Population biology of Excirolana armata (Dana, 1853) (Isopoda, Cirolanidae) on an exposed sandy beach in Southeastern Brazil

The reproductive biology and population dynamics of the cirolanid isopod Excirolana armata (Dana, 1853) were analysed through monthly samples from December 2003 to November 2005 on Una beach, Sao Paulo state (24 degrees S), in Southeastern Brazil. Sampling was performed along three transects established from the base of foredunes to the waterline. On Una beach, E. armata showed continuous reproduction with higher abundances of ovigerous females in winter and spring (July-November) with a higher peak of juveniles in spring (November 2004). The fecundity ranged from 2 to 18 eggs/embryos per female, depending on the female length. The incubation period was estimated as 2 months. The life span of males and females was nearly 1 year. The short life span and the high energetic expenditure inherent to reproduction with maternal care, probably kept females from producing more than one brood in their lifetime. When comparing the population of E. armata on Una beach (24 degrees S) with populations in Southern Brazil (32 degrees S), Uruguay (34 degrees S) and Argentina (36 degrees S), it was verified that several biological population traits (length of the smallest juvenile, length of the largest individual, length of the smallest and largest ovigerous females, range of fecundity and life span) tended to increase at higher latitudes, whereas other traits (instantaneous rate of mortality and the curvature parameter of von Bertalanffy growth function) tended to decrease. However, comparing E. armata on Una beach (24 degrees S) with a population situated at a close latitude (25 degrees S), unexpected differences in relation to population structure and to growth demonstrated and reinforced the importance of density-dependent factors over life history traits of E. armata on dissipative beaches.

A novel spermatozoan ultrastructure in the shrimp Hippolyte obliquimanus Dana, 1852 (Decapoda: Caridea: Hippolytidae)

The aim of this study was to describe and illustrate the morphology of the spermatozoon of the Western Atlantic shrimp, Hippolyte obliquimanus. Individuals were sampled from Itagua Beach (Ubatuba, southern Brazil). The male reproductive system was dissected and morphological analysis was undertaken using a stereomicroscope, a light microscope, and transmission electron and scanning electron microscopes. When viewed from the nuclear or acrosomal poles, each spermatozoon has many translucent radiating arms (about 20) from a denser cell body, while laterally the cell body and arms resemble a "cnidarian medusa", with all the arms projecting away from the bell-like cell body. This sperm morphology is distinct from the "thumbtack"-shaped spermatozoa observed in the majority of carideans but has similarities to the spermatozoa of Rhynchocinetes spp. The morphology of sperm of several species of the genus Hippolyte resembles the spermatozoon of H. obliquimanus with the presence of posterior nuclear arms, but it is necessary to study other Hippolyte species to place these arms in the context of the genus.

Production of Excirolana armata (Dana, 1853) (Isopoda, Cirolanidae) on an exposed sandy beach in southeastern Brazil

The somatic and gonad productions of the cirolanid isopod Excirolana armata were analyzed by taking monthly samples from December 2003 to November 2005 on Una beach, So Paulo state (24A degrees S), southeastern Brazil. Sampling was performed along three fixed transects established from the base of the foredunes to the waterline. Weight-specific growth rate was used to estimate the E. armata somatic production for 2004 and 2005, separately. The gonad production was estimated based on the monthly reproductive potential (mean number of eggs/embryos per female x monthly abundance of ovigerous females with near-release broods) for 2004. The annual somatic production of E. armata population varied from 15.57 to 17.25 g AFDW m(-1) year(-1) and the somatic production/biomass ratio (P (s)/B) from 3.55 to 3.14 year(-1) for 2004 and 2005, respectively. The P (s)/B ratios were higher for males (4.02 and 3.19 year(-1) for 2004 and 2005) than for females (3.10 year(-1) for both years). The annual gonad production (P (g) = 1.07 g AFDW m(-1) year(-1)) contributed about 15 and 6% to the total production (P (s) + P (g)) of females and the population, respectively. The proportion of gonad to somatic production of females (P (g)/P (s)) increased with individual size (ca 90% in the 7.5 mm size class), and the annual weight-specific gonad production (P (g)/B ratio) was estimated to 0.24 year(-1). The high P (s)/B ratios estimated for E. armata derive from the fast growth of individuals and show the importance of this population to the energy flow on Una beach ecosystem. However, the low percentage of juveniles verified in this population and in other studies of populations of the genus Excirolana is discussed as an important source of underestimation of P (s)/B ratio.

