Lean diesel technology and human health: a case study in six Brazilian metropolitan regions

OBJECTIVE: Due to their toxicity, diesel emissions have been submitted to progressively more restrictive regulations in developed countries. However, in Brazil, the implementation of the Cleaner Diesel Technologies policy (Euro IV standards for vehicles produced in 2009 and low-sulfur diesel with 50 ppm of sulfur) was postponed until 2012 without a comprehensive analysis of the effect of this delay on public health parameters. We aimed to evaluate the impact of the delay in implementing the Cleaner Diesel Technologies policy on health indicators and monetary health costs in Brazil. METHODS: The primary estimator of exposure to air pollution was the concentration of ambient fine particulate matter (particles with aerodynamic diameters, <2.5 mu m, [PM2.5]). This parameter was measured daily in six Brazilian metropolitan areas during 2007-2008. We calculated 1) the projected reduction in the PM2.5 that would have been achieved if the Euro IV standards had been implemented in 2009 and 2) the expected reduction after implementation in 2012. The difference between these two time curves was transformed into health outcomes using previous dose-response curves. The economic valuation was performed based on the DALY (disability-adjusted life years) method. RESULTS: The delay in implementing the Cleaner Diesel Technologies policy will result in an estimated excess of 13,984 deaths up to 2040. Health expenditures are projected to be increased by nearly US$ 11.5 billion for the same period. CONCLUSIONS: The present results indicate that a significant health burden will occur because of the postponement in implementing the Cleaner Diesel Technologies policy. These results also reinforce the concept that health effects must be considered when revising fuel and emission policies.

Catch-up growth in children after repair of Tetralogy of Fallot

Purpose: To evaluate the growth of children after repair of Tetralogy of Fallot, as well as the influence of residual lesions and socio-economic status. Methods: A total of 17 children, including 10 boys with a median age of 16 months at surgery, were enrolled in a retrospective cohort, in a tertiary care university hospital. Anthropometric (as z-scores), clinical, nutritional, and social data were collected. Results: Weight-for-age and weight-for-height z-scores decreased pre-operatively and recovered post-operatively in almost all patients, most markedly weight for age. Weight-for-height z-scores improved, but were still lower than birth values in the long term. Long-term height-for-age z-scores were higher than those at birth, surgery, and 3 months post-operatively. Most patients showed catch-up growth for height for age (70%), weight for age (82%), and weight for height (70%). Post-operative residual lesions (76%) influenced weight-for-age z-scores. Despite the fact that most patients (70%) were from low-income families, energy intake was above the estimated requirement for age and gender in all but one patient. There was no influence of socio-economic status on pre- and post-operative growth. Bone age was delayed and long-term-predicted height was within mid-parental height limits in 16 children (93%). Conclusion: Children submitted to Tetralogy of Fallot repair had pre-operative acute growth restriction and showed post-operative catch-up growth for weight and height. Acute growth restriction could still be present in the long term.

The CUPID (Cultural and Psychosocial Influences on Disability) Study: Methods of Data Collection and Characteristics of Study Sample

Background: The CUPID (Cultural and Psychosocial Influences on Disability) study was established to explore the hypothesis that common musculoskeletal disorders (MSDs) and associated disability are importantly influenced by culturally determined health beliefs and expectations. This paper describes the methods of data collection and various characteristics of the study sample. Methods/Principal Findings: A standardised questionnaire covering musculoskeletal symptoms, disability and potential risk factors, was used to collect information from 47 samples of nurses, office workers, and other (mostly manual) workers in 18 countries from six continents. In addition, local investigators provided data on economic aspects of employment for each occupational group. Participation exceeded 80% in 33 of the 47 occupational groups, and after pre-specified exclusions, analysis was based on 12,426 subjects (92 to 1018 per occupational group). As expected, there was high usage of computer keyboards by office workers, while nurses had the highest prevalence of heavy manual lifting in all but one country. There was substantial heterogeneity between occupational groups in economic and psychosocial aspects of work; three-to fivefold variation in awareness of someone outside work with musculoskeletal pain; and more than ten-fold variation in the prevalence of adverse health beliefs about back and arm pain, and in awareness of terms such as "repetitive strain injury" (RSI). Conclusions/Significance: The large differences in psychosocial risk factors (including knowledge and beliefs about MSDs) between occupational groups should allow the study hypothesis to be addressed effectively.

An economic evaluation of antihypertensive therapies based on clinical trials

OBJECTIVE: Hypertension is a major issue in public health, and the financial costs associated with hypertension continue to increase. Cost-effectiveness studies focusing on antihypertensive drug combinations, however, have been scarce. The cost-effectiveness ratios of the traditional treatment (hydrochlorothiazide and atenolol) and the current treatment (losartan and amlodipine) were evaluated in patients with grade 1 or 2 hypertension (HT1-2). For patients with grade 3 hypertension (HT3), a third drug was added to the treatment combinations: enalapril was added to the traditional treatment, and hydrochlorothiazide was added to the current treatment. METHODS: Hypertension treatment costs were estimated on the basis of the purchase prices of the antihypertensive medications, and effectiveness was measured as the reduction in systolic blood pressure and diastolic blood pressure (in mm Hg) at the end of a 12-month study period. RESULTS: When the purchase price of the brand-name medication was used to calculate the cost, the traditional treatment presented a lower cost-effectiveness ratio [US$/mm Hg] than the current treatment in the HT1-2 group. In the HT3 group, however, there was no difference in cost-effectiveness ratio between the traditional treatment and the current treatment. The cost-effectiveness ratio differences between the treatment regimens maintained the same pattern when the purchase price of the lower-cost medication was used. CONCLUSIONS: We conclude that the traditional treatment is more cost-effective (US$/mm Hg) than the current treatment in the HT1-2 group. There was no difference in cost-effectiveness between the traditional treatment and the current treatment for the HT3 group.

Comparison of extraction and transesterification methods on the determination of the fatty acid contents of three Brazilian seaweed species

Seaweeds are photosynthetic organisms important to their ecosystem and constitute a source of compounds with several different applications in the pharmaceutical, cosmetic and biotechnology industries, such as triacylglycerols, which can be converted to fatty acid methyl esters that make up biodiesel, an alternative source of fuel applied in economic important areas. This study evaluates the fatty acid profiles and concentrations of three Brazilian seaweed species, Hypnea musciformis (Wulfen) J.V. Lamouroux (Rhodophya), Sargassum cymosum C. Agardh (Heterokontophyta), and Ulva lactuca L. (Chlorophyta), comparing three extraction methods (Bligh & Dyer - B&D; AOAC Official Methods - AOM; and extraction with methanol and ultrasound - EMU) and two transesterification methods (7% BF3 in methanol - BF3; and 5% HCl in methanol - HCl). The fatty acid contents of the three species of seaweeds were significantly different when extracted and transesterified by the different methods. Moreover, the best method for one species was not the same for the other species. The best extraction and transesterification methods for H. musciformis, S. cymosum and U. lactuca were, respectively, AOM-HCl, B&D-BF3 and B&D-BF3/B&D-HCl. These results point to a matrix effect and the method used for the analysis of the fatty acid content of different organisms should be selected carefully.