developed for the study of acute respiratory distress syndrome (ARDS). The original technique has been modified by many authors, resulting in difficulties with reproducibility. There is insufficient detail on the lung injury models used, including hemodynamic stability during animal preparation and drawbacks encountered such as mortality. The authors studied the effects of the pulmonary recruitment and the use of fixed tidal volume (Vt) or fixed inspiratory pressure in the experimental ARDS model installation. Methods: Adult rabbits were submitted to repeated lung lavages with 30 ml/kg warm saline until the ARDS definition (PaO2/FiO(2) <= 100) was reached. The animals were divided into three groups, according to the technique used for mechanical ventilation: 1) fixed Vt of 10 ml/kg; 2) fixed inspiratory pressure (IP) with a tidal volume of 10 ml/kg prior to the first lung lavage; and 3) fixed Vt of 10 ml/kg with pulmonary recruitment before the first lavage. Results: The use of alveolar recruitment maneuvers, and the use of a fixed Vt or IP between the lung lavages did not change the number of lung lavages necessary to obtain the experimental model of ARDS or the hemodynamic stability of the animals during the procedure. A trend was observed toward an increased mortality rate with the recruitment maneuver and with the use of a fixed IP. Discussion: There were no differences between the three study groups, with no disadvantage in method of lung recruitment, either fixed tidal volume or fixed inspiratory pressure, regarding the number of lung lavages necessary to obtain the ARDS animal model. Furthermore, the three different procedures resulted in good hemodynamic stability of the animals, and low mortality rate. (C) 2012 Elsevier Inc. All rights reserved.

Efficacy of graded activity versus supervised exercises in patients with chronic non-specific low back pain: protocol of a randomised controlled trial

Abstract Background Low back pain is a relevant public health problem, being an important cause of work absenteeism worldwide, as well as affecting the quality of life of sufferers and their individual functional performances. Supervised active physical routines and of cognitive-behavioral therapies are recommended for the treatment of chronic Low back pain, although evidence to support the effectiveness of different techniques is missing. Accordingly, the aim of this study is to contrast the effectiveness of two types of exercises, graded activity or supervised, in decreasing symptoms of chronic low back pain. Methods/design Sample will consist of 66 patients, blindly allocated into one of two groups: 1) Graded activity which, based on an operant approach, will use time-contingent methods aiming to increase participants’ activity levels; 2) Supervised exercise, where participants will be trained for strengthening, stretching, and motor control targeting different muscle groups. Interventions will last one hour, and will happen twice a week for 6 weeks. Outcomes (pain, disability, quality of life, global perceived effect, return to work, physical activity, physical capacity, and kinesiophobia) will be assessed at baseline, at treatment end, and three and six months after treatment end. Data collection will be conducted by an investigator blinded to treatment allocation. Discussion This project describes the randomisation method that will be used to compare the effectiveness of two different treatments for chronic low back pain: graded activity and supervised exercises. Since optimal approach for patients with chronic back pain have yet not been defined based on evidence, good quality studies on the subject are necessary. Trial registration NCT01719276

Comparative electrical behavior at low and high current of SnO(2)- and ZnO-based varistors

The complete I-V characteristics of SnO(2)-based varistors, particularly of the Pianaro system SCNCr consisting in 98.9%SnO(2)+1%CoO+0.05%Nb(2)O(5)+0.05%Cr(2)O(3), all in mol%, have been seldom reported in the literature. A comparative study at low and high currents of the nonohmic behavior of SCNCr- and ZnO-based varistors (modified Matsuoka system) is proposed in this work. The SCNCr system showed higher nonlinearity coefficients in the whole range of measured current. The electrical breakdown field (E(b)) was twice as high for the SCNCr system (5400 V/cm) than for the ZnO varistor (2600 V/cm) due to a smaller average grain size of the former (4.5 mu m) with respect to the latter (8.5 mu m). Nevertheless, we consider that another important factor responsible for the high E(b) in the SCNCr system is the great number of electrically active interfaces (85%) as determined with electrostatic force microscopy (EFM). It was also established that the SCNCr system might be produced in disks of smaller dimensions than that of commercial ZnO-based product, with a 5.0 cm(-1) minimal area-volume (A/V) ratio. The SCNCr reached the saturation current in a short time because of the high resistivity of the grains, which is five times higher than that of the grains in ZnO-based varistors.

Characterization of depolymerized residues from extremely low acid hydrolysis (ELA) of sugarcane bagasse cellulose: Effects of degree of polymerization, crystallinity and crystallite size on thermal decomposition

Sugarcane bagasse cellulose was subjected to the extremely low acid (ELA) hydrolysis in 0.07% H2SO4 at 190, 210 and 225 degrees C for various times. The cellulose residues from this process were characterized by TGA, XRD, GPC, FIR and SEM. A kinetic study of thermal decomposition of the residues was also carried out, using the ASTM and Kissinger methods. The thermal studies revealed that residues of cellulose hydrolyzed at 190, 210 and 225 degrees C for 80,40 and 8 min have initial decomposition temperature and activation energy for the main decomposition step similar to those of Avicel PH-101. XRD studies confirmed this finding by showing that these cellulose residues are similar to Avicel in crystallinity index and crystallite size in relation to the 110 and 200 planes. FTIR spectra revealed no significant changes in the cellulose chemical structure and analysis of SEM micrographs demonstrated that the particle size of the cellulose residues hydrolyzed at 190 and 210 degrees C were similar to that of Avicel. (C) 2011 Elsevier B.V. All rights reserved.

