Influence of a narrow depth gradient and season on the morphology, phenology, and epibiosis of the brown alga Sargassum cymosum

Temporal and spatial fluctuations of environmental parameters are normally assigned as causes of variations in morpho-phenological characters of seaweeds and in their epibionts, but formal tests of such hypotheses are lacking, especially in narrow gradients. The present study evaluated the influence of a very small depth gradient (1 to 3 m) and of subtle seasonality characteristic of tropical areas on morpho-phenological traits and on the occurrence of sessile epiphytic organisms using a controlled orthogonal sampling design in a sublittoral population of the tropical brown alga Sargassum cymosum. Four temporal samples were obtained over a one-year period at three depths using nine replicates. The wet weight, maximum length, number of primary and secondary branches, and proportion of secondary branches with receptacles were recorded. Epibiosis was estimated by visual evaluation of percentage cover on secondary branches. Algal morphology varied as a function of the period of the year (weaker effect) and depth (stronger effect) but in different ways for each variable analysed. In general, fronds tended to be shorter, heavier, and more ramified in shallower areas. In relation to time, the morphological characters tended mostly to present higher values in January (summer) and/or April (autumn). Frequency of receptacles did not depend on algal morphology and depth at all but varied in time, although only in the deepest area. Epibiosis also did not depend on algal morphology but varied in relation to time (stronger effect) and, to a lesser extent, depth (weaker effect). The effect of time upon epibiosis also depended on the biological group analysed. These data support the hypothesis that algal morphology varies in relation to period of the year and depth, even under small temporal and spatial environmenal gradients.

Potential impacts of polar fronts on sedimentation processes at Abrolhos coral reef (South-West Atlantic Ocean/Brazil)

Several reefs of the world have undergone changes in community due to sedimentation processes. It has been suggested that Abrolhos reefs (Brazil/South-West Atlantic) are subjected to a steady coastal influence, although there is still little information regarding this assumption. In this work, we have analyzed a set of environmental parameters concerning sedimentation characteristics at the Abrolhos reefs, near 18 degrees S-39 degrees W. The analysis included remote sensing, model and in situ data to provide a three-dimensional quantitative description of the processes that influence sediment apportionment to the reefs. Mineralogy and natural radioactivity of sediment trapped at three reef sites in a transect perpendicular to the coastline were used in conjunction with numerical weather prediction model and remote sensing databases. We have observed an increase of around 100% of sediment flux during the summer compared to the winter season. A comparison of regional rainfall regime, sediment plume dynamics and a year-around monitoring of polar fronts trajectories and surface wind showed that the wind-driven resedimentation due to polar front activity is the major contributor to the intensification of sedimentation processes at the offshore area of Abrolhos reefs, despite river runoff from mainland. (C) 2007 Elsevier Ltd. All rights reserved.

Extensive Rhodolith Beds Cover the Summits of Southwestern Atlantic Ocean Seamounts

Calcium carbonate production by marine organisms is an essential process in the global budget of CO32-, and coralline reefs are the most important benthic carbonate producers. Crustose coralline algae (CCA) are well recognized as the most important carbonate builders in the tropical Brazilian continental shelf, forming structural reefs and extensive rhodolith beds. However, the distribution of CCA beds, as well as their role in CO32- mineralization in mesophotic communities and isolated carbonate banks, is still poorly known. To characterize the bottom features of several seamount summits in the Southwestern Atlantic (SWA), side-scan sonar records, remotely operated vehicle imagery, and benthic samples with mixed-gas scuba diving were acquired during two recent research cruises (March 2009 and February 2011). The tops of several seamounts within this region are relatively shallow (similar to 60 m), flat, and dominated by rhodolith beds (Vitoria, Almirante Saldanha, Davis, and Jaseur seamounts, as well as the Trindade Island shelf). On the basis of abundance, dimensions, vitality, and growth rates of CCA nodules, a mean CaCO3 production was estimated, ranging from 0.4 to 1.8 kg m(-2) y(-1) with a total production reaching 1.5 x 10(-3) Gt y(-1). Our results indicate that these SWA seamount summits provide extensive areas of shallow reef area and represent 0.3% of the world's carbonate banks. The importance of this habitat has been highly neglected, and immediate management needs must be fulfilled in the short term to ensure long-term persistence of the ecosystem services provided by these offshore carbonate realms.

