Using occupancy models to investigate space partitioning between two sympatric large predators, the jaguar and puma in central Brazil

Coexistence of sympatric species is mediated by resource partitioning. Pumas occur sympatrically with jaguars throughout most of the jaguar's range but few studies have investigated space partitioning between both species. Here, camera trapping and occupancy models accounting for imperfect detection were employed in a Bayesian framework to investigate space partitioning between the jaguar and puma in Emas National Park (ENP), central Brazil. Jaguars were estimated to occupy 54.1% and pumas 39.3% of the sample sites. Jaguar occupancy was negatively correlated with distance to water and positively correlated with the amount of dense habitat surrounding the camera trap. Puma occupancy only showed a weak negative correlation with distance to water and with jaguar presence. Both species were less often present at the same site than expected under independent distributions. Jaguars had a significantly higher detection probability at cameras on roads than at off-road locations. For pumas, detection was similar on and off-road. Results indicate that both differences in habitat use and active avoidance shape space partitioning between jaguars and pumas in ENP. Considering its size, the jaguar is likely the competitively dominant of the two species. Owing to its habitat preferences, suitable jaguar habitat outside the park is probably sparse. Consequently, the jaguar population is likely largely confined to the park, while the puma population is known to extend into ENP's surroundings. (C) 2011 Deutsche Gesellschaft fur Saugetierkunde. Published by Elsevier GmbH. All rights reserved.

A method to investigate the shrinkage stress developed by resin-composites bonded to a single flat surface

Objectives. To purpose a method for predicting the shrinkage stress development in the adhesive layer of resin-composite cylinders that shrink bonded to a single flat surface, by measuring the deflection of a glass coverslip caused by the shrinkage of the bonded cylinders. The correlation between the volume of the bonded resin-composite and the stress-peak was also investigated. Methods. A glass coverslip deflection caused by the shrinkage of a bonded resin-composite cylinder (diameter: d = 8 mm, 4 mm, or 2 mm, height: h = 4 mm, 2 mm, 1 mm, or 0.5 mm) was measured, and the same set-up was simulated by finite element analysis (3D-FEA). Stresses generated in the adhesive layer were plotted versus two geometric variables of the resin-composite cylinder (C-Factor and volume) to verify the existence of correlations between them and stresses. Results. The FEA models were validated. A significant correlation (p < 0.01, Pearson's test) between the stress-peak and the coverslip deflection when the resin-composites were grouped by diameter was found for diameters of 2 and 4 mm. The stress-peak of the whole set of data showed a logarithmic correlation with the bonded resin-composite volume (p < 0.001, Pearson's test), but did not correlate with the C-Factor. Significance. The described method should be considered for standardizing the stress generated by the shrinkage of resin-composite blocks bonded to a single flat surface. (C) 2012 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.