Influência da temperatura de calcinação do fosfogesso no desempenho de cimentos supersulfatados

The supersulfated cement (CSS) basically consist of up to 90% blast furnace slag, 10-20% of a source of calcium sulfate and a small amount of alkali activator, covered by European standard EN 15743/2010. Because of this SSC are considered "green cement" low environmental impact. The source of calcium sulfate used in the preparation of CSS can be obtained from natural sources, such as gypsum or from alternative sources (industrial products), such as phosphogypsum. The phosphogypsum is a by-product of the fertilizer industry, used in the production of phosphoric acid. In this process the phosphate rock is treated with sulfuric acid to give as the major product phosphoric acid (H3PO4), gypsum and a small amount of hydrofluoric acid. The chemical composition of gypsum is basically calcium sulfate dihydrate (CaSO4.2H2O), similar to gypsum, because it can be used in this type of cement. To become anhydrous, the calcination of gypsum is necessary. The availability of the source of calcium sulfate to react with the slag is dependent on its solubility that is directly related to its calcination temperature. The solubility of the anhydrous gypsum decreases with increasing calcination temperature. This study investigated the influence of temperature of calcination of phosphogypsum on the performance of CSS. Samples were prepared with 10 and 20% of phosphogypsum calcinated at 350 to 650 ° C using KOH as an alkaline activator at three different concentrations (0.2, 0.5 and 0.8%). The results showed that all mortars presented the minimum values required by EN 15743/2010 for 7 and 28 days of hydration. In general CSS containing 10% phosphogypsum showed slightly better compressive strength results using a lower calcination temperature (350 °C) and curing all ages. The CSS containing 20% of calcined gypsum at 650 °C exhibit satisfactory compressive strenght at 28 days of hydration, but at later ages (56 to 90 days) it strongly reduced. This indicates that the calcination temperature of phosphogypsum has a strong influence on the performance of the CSS.

Herança genética e marcadores moleculares associados à resistência de Euphorbia heterophylla L. aos herbicidas inibidores da ALS e PROTOX

This study aimed to assess the genetic inheritance, determine the better DNA isolation protocol for this species and to identify molecular markers associated with the Wild Poinsettia (Euphorbia heterophylla L.) resistance ALS- and PROTOX- inhibiting herbicides and. The genetic inheritance of resistance was determined from crosses between E. heterophylla biotypes susceptible (S) and resistant (R), backcrosses and F2 generation. The complete dominance of resistance was confirmed with dose response curves. Ten adjusted methods for DNA isolation described in the literature were tested. The specific primers for ALS and PROTOX genes were designed from the consensus DNA sequence of these genes, obtained by aligning the gene sequences of the species Manihot esculenta and Ricinus communis L. Additionally, it was assessed the transferability of twenty SSR (simple sequence repeat) markers designed for Manihot esculenta, because among the species of Euphorbiaceae with more developed SSRs markers, because it is the closest relative phylogenetic species of E. heterophylla. Regarding genetic inheritance, the frequencies observed in the F1, F2, RCs and RCr did not differ significantly from the expected frequencies for a trait controlled by two dominant genes for multiple resistance and a single dominant gene for simple resistance to ALS- and PROTOX-inhibiting herbicides. The similar levels of resistance to dosage up to 2000 g i.a. ha-1 of fomesafen and dosage up to 800 g i.a. ha-1 of imazethapyr observed in F1 (heterozygous) and homozygous R biotype confirm the complete dominance of resistance to PROTOX- and ALS-inhibiting herbicides, respectively. The 0.2%BME protocol allowed the isolation of 7,083 ng μL-1 DNA, significantly (P=0.05) higher than other methods. Co-isolation of phenolic compounds was observed in FENOL and 3%BME+TB methods, but the addition of polyvinylpyrrolidone (PVP40) in the protocol extraction buffer 3%BME+TA solved this problem. The primers designed for ALS and PROTOX genes amplified but not showed no visible polymorphism in agarose gel between the S and R biotypes of E. heterophylla. Regarding the SSR transferability, ten markers were transferred to E. heterophylla, however, these six primers showed polymorphism among S and R biotypes.