U-Pb zircon in situ dating with LA-MC-ICP-MS using a mixed detector configuration

The LA-MC-ICP-MS method applied to U-Pb in situ dating is still rapidly evolving due to improvements in both lasers and ICP-MS. To test the validity and reproducibility of the method, 5 different zircon samples, including the standard Temora-2, ranging in age between 2.2 Ga and 246 Ma, were dated using both LA-MC-ICP-MS and SHRIMP. The selected zircons were dated by SHRIMP and, after gentle polishing, the laser spot was driven to the same site or on the same zircon phase with a 213 nm laser microprobe coupled to a multi-collector mixed system. The data were collected with a routine spot size of 25 μm and, in some cases, of 15 and 40 μm. A careful cross-calibration using a diluted U-Th-Pb solution to calculate the Faraday reading to counting rate conversion factors and the highly suitable GJ-1 standard zircon for external calibrations were of paramount importance for obtaining reliable results. All age results were concordant within the experimental errors. The assigned age errors using the LA-MC-ICP-MS technique were, in most cases, higher than those obtained by SHRIMP, but if we are not faced with a high resolution stratigraphy, the laser technique has certain advantages.

U-Pb dating by zircon dissolution method using chemical abrasion

Chemical abrasion was carried out on zircons grains of the Temora II standard for U-Pb dating prior to analyses using in situ Laser Ablation-MultiCollector Ion Coupled Plasma Mass Spectrometer (LA-ICPMS) followed by the Isotope Dissolution Thermal Ionization Mass Spectrometer (ID-TIMS) method. The proposed methodology was herein applied in order to reduce primarily the effects of secondary Pb loss, the presence of common lead and/or silicate impurities. Nine Temora II zircon grains were analyzed by the laser ablation method yielding an age of 418.3±4.3 Ma. Zircon grains of a same population were separated for chemical abrasion before dissolution and mass spectrometry analyses. Six fractions of them were separated for isotope dissolution using 235U-205Pb mixed spike after we have checked and assured the laboratory conditions of low blank values for total Pb of less than 2 pg/g. The obtained U-Pb zircon age by the ID-TIMS method was 415.7±1.8 Ma (error 0.43 %) based on four successful determinations. The results are consistent with the published ages for the Temora diorite (Temora I â 416.75±1.3 Ma; Temora II â 416.78±0.33 Ma) and established as 416±0.33 Ma. The technique is thus recommended for high precision U-Pb zircon analyses (error < 1 %), mainly for high resolution stratigraphic studies of Phanerozoic sequences.

Atributos de solos hidromórficos no Pantanal Norte Matogrossense

Os solos hidromórficos, comuns na Amazônia e no Pantanal, estão sujeitos à alternância natural de períodos de alagamento e secamento, que conduzem a uma formação e características diferenciadas. Estes solos guardam estreita relação com a natureza do material de origem e com os processos de deposição e sedimentação. O objetivo neste trabalho foi avaliar as características químicas, morfológicas e mineralógicas de três perfis de solos do Pantanal Norte Matogrossense (Planossolo, Plintossolo e Gleissolo), a fim de interpretar as relações entre suas propriedades e o ambiente em que foram formados. Os Planossolos e Gleissolos possuem maior fertilidade natural, evidenciada pelos valores expressivos de CTC (capacidade de troca de cátions) e saturação por bases. Os menores teores de Fe2O3 do Planossolo estão relacionados com a redução e remoção do Fe durante sua gênese A mineralogia da fração areia dos solos é constituída principalmente de quartzo, nódulos e concreções de Fe e de Mn, e em menor grau, biotita, muscovita e traços de turmalina, magnetita, ilmenita, epídoto, zircão e rutilo. Os solos apresentaram perfil mineralógico semelhante na fração argila, constituído por caulinita, esmectita, ilita e interestratificados do tipo ilita-esmectita. A mineralogia da fração argila dos solos foi compatível com as diferenças químicas constatadas entre eles, pois o Planossolo apresentou argila de maior atividade relativa às esmectitas e interestratificados ilita/esmectita, com maior soma de bases trocáveis e CTC, enquanto o Plintossolo e o Gleissolo, cujo mineral predominante foi a caulinita, apresentaram baixo teor de bases trocáveis e menor CTC.