Morphological and genetic variability in Hippolyte obliquimanus dana, 1852 (Decapoda, Caridea, Hippolytidae) from Brazil and the caribbean sea

Hippolyte obliquimanus is a marine shrimp reported from the Caribbean Sea and Brazil. The literature provides indications for morphological variation between populations from those regions and the species has a troubled taxonomic history. The aims of this study were to analyse morphological and genetic variation in the populations of H. obliquimanus from Brazil and the Caribbean Sea and to verify if those might support separation of H. obliquimanus into two or more species. This hypothesis was tested with the analysis of morphological and genetic data (mitochondrial gene 16S and the barcode region Cytochrome Oxidase I). The material analysed was obtained from samples and from loans of zoological collections. The rostrum as well as pereiopods 3, 4, and 5 were the adult morphological characters that showed variation, but this occurred in samples from both regions, Brazil and the Caribbean Sea. The sequences of the 16S gene were identical among all specimens analysed. There was, however, variation among the sequences of the barcoding gene COI (<2.0%); this divergence separated the specimens into two groups (Brazil versus the Caribbean) and these groups did not share haplotypes. In conclusion, specimens from the regions analysed showed both morphological and genetic variation, but these did not support the separation of H. obliquimanus into two or more species.

Ascensão capilar de água em substratos de coco e de pinus

O uso da irrigação por capilaridade na produção de mudas em viveiros pode trazer vantagens ao uso de água e sua utilização adequada requer o conhecimento da capacidade de ascensão de água no meio de crescimento das raízes, atributo pouco estudado. Para avaliar esta condição fundamental, este trabalho tem como objetivo avaliar a ascensão de água em substratos comerciais de coco e pinus, em dois padrões de tamanho de partículas e em duas condições de umidade, para indicar aquele que possua as melhores características físicas para aplicação na irrigação por capilaridade. Utilizou-se o método de ascensão capilar, com colunas desmontáveis de anéis preenchidas com substratos, avaliando-se os seguintes tempos de contato do fundo da coluna com a lâmina de água: 0,25, 0,5, 1, 2, 4, 8, 16 e 24 horas, com 10 repetições por tempo testado. Pelos resultados, observou-se que a maior ascensão capilar acumulada em 24 horas de ensaio foi obtida para os substratos de textura fina de coco e de pinus. Além disso, a hidrofobia do substrato de coco seco recomenda que as irrigações nesse material devem ter frequências maiores que substratos de pinus, evitando seu secamento. O substrato de pinus, por não apresentar esse comportamento, deve ter turnos de rega mais espaçados, principalmente sob textura fina. Devido à sua maior retenção de água e capacidade de elevação de água quando umedecido, o substrato fino de coco é mais adequado à irrigação por capilaridade em recipientes como tubetes.

Dinâmica do potencial matricial em substratos de pinus e coco sob ação da capilaridade

O tamanho médio de partículas e a porosidade dos substratos condicionam as propriedades matriciais, interferindo na capacidade de retenção e de transmissão da água no meio. O conhecimento desses atributos é fundamental em processos de irrigação por capilaridade, para que o molhamento atinja as camadas superiores dos recipientes com níveis de tensão de água facilmente disponível. O presente trabalho teve como objetivo estudar a ascensão de água por capilaridade para determinar a posição mais apropriada do nível de saturação na ascensão capilar em recipientes com substratos de coco e pinus, de textura grossa e fina. Foram efetuados experimentos avaliando a ascensão de água por capilaridade em colunas segmentadas preenchidas com os substratos. Os valores de umidade em cada segmento foram calculados gravimetricamente e relacionados aos de tensão estimados pela curva de tensão dos substratos. Os substratos com textura fina apresentaram melhor elevação de água por capilaridade, com melhor elevação da umidade em níveis de tensão de água disponível. O substrato de coco fino apresentou água disponível em todo o perfil do recipiente, enquanto o de pinus apresentou as camadas superiores do recipiente com água retida em tensões abaixo do ponto de murcha permanente. O substrato fino de coco apresentou os melhores resultados para aplicação na irrigação por capilaridade, permitindo recomendar o seu uso com o nível de saturação posicionado a cinco centímetros do fundo do recipiente por quinze minutos.