A method to investigate the shrinkage stress developed by resin-composites bonded to a single flat surface

Objectives. To purpose a method for predicting the shrinkage stress development in the adhesive layer of resin-composite cylinders that shrink bonded to a single flat surface, by measuring the deflection of a glass coverslip caused by the shrinkage of the bonded cylinders. The correlation between the volume of the bonded resin-composite and the stress-peak was also investigated. Methods. A glass coverslip deflection caused by the shrinkage of a bonded resin-composite cylinder (diameter: d = 8 mm, 4 mm, or 2 mm, height: h = 4 mm, 2 mm, 1 mm, or 0.5 mm) was measured, and the same set-up was simulated by finite element analysis (3D-FEA). Stresses generated in the adhesive layer were plotted versus two geometric variables of the resin-composite cylinder (C-Factor and volume) to verify the existence of correlations between them and stresses. Results. The FEA models were validated. A significant correlation (p < 0.01, Pearson's test) between the stress-peak and the coverslip deflection when the resin-composites were grouped by diameter was found for diameters of 2 and 4 mm. The stress-peak of the whole set of data showed a logarithmic correlation with the bonded resin-composite volume (p < 0.001, Pearson's test), but did not correlate with the C-Factor. Significance. The described method should be considered for standardizing the stress generated by the shrinkage of resin-composite blocks bonded to a single flat surface. (C) 2012 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Twinlike models for kinks and compactons in flat and warped spacetime

This work deals with the presence of twinlike models in scalar field theories. We show how to build distinct scalar field theories having the same extended solution, with the same energy density and linear stability. Here, however, we start from a given but generalized scalar field theory, and we construct the corresponding twin model, which also engenders generalized dynamics. We investigate how the twinlike models arise in both flat and curved spacetimes. In the curved spacetime, we consider a braneworld model with the warp factor controlling the spacetime geometry with a single extra dimension of infinite extent. In particular, we study linear stability in both flat and curved spacetimes, and in the case of curved spacetime-in both the gravity and the scalar field sectors-for the two braneworld models. DOI: 10.1103/PhysRevD.86.125021

Film based on Y2O3: Eu3+ (5 mol% of Eu3+) for flat panel display

This paper reports on Y2O3:Eu3+ containing 1 mol% of Ag-0 nanoparticle films recovered with a SiO2 layer by using glass foil as a substrate for a possible optical display device application. The obtained film showed an intense emission at 612 nm due to the Eu3+ 5D0 -> F-7(2) hypersensitive transition, a high transmittance in that emission range, an excellent optical quality, and a high absorption only below 300 nm. Moreover, despite the presence of the SiO2 layer used to improve the phosphor adhesion on Corning (R) foil substrates, the intensity ratios between the emissions assigned to Eu3+ D-5(0) -> F-7(2) (dipole electric transition) and D-5(0) -> F-7(1) (dipole magnetic transition) were not affected by it. The x and y coordinate values found in the 1931 Commission Internationale de l'Eclairage Chromaticity Diagram for this film reveal that it has a suitable pure red color emission for optical displays devices. (C) 2012 Elsevier B. V. All rights reserved.

COMPARISON OF DIFFERENT PROTOCOLS FOR THE EXTRACTION OF MICROBIAL DNA FROM REEF CORALS

This study aimed to test different protocols for the extraction of microbial DNA from the coral Mussismilia harttii. Four different commercial kits were tested, three of them based on methods for DNA extraction from soil (FastDNA SPIN Kit for soil, MP Bio, PowerSoil DNA Isolation Kit, MoBio, and ZR Soil Microbe DNA Kit, Zymo Research) and one kit for DNA extraction from plants (UltraClean Plant DNA Isolation Kit, MoBio). Five polyps of the same colony of M. harttii were macerated and aliquots were submitted to DNA extraction by the different kits. After extraction, the DNA was quantified and PCR-DGGE was used to study the molecular fingerprint of Bacteria and Eukarya. Among the four kits tested, the ZR Soil Microbe DNA Kit was the most efficient with respect to the amount of DNA extracted, yielding about three times more DNA than the other kits. Also, we observed a higher number and intensities of DGGE bands for both Bacteria and Eukarya with the same kit. Considering these results, we suggested that the ZR Soil Microbe DNA Kit is the best adapted for the study of the microbial communities of corals.

Comparison of different protocols for the extraction of microbial DNA from reef corals

This study aimed to test different protocols for the extraction of microbial DNA from the coral Mussismilia harttii. Four different commercial kits were tested, three of them based on methods for DNA extraction from soil (FastDNA SPIN Kit for soil, MP Bio, PowerSoil DNA Isolation Kit, MoBio, and ZR Soil Microbe DNA Kit, Zymo Research) and one kit for DNA extraction from plants (UltraClean Plant DNA Isolation Kit, MoBio). Five polyps of the same colony of M. harttii were macerated and aliquots were submitted to DNA extraction by the different kits. After extraction, the DNA was quantified and PCR-DGGE was used to study the molecular fingerprint of Bacteria and Eukarya. Among the four kits tested, the ZR Soil Microbe DNA Kit was the most efficient with respect to the amount of DNA extracted, yielding about three times more DNA than the other kits. Also, we observed a higher number and intensities of DGGE bands for both Bacteria and Eukarya with the same kit. Considering these results, we suggested that the ZR Soil Microbe DNA Kit is the best adapted for the study of the microbial communities of corals.