Development of methodology for determination of pesticides residue in water by SPE/HPLC/DAD

To boost crop yield, sugarcane growers are using increasing amounts of pesticides to combat insects and weeds. But residues of these compounds can pollute water resources, such as lakes, rivers and aquifers. The present paper reports the results of a study of water samples from the Feijao River, which is the source of drinking water for the city of Sao Carlos, Sao Paulo, Brazil. The samples were evaluated for the presence of four leading pesticides - ametryn, atrazine, diuron and fipronil - used on sugarcane, the dominant culture in the region. The samples were obtained from three points along the river: the headwaters, along the middle course of the river and just before the municipal water intake station. The pesticides were extracted from the water samples by solid-phase extraction (SPE) and then analyzed by liquid chromatography with diode array detection (LC-DAD). The analytical method was validated by traditional methods, obtaining recovery values between 90 and 95%, with precision deviations inferior to 2.56%, correlation coefficients above 0.99 and detection and quantification limits varying from 0.02 to 0.05 mg L-1 and 0.07 to 0.17 mg L-1, respectively. No presence of residues of the pesticides was detected in the samples, considering the detection limits of the method employed.

Phenol biodegradation by a microbial consortium: application of artificial neural network (ANN) modelling

In this study, an effective microbial consortium for the biodegradation of phenol was grown under different operational conditions, and the effects of phosphate concentration (1.4 g L-1, 2.8 g L-1, 4.2 g L-1), temperature (25 degrees C, 30 degrees C, 35 degrees C), agitation (150 rpm, 200 rpm, 250 rpm) and pH (6, 7, 8) on phenol degradation were investigated, whereupon an artificial neural network (ANN) model was developed in order to predict degradation. The learning, recall and generalization characteristics of neural networks were studied using data from the phenol degradation system. The efficiency of the model generated by the ANN was then tested and compared with the experimental results obtained. In both cases, the results corroborate the idea that aeration and temperature are crucial to increasing the efficiency of biodegradation.

Adsorption of phosphate from aqueous solution by hydrous zirconium oxide

Synthetic ZrO2 center dot nH(2)O was used for phosphate removal from aqueous solution. The optimum adsorbent dose obtained for phosphate adsorption on to hydrous zirconium oxide was 0.1 g. The kinetic process was described very well by a pseudo-second-order rate model. The phosphate adsorption tended to increase with the decrease in pH. The adsorption capacity increased from 61 to 66 mg g(-1) when the temperature was increased from 298 to 338 K. A phosphate desorption of approximately 74% was obtained using water at pH 12.

Thermal decomposition kinetics of Brazilian limestones: effect of CO2 partial pressure

The influence of the partial pressure of carbon dioxide (CO2) on the thermal decomposition process of a calcite (CI) and a dolomite (DP) is investigated in this paper using a thermogravimetric analyser. The tests were non-isothermal at five different heating rates in dynamic atmosphere of air with 0% and 15% carbon dioxide (CO2). In the atmosphere without CO2, the average activation energies (E-alpha) were 197.4 kJ mol(-1) and 188.1 kJ mol(-1) for CI and DP, respectively. For the DP with 15% CO2, two decomposition steps were observed, indicating a change of mechanism. The values of E-alpha for 15% CO2 were 378.7 kJ mol(-1) for the CI, and 299.8 kJ mol(-1) (first decomposition) and 453.4 kJ mol(-1) (second decomposition) for the DP, showing that the determination of E-alpha for DP should in this case be considered separately in those two distinct regions. The results obtained in this study are relevant to understanding the behaviour changes in the thermal decomposition of limestones with CO2 partial pressure when applied to technologies, such as carbon capture and storage (CCS), in which carbon dioxide is present in high concentrations.

Lean diesel technology and human health: a case study in six Brazilian metropolitan regions

OBJECTIVE: Due to their toxicity, diesel emissions have been submitted to progressively more restrictive regulations in developed countries. However, in Brazil, the implementation of the Cleaner Diesel Technologies policy (Euro IV standards for vehicles produced in 2009 and low-sulfur diesel with 50 ppm of sulfur) was postponed until 2012 without a comprehensive analysis of the effect of this delay on public health parameters. We aimed to evaluate the impact of the delay in implementing the Cleaner Diesel Technologies policy on health indicators and monetary health costs in Brazil. METHODS: The primary estimator of exposure to air pollution was the concentration of ambient fine particulate matter (particles with aerodynamic diameters, <2.5 mu m, [PM2.5]). This parameter was measured daily in six Brazilian metropolitan areas during 2007-2008. We calculated 1) the projected reduction in the PM2.5 that would have been achieved if the Euro IV standards had been implemented in 2009 and 2) the expected reduction after implementation in 2012. The difference between these two time curves was transformed into health outcomes using previous dose-response curves. The economic valuation was performed based on the DALY (disability-adjusted life years) method. RESULTS: The delay in implementing the Cleaner Diesel Technologies policy will result in an estimated excess of 13,984 deaths up to 2040. Health expenditures are projected to be increased by nearly US$ 11.5 billion for the same period. CONCLUSIONS: The present results indicate that a significant health burden will occur because of the postponement in implementing the Cleaner Diesel Technologies policy. These results also reinforce the concept that health effects must be considered when revising fuel and emission policies.

