Assessment and management of oral health in liver transplant candidates

Liver transplantation has become a standard treatment for end-stage liver disease and the number of recipients has grown rapidly in the last few years. Dental care during pre-transplant workup is important to reduce potential sources of infection in the drug-induced immunosuppression phase of liver transplantation. Objectives: The objectives of this study were to document the prevalence of oral abnormalities in patients on a liver transplant waiting list presenting to an urban dental school clinic, discuss the appropriate dental treatment according their systemic conditions and compare their oral manifestations with those of healthy individuals. Material and Methods: A pilot study was conducted involving 16 end-stage liver disease individuals (study group- SG) attending the Special Care Dentistry Center of the University of So Paulo and 16 control individuals (control group- CG) with no liver diseases, receiving dental care at the Dental School of the University of So Paulo. These individuals were assessed for their dental status (presence of oral disease or abnormalities), coagulation status, and dental treatment indications. Results: The patients from SG exhibited a greater incidence of oral manifestations compared with CG (p=0.0327) and were diagnosed with at least one oral disease or condition that required treatment. Coagulation abnormalities reflecting an increased risk of bleeding were found in 93.75% of the patients. However, no bleeding complications occurred after dental treatment. Conclusions: The patients with chronic liver diseases evaluated in this study exhibited a higher incidence of oral manifestations compared with the control group and had at least one oral disease or abnormality which required dental treatment prior to liver transplantation. Careful oral examination and evaluation of the patient, including laboratory tests, will ensure correct oral preparation and control of oral disease prior to liver transplantation.

Effect of light sources and curing mode techniques on sorption, solubility and biaxial flexural strength of a composite resin

Adequate polymerization plays an important role on the longevity of the composite resin restorations. Objectives: The aim of this study was to evaluate the effect of light-curing units, curing mode techniques and storage media on sorption, solubility and biaxial flexural strength (BFS) of a composite resin. Material and Methods: Two hundred and forty specimens were made of one composite resin (Esthet-X) in a stainless steel mold (2 mm x 8 mm 0), and divided into 24 groups (n=10) established according to the 4 study factors: light-curing units: quartz tungsten halogen (QTH) lamp and light-emitting diodes (LED); energy densities: 16 J/cm(2) and 20 J/cm(2); curing modes: conventional (CM) and pulse-delay (PD); and permeants: deionized water and 75% ethanol for 28 days. Sorption and solubility tests were performed according to ISO 4049:2000 specifications. All specimens were then tested for BFS according to ASTM F394-78 specification. Data were analyzed by three-way ANOVA followed by Tukey, Kruskal-Wallis and Mann-Whitney tests (alpha=0.05). Results: In general, no significant differences were found regarding sorption, solubility or BFS means for the light-curing units and curing modes (p>0.05). Only LED unit using 16 J/cm(2) and PD using 10 s produced higher sorption and solubility values than QTH. Otherwise, using CM (16 J/cm(2)), LED produced lower values of BFS than QTH (p<0.05). 75% ethanol permeant produced higher values of sorption and solubility and lower values of BFS than water (p<0.05). Conclusion: Ethanol storage media produced more damage on composite resin than water. In general the LED and QTH curing units using 16 and 20 J/cm(2) by CM and PD curing modes produced no influence on the sorption, solubility or BFS of the tested resin.