3 resultados para Subproduto agroindustrial
em Repositório Institucional da Universidade Tecnológica Federal do Paraná (RIUT)
Resumo:
The supersulfated cement (CSS) basically consist of up to 90% blast furnace slag, 10-20% of a source of calcium sulfate and a small amount of alkali activator, covered by European standard EN 15743/2010. Because of this SSC are considered "green cement" low environmental impact. The source of calcium sulfate used in the preparation of CSS can be obtained from natural sources, such as gypsum or from alternative sources (industrial products), such as phosphogypsum. The phosphogypsum is a by-product of the fertilizer industry, used in the production of phosphoric acid. In this process the phosphate rock is treated with sulfuric acid to give as the major product phosphoric acid (H3PO4), gypsum and a small amount of hydrofluoric acid. The chemical composition of gypsum is basically calcium sulfate dihydrate (CaSO4.2H2O), similar to gypsum, because it can be used in this type of cement. To become anhydrous, the calcination of gypsum is necessary. The availability of the source of calcium sulfate to react with the slag is dependent on its solubility that is directly related to its calcination temperature. The solubility of the anhydrous gypsum decreases with increasing calcination temperature. This study investigated the influence of temperature of calcination of phosphogypsum on the performance of CSS. Samples were prepared with 10 and 20% of phosphogypsum calcinated at 350 to 650 ° C using KOH as an alkaline activator at three different concentrations (0.2, 0.5 and 0.8%). The results showed that all mortars presented the minimum values required by EN 15743/2010 for 7 and 28 days of hydration. In general CSS containing 10% phosphogypsum showed slightly better compressive strength results using a lower calcination temperature (350 °C) and curing all ages. The CSS containing 20% of calcined gypsum at 650 °C exhibit satisfactory compressive strenght at 28 days of hydration, but at later ages (56 to 90 days) it strongly reduced. This indicates that the calcination temperature of phosphogypsum has a strong influence on the performance of the CSS.
Resumo:
The southern region of Brazil, especially the states of Parana and Santa Catarina stand out for growing grapes and apples for fresh consumption and in order to add value to these products, process the material for the production of wine, juices and jellies . As a result large quantities of by-products, such as peels, seeds and pulp are produced becoming environmental problems. Studies reuse of these by-products have attracted interest because they have shown a high biological potential, due to the presence of high levels of phenolic compounds, which are associated with a lower incidence of disease caused by oxidative stress, due to its antioxidant, antiinflammatory and antibacterial properties. Currently, few studies are presented on the phenolic composition and biological potential of waste grape variety Bordô (Vitis labrusca) and apple (Malus domestica) Gala variety, cultivated in southern Brazil. Within this context, the objectives of this study were: compare the efficiency of solidliquid and liquid-liquid extraction, perform the optimization and validation of analytical methodology by HPLC-DAD for the separation, identification and quantification of multiclass phenolic compounds, evaluate the activity antioxidant by sequestering methods of free radical 2,2-diphenyl-1 picrilhidrazina (DPPH) and 2,2-azino-bis (3- ethyl-benzthiazoline-6-sulphonic acid) (ABTS) solution, reduction of Fe3+ in Fe2+ method (FRAP), ORAC, RP-HPLC-ABTS online, Rancimat and determination of total phenolics three agro-industrial byproducts, pomace and stems grape Bordô produced in Paraná Southwest region and Gala apple pomace coming from the Santa Catarina West. Optimization and validation of chromatographic method showed satisfactory quality parameters for the compounds of interest and the solidliquid extraction was more efficient in extracting phenolic evaluated. The three byproducts evaluated showed significant levels of phenolic compounds when analyzed by HPLC, especially flavonoids, catechin and epicatechin besides that showed significant antioxidant capacity. The grape stems extract had the highest sequestration capacity of DPPH and ABTS radical and reduced iron, and high content of phenolic compounds. The apple pomace extract showed the best response to the Rancimat method, which indicates a high potential to protect the oil from lipid oxidation, was no significant difference when compared to synthetic antioxidant TBHQ. The results of this study showed that the agro-industrial coproducts analyzed are rich in phenolic compounds of high antioxidant capacity and therefore must be better explored by the food and pharmaceutical industries.
Resumo:
The Brazilian agricultural research agency has, over the years, contributed to solve social problems and to promote new knowledge, incorporating new advances and seeking technological independence of the country, through the transfer of knowledge and technology generated. However, the process of transfering of knowledge and technology has represented a big challenge for public institutions. The Embrapa is the largest and main brazilian agricultural research company, with a staff of 9.790 employees, being 2.440 researchers and an annual budget of R$ 2.52 billion. Operates through 46 decentralized research units, and coordinate of the National Agricultural Research System - SNPA. Considering that technology transfer is the consecration of effort and resources spent for the generation of knowledge and the validity of the research, this work aims to conduct an assessment of the performance of Embrapa Swine and Poultry along the production chain of broilers and propose a technology transfer model for this chain, which can be used by the Public Institutions Research – IPPs. This study is justified by the importance of agricultural research for the country, and the importance of the institution addressed. The methodology used was the case study with a qualitative approach, documentary and bibliographic research and interviews with use of semi-structured questionnaires. The survey was conducted in three stages. In the first stage, there was a diagnosis of the Technology Transfer Process (TT), the contribution of the Embrapa Swine and poultry for the supply chain for broiler. At this stage it was used bibliographical and documentary research and semi- structured interviews with agroindustrial broiler agents, researchers at Embrapa Swine and Poultry, professionals of technology transfer, from the Embrapa and Embrapa Swine and Poultry, managers of technology transfer and researchers from the Agricultural Research Service - ARS. In the second step, a model was developed for the technology transferring poultry process of Embrapa. In this phase, there were made documentary and bibliographic research and analysis of information obtained in the interviews. The third phase was to validate the proposed model in the various sectors of the broilers productive chain. The data show that, although the Embrapa Swine and Poultry develops technologies for broiler production chain, the rate of adoption of these technologies by the chain is very low. It was also diagnosed that there is a gap between the institution and the various links of the chain. It was proposed an observatory mechanism to approximate Embrapa Swine and Poultry and the agents of the broiler chain for identifying and discussing research priorities. The proposed model seeks to improve the interaction between the institution and the chain, in order to identify the chain real research demands and the search and the joint development of solutions for these demands. The proposed TT model was approved by a large majority (96.77%) of the interviewed agents who work in the various links in the chain, as well as by representatives (92%) of the entities linked to this chain. The acceptance of the proposed model demonstrates the willingness of the chain to approach Embrapa Swine and Poultry, and to seek joint solutions to existing problems.