Produção de milho adubado residualmente com composto de lodo de esgoto e fosfato de Gafsa

Objetivou-se, com este trabalho, avaliar o efeito residual da adubação com composto de lodo de esgoto e fosfato natural de Gafsa sobre os teores de nutrientes no solo, na planta e na produtividade do milho. O trabalho foi realizado em Cambissolo Háplico. Os tratamentos, em esquema fatorial 2 x 4, corresponderam a 2 doses de fosfato de Gafsa (0 e 90 kg ha-1 de P2O5) e 4 doses de composto de lodo de esgoto (0; 25; 50 e 75 t ha-1, em base seca). O delineamento experimental utilizado foi em blocos casualizados, com 3 repetições. Em geral, a produtividade e os teores de nutrientes no solo e na planta no segundo cultivo sucessivo de milho não foram influenciados pela adubação com fosfato natural reativo. Entretanto, a produtividade de milho e os teores de nutrientes no solo e nas folhas de milho aumentaram com a dose de composto de lodo de esgoto ao solo, sendo a dose de 75 Mg ha-1, a de maior efeito residual. A produtividade do milho é menor no segundo cultivo sucessivo em razão do empobrecimento do solo em fósforo e potássio, recomendando-se novas adubações com lodo de esgoto, a cada cultivo realizado.

Effects of the extraction conditions on the yield and composition of rice bran oil extracted with ethanol-A response surface approach

Rice bran oil was obtained from rice bran by solvent extraction using ethanol. The influence of process variables, solvent hydration (0-24% of water, on mass basis), temperature (60-90 degrees C), solvent-to-rice bran mass ratio (2.5:1 to 4.5:1) and stirrer speed (100-250 rpm) were analysed using the response surface methodology. The extraction yield was highly affected by the solvent water content, and it varied from 8.56 to 20.05 g of oil/100 g of fresh rice bran (or 42.7-99.9% of the total oil available) depending on the experimental conditions. It was observed that oryzanol and tocols behave in different ways during the extraction process. A larger amount of tocols is extracted from the solid matrix in relation to gamma-oryzanol. It was possible to obtain values from 123 to 271 mg of tocols/kg of fresh rice bran and 1527 to 4164 mg of oryzanol/kg of fresh rice bran, indicating that it is feasible to obtain enriched oil when this renewable solvent is used. No differences in the chemical composition of the extracted oils were observed when compared to the data cited in the literature. (C) 2011 The Institution of Chemical Engineers. Published by Elsevier B.V. All rights reserved.

Hydrothermal pretreatment of sugarcane bagasse using response surface methodology improves digestibility and ethanol production by SSF

Sugarcane bagasse was characterized as a feedstock for the production of ethanol using hydrothermal pretreatment. Reaction temperature and time were varied between 160 and 200A degrees C and 5-20 min, respectively, using a response surface experimental design. The liquid fraction was analyzed for soluble carbohydrates and furan aldehydes. The solid fraction was analyzed for structural carbohydrates and Klason lignin. Pretreatment conditions were evaluated based on enzymatic extraction of glucose and xylose and conversion to ethanol using a simultaneous saccharification and fermentation scheme. SSF experiments were conducted with the washed pretreated biomass. The severity of the pretreatment should be sufficient to drive enzymatic digestion and ethanol yields, however, sugars losses and especially sugar conversion into furans needs to be minimized. As expected, furfural production increased with pretreatment severity and specifically xylose release. However, provided that the severity was kept below a general severity factor of 4.0, production of furfural was below an inhibitory concentration and carbohydrate contents were preserved in the pretreated whole hydrolysate. There were significant interactions between time and temperature for all the responses except cellulose digestion. The models were highly predictive for cellulose digestibility (R (2) = 0.8861) and for ethanol production (R (2) = 0.9581), but less so for xylose extraction. Both cellulose digestion and ethanol production increased with severity, however, high levels of furfural generated under more severe pretreatment conditions favor lower severity pretreatments. The optimal pretreatment condition that gave the highest conversion yield of ethanol, while minimizing furfural production, was judged to be 190A degrees C and 17.2 min. The whole hydrolysate was also converted to ethanol using SSF. To reduce the concentration of inhibitors, the liquid fraction was conditioned prior to fermentation by removing inhibitory chemicals using the fungus Coniochaeta ligniaria.