Upgrading of Transmission Lines in Areas of Severe Environmental Constraints

The need for increasing the loading capacity of transmission lines in a traditional way, by replacing or reinforcement of the structures and foundations on routes crossing areas considered of permanent environmental preservation, may require additional works that alter the environment. The present rigorous environmental legislation turns these changes and substitution unfeasible. One way to increase the capacity of these lines is the use of new conductor technology. The aim of this paper is to discuss the needs for upgrading a transmission line and minimize or eliminate the damage to the environment by using special conductors. Because the aluminum conductor composite reinforced technology is relatively new and considering the lack of information related to its effective performance in practical system, there is a need to verify the behavior of these conductors through monitoring procedures.

Information-dependent processes in incubated and graduated technology-based companies: a comparative case study

Nowadays, competitiveness introduces new behaviors and leads companies to a discomforting situation and often to non adaptation to environmental requirements. A growing number of challenges associated with control of information in organizations with engineering activities can be seen, particularly, the growing amount of information subject to continuous changes. The innovative performance of an organization is directly proportional to its ability to manage information. Thus, the importance of information management is recognized by the search for more competent ways to face current demands. The purpose of this article was to analyze informationdependent processes in technology-based companies, through the four major stages of information management. The comparative method of cases and qualitative research were used. The research was conducted in nine technology-based companies which were incubated or recently went through the incubating process at the Technological Park of Sao Carlos, in the state of Sao Paulo. Among the main results, it was found that in graduated companies information management and its procedures were identified as more conscious and structured in contrast to those of the incubated companies.

Cuticle of 'Gala' and 'Galaxy' Apples Cultivars under Different Environmental Conditions

This study aimed to analyze the cuticle thickness and pattern of epicuticular wax deposition in 'Gala' and 'Galaxy' apple cultivars (Malus domestica Borkh,) from three Brazilian producing areas: Vacaria (RS), Fraiburgo (SC) and Sao Joaquim (SC) with altitudes of 971, 1,048 and 1,353m, respectively. Harvested fruit were kept under two storage conditions: regular atmosphere (RA) (0 degrees C and 90% RH) and controlled atmosphere (CA) (1.5% O-2, 2.5% CO2, 0 degrees C and 90% RH). Cuticle thickness measurements were made using LM and the deposition pattern of epicuticular wax observed with a SEM. Altitude among the apple producing areas was not a factor in deposition pattern of waxes between the cultivars but at higher altitudes, the cuticle was thicker in both the cultivars. In the freshly-harvested fruits, waxes deposition in the form of platelets and the mechanism of "tear and repair" were observed. Severity of microcracks in the cuticle was more evident on the fruits from CA.

Multi-criteria analysis in the strategic environmental assessment of the sugar and alcohol sector

The Strategic Environmental Assessment (SEA) of the sugar and alcohol sector guides a territorial and sectoral planning that benefits most of the local society and supports this economic activity in all its stages. In this way, the present work aims to determine an index of aggregation of the indicators generated in the baseline of the SEA process, called Index of Sustainability of Expansion of the Sugar and Alcohol Sector (IScana). For this, it was used the normalization of the indicators of each city by the fuzzy logic and attribution of weights by the Analytic Hierarchy Process (AHP). Then, the IScana values had been spatialized in the region of 'Grande Dourados'-Mato Grosso do Sul State. The northern portion concentrated the highest values of IScana, 0.48 and 0.55, referring to the cities of Nova Alvorada do Sul and Rio Brilhante, while, in the central portion, the city of Dourados presented the lowest value, 0.10. The selection of the set of indicators forming the IScana, and their relative importance, was satisfactory for the application of fuzzy logic and AHP techniques. The IScana index supplies objective information regarding the diagnosis of the region for the application of SEA.

Cuticle of 'Gala' and 'Galaxy' apples cultivars under different environmental conditions

This study aimed to analyze the cuticle thickness and pattern of epicuticular wax deposition in 'Gala' and 'Galaxy' apple cultivars (Malus domestica Borkh,) from three Brazilian producing areas: Vacaria (RS), Fraiburgo (SC) and São Joaquim (SC) with altitudes of 971, 1,048 and 1,353m, respectively. Harvested fruit were kept under two storage conditions: regular atmosphere (RA) (0 ºC and 90% RH) and controlled atmosphere (CA) (1.5% O2, 2.5% CO2, 0ºC and 90% RH). Cuticle thickness measurements were made using LM and the deposition pattern of epicuticular wax observed with a SEM. Altitude among the apple producing areas was not a factor in deposition pattern of waxes between the cultivars but at higher altitudes, the cuticle was thicker in both the cultivars. In the freshly-harvested fruits, waxes deposition in the form of platelets and the mechanism of tear and repair were observed. Severity of microcracks in the cuticle was more evident on the fruits from CA.