Investigação dos métodos de separação, uso e aplicação da Lignina proveniente da biomassa lignocelulósica

This study investigated the main methods of separation of components of lignocellulosic biomass, with an emphasis on obtaining lignin and its application. The work was developed based on the concept of Biorefinery proposing full use of renewable raw materials and / or the use of lignocellulosic agricultural residues by biochemical or biotechnological conversion in obtaining high value added products with minimal environmental impact. From this premise, a literature review was performed in refereed journal articles and theses in order to gather enough material for critical analysis of usual and alternative methods in the literature. When researching methods that add value to lignin, it was found that with the technology found today, the cost required to have a degree of competitiveness is still too high, preventing much of the process. However, the isolated lignin can be used as raw material in the production of numerous types of biocomposites and polymers and other products such as phenols, benzene, dispersants, vanillin, emulsifying agents, antioxidants, pesticides, fertilizers, charcoal, concrete additives, among others. As an industrial production level is necessary, because the consumption of biomass will only grow over the years, it is necessary that new methods or technologies to be created in order to facilitate the extensive use of lignocellulosic biomass

Determinação comparativa do grau de deformação plástica aplicado a componentes obtidos por conformação

The manufacturing process of components of Pressure Vessels has a great importance in the efficiency during the operation and life cycle of the equipment. Taking this into account, the objective of this dissertation was to analyze the methods to determine the strain rate in formed components by measuring the components themselves, and posterior results comparison with the values found in manufacturing standards of Pressure vessels. In this study the whole manufacturing process of a component from a pressure vessel, known as Head or End, was accompanied. Using the methodology obtained from literatures it was possible to execute the relative and logarithmic deformation measurements of these components and compare with the obtained results by means of equations presented in the Standards as AD-Merkblatt and ASME (for pressure vessels). The found results were also compared with the logarithmic methodology, taking into account the deformation of the empirical mesh and the thickness of the components studied. It is possible to conclude from this study that despite the existence of empirical methods of measurement of strain rate in components plastically formed, it is recommended the adoption in all situation of the component manufacturing standard. It can be noticed and explained during the development of this study and through the results found