Experimental investigations of heat transfer coefficients of cutting fluids in metal cutting processes: analysis of workpiece phenomena in a given case study

This paper reports an experimental method to estimate the convective heat transfer of cutting fluids in a laminar flow regime applied on a thin steel plate. The heat source provided by the metal cutting was simulated by electrical heating of the plate. Three different cooling conditions were evaluated: a dry cooling system, a flooded cooling system and a minimum quantity of lubrication cooling system, as well as two different cutting fluids for the last two systems. The results showed considerable enhancement of convective heat transfer using the flooded system. For the dry and minimum quantity of lubrication systems, the heat conduction inside the body was much faster than the heat convection away from its surface. In addition, using the Biot number, the possible models were analyzed for conduction heat problems for each experimental condition tested.

Female Sexual Function and Gestational Diabetes

Introduction. The number of women with gestational diabetes mellitus (GDM) is growing worldwide in parallel with the obesity epidemic. The diagnosis of GDM leads to substantial modifications in the daily routine of these women, and these adjustments could potentially affect their sexual function. There are no previous studies on the sexual function of patients with GDM. Aim. The aim of this study was to investigate the sexual function of patients with GDM in comparison with healthy pregnant women at the same gestational age. Methods. Brazilian women in the third trimester of pregnancy with and without GDM were invited to participate in this cross-sectional study while waiting for their antenatal care visits at a single public tertiary teaching institution between March and December 2010. The Brazilian version of the Female Sexual Function Index (FSFI) questionnaire was used to assess sexual function. Main Outcome Measures. Desire, arousal, lubrication, orgasm, sexual satisfaction, and pain during and after coitus in the last 4 weeks, measured according to a standardized and validated questionnaire. Results. A total of 87 participants were enrolled (43 healthy women and 44 with GDM). There were no significant differences in the sociodemographic characteristics of both groups. The total FSFI scores of GDM patients was 21.0 +/- 9.59 compared with 22.3 +/- 9.17 for healthy women (P = 0.523). Difficulty in desire was the most common sexual dysfunction symptom in both groups, being reported by 42% and 50% of GDM and healthy women, respectively (P = 0.585). Conclusion. The sexual function of Brazilian patients with GDM does not differ significantly from that of healthy pregnant women at the same gestational age. Ribeiro MC, Nakamura MU, Scanavino Mde T, Torloni MR, and Mattar R. Female sexual function and gestational diabetes. J Sex Med 2012; 9: 786-792.

Ultra-low friction coefficient in alumina-silicon nitride pair lubricated with water

In a ball-on-disc wear test, an alumina ceramic body sliding against a silicon nitride ceramic body in water achieved an ultra-low friction coefficient (ULFC) of 0.004. The profilometer and EDX measurements indicated that the ULFC regime in this unmated Al2O3-Si3N4 pair was achieved because of the formation of a flat and smooth interface of nanometric roughness, which favored the hydrodynamic lubrication. The triboreactions formed silicon and aluminum hydroxides which contributed to decrease roughness and shear stress at the contact interface. This behavior enables the development of low energy loss water-based tribological systems using oxide ceramics. 13 2012 Elsevier B.V. All rights reserved.

Qualitative study of young, adult, and aged wistar rats temporomandibular synovial membrane employing light, scanning, and transmission electron microscopy

The aim of this study was to analyze the rat temporomandibular joint (TMJ) synovial membrane at different ages using light, scanning, and transmission electron microscopy. Under light microscopic analysis, the TMJ structures were observed such as condyle, capsule, disk, the synovial membrane collagen type, and cells distribution. In the scanning electron microscopy, the synovial membrane surface exhibited a smooth aspect in young animals and there was an increase with ageing in the number of folds. The transmission electron microscopic analysis showed more synoviocytes in the synovial layer in the young group and still a great number of vesicles and cisterns dilation of rough endoplasmic reticulum in the aged group. In the three groups, a dense layer of collagen fibers in the synovial layer and cytoplasmic extensions were clearly seen. It was possible to conclude that synovial membrane structures in aged group showed alterations contributing to the decrease in joint lubrication and in the sliding between disk and joint surfaces. These characteristic will reflect in biomechanics of chewing, and may cause the TMJ disorders, currently observed in clinical processes. Microsc. Res. Tech. (c) 2012 Wiley Periodicals, Inc.

Friction and wear of performance of MoDTC and ester-containing lubrificants over steel surfaces under reciprocating conditions

Since the earliest developments of human history, friction has been a major issue. From the invention of the wheel and the use of the first lubricants to the studiesof coated and microtexturized surfaces, significant effort has been put on improvements that couldovercome the resistance to motion. Areview by Holmberg, Andersson and Erdemir[1] shows that, in an average passenger car, about one third of the total energy consumptionis due to friction losses. Of these, another one third is consumed in the engine system. The optimization of the lubricating oil formulation used ininternal combustion enginesis an important way to reduce friction, therefore improving energeticefficiencyand controllingemissions.Lubrication is also a way to assure the required protection to the system by maintaining wear rates in an adequate level, which helps to minimize maintenance costs.