Effect of pulse repetition rate and number of pulses in the analysis of polypropylene and high density polyethylene by nanosecond infrared laser induced breakdown spectroscopy

Pulse repetition rates and the number of laser pulses are among the most important parameters that do affect the analysis of solid materials by laser induced breakdown spectroscopy, and the knowledge of their effects is of fundamental importance for suggesting analytical strategies when dealing with laser ablation processes of polymers. In this contribution, the influence of these parameters in the ablated mass and in the features of craters was evaluated in polypropylene and high density polyethylene plates containing pigment-based PbCrO4. Surface characterization and craters profile were carried out by perfilometry and scanning electron microscopy. Area, volume and profile of craters were obtained using Taylor Map software. A laser induced breakdown spectroscopy system consisted of a Q-Switched Nd:YAG laser (1064 nm, 5 ns) and an Echelle spectrometer equipped with ICCD detector were used. The evaluated operating conditions consisted of 10, 25 and 50 laser pulses at 1, 5 and 10 Hz, 250 mJ/pulse (85 J cm(-2)), 2 mu s delay time and 6 mu s integration time gate. Differences in the topographical features among craters of both polymers were observed. The decrease in the repetition rate resulted in irregular craters and formation of edges, especially in polypropylene sample. The differences in the topographical features and ablated masses were attributed to the influence of the degree of crystallinity, crystalline melting temperature and glass transition temperature in the ablation process of the high density polyethylene and polypropylene. It was also observed that the intensities of chromium and lead emission signals obtained at 10 Hz were two times higher than at 5 Hz by keeping the number of laser pulses constant. (C) 2011 Elsevier B. V. All rights reserved.

Low resolution structural characterization of the Hsp70-interacting protein - Hip - from Leishmania braziliensis emphasizes its high asymmetry

The Hsp70 is an essential molecular chaperone in protein metabolism since it acts as a pivot with other molecular chaperone families. Several co-chaperones act as regulators of the Hsp70 action cycle, as for instance Hip (Hsp70-interacting protein). Hip is a tetratricopeptide repeat protein (TPR) that interacts with the ATPase domain in the Hsp70-ADP state, stabilizing it and preventing substrate dissociation. Molecular chaperones from protozoans, which can cause some neglected diseases, are poorly studied in terms of structure and function. Here, we investigated the structural features of Hip from the protozoa Leishmania braziliensis (LbHip), one of the causative agents of the leishmaniasis disease. LbHip was heterologously expressed and purified in the folded state, as attested by circular dichroism and intrinsic fluorescence emission techniques. LbHip forms an elongated dimer, as observed by analytical gel filtration chromatography, analytical ultracentrifugation and small angle X-ray scattering (SAXS). With the SAXS data a low resolution model was reconstructed, which shed light on the structure of this protein, emphasizing its elongated shape and suggesting its domain organization. We also investigated the chemical-induced unfolding behavior of LbHip and two transitions were observed. The first transition was related to the unfolding of the TPR domain of each protomer and the second transition of the dimer dissociation. Altogether. LbHip presents a similar structure to mammalian Hip, despite their low level of conservation, suggesting that this class of eukaryotic protein may use a similar mechanism of action. (C) 2012 Elsevier Inc. All rights reserved.

Food-Retail Development and the Myth of Everyday Low Prices: The Case of Brazil

This article analyses the changes in Brazilian food retailing by investigating the co-existence of, and the pricing variation across, large supermarket chains and small independent supermarkets. It uses cointegration tests to show that, despite the widespread belief that small supermarkets are inefficient and charge higher prices, they in fact charge lower prices. Accordingly, in contrast to the prevailing literature on food-retail development, competition in food retail is complex and cannot be described as a simple Darwinian process of market concentration. The article explores the survival of small retail and its consequences for the current discussion on modern food retail in developing countries.

Searching for chronic hepatitis B patients in a low prevalence area – role of racial origin

Abstract Background Clinical studies for testing new drugs against hepatitis B ought to be carried out in low prevalence areas despite difficulties on patient recruitment. In such areas, relatives of chronic hepatitis B patients are considered to be at risk of acquiring the hepatitis B virus (HBV). The aim of this study was to evaluate the prevalence of HBV markers (anti-HBc, HBsAg and anti-HBs) in familial members of chronic hepatitis B (CHB) patients according to their origin (Asian or Western) in a low prevalence area, the city of São Paulo, Brazil. Methods Twenty three Asian CHB probands and their 313 relatives plus 31 CHB probands of Western origin and their 211 relatives were screened for HBV serological markers; the study was carried out in the outpatient clinic of the University of São Paulo School of Medicine. Results Mother to child transmission was greater in the Asian group whereas sexual transmission was more frequent in the Western group (p < 0.0001). Anti-HBc was positive in 90% and 57% of the Asian and Western parents (p = 0.0432) and in 97% and 33% of the Asian and Western brothers (p = 0.0001), respectively. HBsAg was more frequent among the Asian (66%) than the Western (15%) mothers (p = 0.0260) as well as among the Asian (81%) than the Western (19%) brothers (p = 0.0001). We could detect 110 new HBsAg-positive subjects related to the 54 index patients, being the majority (81%) of Asian origin. Conclusion In low prevalence area of hepatitis B, family members and household contacts of chronic HBV carriers are at high risk for acquiring hepatitis B.