Finite element analysis of bonded model Class I 'restorations' after shrinkage

Objectives. The C-Factor has been used widely to rationalize the changes in shrinkage stress occurring at the tooth/resin-composite interfaces. Experimentally, such stresses have been measured in a uniaxial direction between opposed parallel walls. The situation of adjoining cavity walls has been neglected. The aim was to investigate the hypothesis that: within stylized model rectangular cavities of constant volume and wall thickness, the interfacial shrinkage-stress at the adjoining cavity walls increases steadily as the C-Factor increases. Methods. Eight 3D-FEM restored Class I 'rectangular cavity' models were created by MSC.PATRAN/MSC.Marc, r2-2005 and subjected to 1% of shrinkage, while maintaining constant both the volume (20 mm(3)) and the wall thickness (2 mm), but varying the C-Factor (1.9-13.5). An adhesive contact between the composite and the teeth was incorporated. Polymerization shrinkage was simulated by analogy with thermal contraction. Principal stresses and strains were calculated. Peak values of maximum principal (MP) and maximum shear (MS) stresses from the different walls were displayed graphically as a function of C-Factor. The stress-peak association with C-Factor was evaluated by the Pearson correlation between the stress peak and the C-Factor. Results. The hypothesis was rejected: there was no clear increase of stress-peaks with C-Factor. The stress-peaks particularly expressed as MP and MS varied only slightly with increasing C-Factor. Lower stress-peaks were present at the pulpal floor in comparison to the stress at the axial walls. In general, MP and MS were similar when the axial wall dimensions were similar. The Pearson coefficient only expressed associations for the maximum principal stress at the ZX wall and the Z axis. Significance. Increase of the C-Factor did not lead to increase of the calculated stress-peaks in model rectangular Class I cavity walls. (C) 2011 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Multi-molecular markers and metals as tracers of organic matter inputs and contamination status from an Environmental Protection Area in the SW Atlantic (Laranjeiras Bay, Brazil)

The sources and concentrations of aliphatic hydrocarbons (AHs) and polycyclic aromatic hydrocarbons (PAHs), faecal and biogenic sterols, and trace metals at 10 sampling sites located in Laranjeiras Bay, a large Environmental Protection Area in the southern Atlantic region of Brazil, were determined to assess the sources of organic matter and the contamination status of estuarine sediments. Organic compounds were determined by GC-FID and GC-MS, and ICP-OES was used to evaluate trace metals. The total AHs concentration ranged from 0.28 to 8.19 mu g g(-1), and n-C-29 and n-C-31 alkanes were predominant, indicating significant inputs from higher terrestrial plants. Unresolved complex mixtures (UCM) were not detected at any site, suggesting that the study area was not significantly contaminated by fossil fuels. The total PAH concentration varied from 3.85 to 89.2 ng g(-1). The ratio between selected PAH isomers showed that combustion of biomass, coal, and petroleum is the rnain source of PAHs in the study area. The concentrations of the faecal sterols coprostanol and epicoprostanol were below the detection limits, suggesting that sewage was not a significant contributor to sedimentary organic matter. The concentrations of the trace metals (As, Cr, Cu, Ni, Pb and Zn) were low, except near sites located at the mouths of rivers that discharge into the study area and near urbanised regions (Paranagua city and the adjoining harbour). In general, the concentrations of PAHs were below the threshold effect concentrations (TEL) levels. Although the As, Cr and Ni concentrations were above the TEL levels, the study area can be considered as preserved from human activities.