Bills Favor Mining and Threaten Conservation of Brazilian Merganser (Mergus octosetaceus) at Serra da Canastra National Park, Minas Gerais, Brazil

Serra da Canastra National Park (SCNP) is one of the most important protected areas in the Cerrado biome. Despite its importance to the conservation of rare and endangered species like Brazilian Merganser, two bills were approved in 2010 by Brazil's Chamber of Deputies aiming to reduce SCNP's official boundaries and to transform some of its parts into an Environmental Protection Area (EPA). We evaluated whether such changes would facilitate mining areas to be legally exploited within the park's area, and if those mining areas would represent a threat to Brazilian Merganser populations at SCNP. Results showed that 55% of the mining areas currently within the National Park will be located within the new EPA, and six hydrographic micro-basins inhabited by Brazilian Merganser could be affected by environmental impacts caused by mineral exploitation in those areas. For these reasons, we recommend the two bills be refused at the Federal Senate.

New Species of the Thorny Catfish Genus Leptodoras (Siluriformes: Doradidae) from Rio Fresco, Xingu Basin, Brazil

A new species of the thorny catfish genus Leptodoras (family Doradidae) is described. The new species shares three characters with its congeners, the modified oral hood with distinct upper labial extensions, the first gill arch with enlarged accessory lamellae extending well onto medial face of gill filaments, and the pelvic fin inserted in anterior half of body. The new species is distinguished from congeners by having a large dark submarginal blotch on distal half of dorsal-fin spine and anteriormost dorsal-fin branched rays, lower labial extension of modified oral hood extending more posteriorly than upper labial extension, relatively few midlateral scutes, gas bladder moderately sized (not reduced), paired bony capsules on anteriormost vertebrae reduced to paired cup-like laminar ossifications separated by a triangular septum, pair of small, swelling-like diverticula on each side of the anterior chamber of gas bladder, a well-developed anterior nuchal plate, and nuchal foramina present. The new species was discovered from a single specimen collected in the rio Fresco, a tributary of the rio Xingu, and is described based on this and on additional material recently collected in the same area. A discussion of its placement within Leptodoras is also presented.

Comparison of physical properties of two exogenous surfactants: new parameter.

The pulmonary surfactant has essential physical properties for normal lung function. The most important property is the surface tension. In this work, it was evaluated the surface tension of two commercial exogenous surfactants used in surfactant replacement therapy, poractant alfa (Curosurf, Chiesi Farmaceuticals, Italy) and beractant (Survanta, Abbott Laboratories, USA) using new parameters. A Langmuir film balance (Minitrough, KSV Instruments, Finland) was used to measure surface tension of poractant alfa and beractant samples. For both samples, we prepared a solution of 1 mg/m dissolved in chloroform (100π`), which was applied over a subphase of milli-Q water (175 ml) in the chamber of the balance. The chamber has two moving barriers that can change its surface area between a maximal value of 112.5 cm 2 , and a minimal value of 22.5 cm 2, defining a balance cycle. Each surfactant had its surface tension evaluated during 20 balance cycles for three times. Four quantities were calculated from the experiment: Minimum Surface Tension (MTS), defined as the surface tension at minimal surface area during the first cycle; Mean Work Cycle (MWC), defined as the mean hysteresis area of the measured surface tension curve of the last 16 balance cycles; Critical Active Surface Area in Compression (CASAC) or in Expansion (CASAE), defined as the maximal chamber area where the surfactant is active on the surface in compression or expansion. The t-test was applied to verify for statistical significance of the results. Comproved with the MST is the same reported in literature, the differences between MWC, CASAC, and CASAE were statistically significant (p<0.001). The MWC, CASAC and CASAE were higher for poractant alfa than for beractant. A higher MWC for poractant alfa means higher elastic recoil of the lung in comparison with beractant. Using a different methodology, our results showed that poractant alfa is probably more effective in a surfactant replacement therapy than beractant due the use of poractant alfa in relation to the use of beractant in preterm infants with Respiratory Distress Syndrome (RDS).

Mechanical Measurements Of Two Exogenous Surfactants Using A Langmuir Film Balance:A Comparative Study

Rationale: The primary function of surfactant is to reduce the surface tension at air-liquid interface. In this study, the surface tension behavior of two commercial surfactants, poractant alfa (ChiesiFarmaceuticals,ltaly) and beractant (Abbott Laboratories,USA), were evaluated,using new parameters. Methods: We used a Langmuir film balance (Minitrough,KSV lnstruments,Finland) to measure of surface tension of both poractant alfa and beractant samples. For both samples,we prepared a solution of 1 mg/mdl dissolved in chloroform. The solution (1uL) was applied over a subphase of milli-Q water (175 ml) in the chamber of the balance. The chamber has two moving barriers that can change its surface area between a maximum value of 112.5 cm2 anda minimum value of 22.5 cm2, defining a balance cycle.lhree sample's films were evaluated for each sample, during 20 balance cycles. Here quantify two new variables, which is the mean hysteresis area of the measured curve surface tension of the last 16 balance cycles,defined here as Mean Work Cycle (MWC), and the moment that the surfactant is active in the surface, this measure is defined here as Active Surface Area Critical in the compression (ASACC) and the expansion (ASACE). The test was applied to compare the statistical significance of the results.

Characterization of an extrapolation chamber for low-energy X-rays: Experimental and Monte Carlo preliminary results

The extrapolation chamber is a parallel-plate ionization chamber that allows variation of its air-cavity volume. In this work, an experimental study and MCNP-4C Monte Carlo code simulations of an ionization chamber designed and constructed at the Calibration Laboratory at IFEN to be used as a secondary dosimetry standard for low-energy X-rays are reported. The results obtained were within the international recommendations, and the simulations showed that the components of the extrapolation chamber may influence its response up to 11.0%. (C) 2011 Elsevier Ltd. All rights reserved.

The use of metamaterial technology to improve a GTEM chamber

In this work, metamaterial patterns are applied to a GTEM – Gigahertz Transverse Electromagnetic Chamber to improve and give flexibility to its frequency response. The main goal is to achieve a better frequency resonance regardless the dimensions of the original chamber. Therefore, a comparison between the CLL – Capacitively Loaded Loop and Fractal metamaterial technology for these purposes, is done. Experimental results are compared to the simulated ones