Selected Reaction Monitoring (SRM) frente a Western Blot

We propose the SRM technology as a complementary method to the Western Blot for the detection and quantification of proteins in a sample. The technique Western Blot has its own limitations: i) only a protein-of-choice is detected, ignoring any non-relevant proteins, ii) the sensitivity of the technique depends on the specificity of the antibody and iii) Western Blot is expensive and time-consuming. The advantages of SRM with respect Western Blot are remarkable: i) you can detect up to hundreds of different proteins in a sample, ii) SRM is more sensitive, because just 50 copies of the target protein per cell are enough for the detection and iii) once it has been made an investment in the necessary machinery to develop this technique, the detection of proteins in a sample turns into a cheaper, faster, more specific and full-quantitative procedure, without the need of using antibodies. First of all, SRM requires the identification of little peptides, obtained by tryptic digestion, whose sequence must be unique for a single protein or isoform. There is software for that aim. Then, it’s necessary to create isotope-labeled peptides of that identified for acting as internal standards. That sample is introduced in a triple quadrupole mass spectrometer: it passes through a first quadrupole, which functions as a filter, where the fragments are selected, previously ionized, attending to the mass/charge (m/z) relation that correspond to that unique fragments of the protein of interest. In this first selection may be other peptides from other proteins, with the same m/z but with different sequence. To select those that are exclusive from the target protein, the fragments are moved to a second quadrupole, where they are fragmented again with a physical method, and so new smaller fragments are generated. All the new fragments are conduced to the third quadrupole, where just those which come from the protein of interest are selected, attending at their m/z again. The target peptide concentration is determined by measuring the observed signal response for the target peptide relative to that of the isotopic-labeled peptide, the concentration of which is calculated from a pre-determined calibration-response curve. Calibration curves have to be generated for each target peptide in the sample. Because SRM technology is increasing its use, there have been developed databases where the scientific community upload information about protocols and standards for each protein with the aim to facilitate the work to other researchers.

Hormone-Mediated Gene-Specific Translation Regulation

The central role of translation regulation in the control of critical cellular processes has long been recognized. Yet the systematic exploration of quantitative changes in translation at a genome-wide scale in response to specific stimuli has only recently become technically feasible. Using a genetic approach, we have identified new Arabidopsis weak-ethylene insensitive mutants that also display defects in translation, which suggested the existence of a previously unknown molecular module involved in ethylene-mediated translation regulation of components of this signaling pathway. To explore this link in detail, we implemented for Arabidopsis the ribosome-footprinting technology, which enables the study of translation at a whole-genome level at single codon resolution[1]. Using ribosome-footprinting we examined the effects of short exposure to ethylene on the Arabidopsis translatome looking for ethylene-triggered changes in translation rates that could not be explained by changes in transcript levels. The results of this research, in combination with the characterization of a subset of the aforementioned weak-ethylene insensitive mutants that are defective in the UPF genes (core-components of the nonsense-mediated mRNA decay machinery), uncovered a translation-based branch of the ethylene signaling pathway[2]. In the presence of ethylene, translation of a negative regulator of ethylene signaling EBF2 is repressed, despite induced transcription of this gene. These translational effects of ethylene require the long 3´UTR of EBF2 (3´EBF2), which is recognized by the C-terminal end of the key ethylene-signaling protein EIN2 (EIN2C) in the cytoplasm once EIN2C is released from the ER-membrane by proteolytic cleavage. EIN2C binds the 3´EBF2, recruits the UPF proteins and moves to P-bodies, where the translation of EBF2 in inhibited despite its mRNA accumulation. Once the ethylene signal is withdrawn, the translation of the stored EBF2 mRNAs is resumed, thus rapidly dampening the ethylene response. These findings represent a mechanistic paradigm of gene-specific regulation of translation in response to a key growth regulator. Translation regulatory elements can be located in both 3′ and 5′ UTRs. We are now focusing on the ead1 and ead2 mutants, another set of ethylene-signaling mutants defective in translational regulation. Ribosome-footprinting on the ead1 mutant revealed an accumulation of translating ribosomes in the 5´UTRs of uORF-containing genes and reduction in the levels of ribosomes in the main ORF. The mutant is also impaired in the translation of GFP when this reporter is fused to WT 5´UTR of potential EAD1 targets but not when GFP is fused to the uORF-less versions of the same 5´UTRs. Our hypothesis is that EAD1/2 work as a complex that is required for the efficient translation of mRNAs that have common structural (complex 5´UTR with uORFs) and functional (regulation of key cellular processes) features. We are working towards the identification of the conditions where the EAD1 regulation of translation is required. [1] Ingolia, N. et al. (2009) Genome-Wide Analysis in Vivo of Translation with Nucleotide Resolution Using Ribosome Profiling. Science, 324; 218-222 [2] Merchante, C. et al. (2015) Gene-Specific Translation Regulation Mediated by the Hormone-Signaling Molecule EIN2. Cell, 163(3): 684-697