Características químicas do solo e desempenho de culturas após quatro anos de aplicações de cama de aviário em diferentes épocas e níveis

Due to the high supply and its attractive cost, the poultry litter has been used in the southwestern region of Parana to the improvement of soil fertility seeking greater production of grains and pastures. However, the use without technical knowledge can minimize the benefits of poultry litter or even cause undesirable effects on soil, environmental pollution and also productivity losses in the used crops. The objective of this study was to evaluate the influence of different times of poultry litter application, predating the winter crop, associated with increasing levels, about soil chemical properties, release of nutrients and crop performances in four consecutive years (2011-2014). In the first three years the experimental design was randomized blocks with a split plot system and four replications. In the main plots were tested four poultry litter application times preceding the wheat production: 0, 15, 30 and 45 days before sowing (DAS); in the subplots were applied four poultry litter levels (wet basis): 0, 4, 8 and 12 Mg ha-1. Last year one more subdivision of plots was done, evaluating the use or not of nitrogen in coverage in wheat, at a dose of 100 kg N ha-1. The wheat cultivar used in the four years was the BRS 220. In three years it was evaluated the residual effect on soybean production (cultivar - BMX Turbo RR) and in one year on the beans. The chemical soil attributes were evaluated at four depths 0-2,5cm, 2,5-5cm, 5-10cm and 10-20cm, and also the rate of decomposition and nutrient release of poultry litter and the crop productivity. The different times of application concerning the poultry litter had little influence on the studied variables, demonstrating that the producer does not need to have a specific date (before planting) to the application of poultry litter. Potassium was fully released 60 days after the allocation of litter bags into the field; for nitrogen and phosphorus the release was slower. The use of increasing levels of poultry litter increased the levels of various soil elements, highlighting the potassium which reached 20 cm deep in the second year of evaluation. The increase in pH and in the base saturation occurred only in the upper layers, while the phosphorus reached 10 cm deep in the third year of the study. It was observed increased pH and base saturation. The use of increasing doses of poultry litter contributed to the wheat plant nutrition, significantly increasing the weight of a thousand grains, and the grain yield of wheat in all the evaluated years; the nitrogen fertilization in coverage also had significant effect for the fourth evaluated year. Also there was a significant response from the residual effect of poultry litter for crops planted in summer for both soybeans and beans.

Material para construção civil a partir de lodo de estação de tratamento de água, lama de polimento de mármore e resíduo de produção de cal

The rapid population growth is the great motivator for the development of the construction industry and the increased demand for drinking water, resulting in a gradual increase in the generation of solid waste. Thus, this work was carried out in order to recycle industrial and municipal wastes incorporating them into materials for civil construction. The composite produced from water treatment sludge and marble polishing mud, applying lime production waste as a binder, was evaluated for its mechanical performance and its morphological structure. The raw materials were characterized for their chemical composition, mineralogy, morphology, particle size and also the moisture content. With the featured materials nine compositions have been developed varying the content of the water treatment sludge between 25 to 50%, marble polishing mud between 35 to 50% and the lime production waste between 10 to 30%. The composites were subjected to mechanical strength tests, water absorption, chemical and mineralogical composition and morphology. The developed materials presented, on the 3rd day of hydration, maximum strength value of 4.65 MPa, the 7th day 6.36 MPa, on the 14th day 6.74 MPa, the 28th day 5.98 MPa, on the 60th day 8.52 MPa at 90th day 11.75 MPa and 180th day 12.06 MPa. The water absorption values after 28 days of hydration ranged from 16.27% to 26.32% and after 90 days, from 13.57% to 23.56%.

Análise de aspectos sociocientíficos em questões de química do Enem: subsídio para a elaboração de material didático para a formação cidadã

Acompanha: Manual didático: o emprego de aspectos sociocientíficos no ensino de química

Aproveitamento de subprodutos da indústria de carne suína: caracterização físico-química do queijo de porco

Headcheese is a meat sausage originated from Europe made from hog slaughter by-products. It is a much appreciated product in the South of Brazil which is increasingly established in the market, however it does not have official regulations yet. This study aimed to present the physicochemical characterization of headcheese in a western Santa Catarina industry supervised by Companhia Integrada de Desenvolvimento Agrícola de Santa Catarina and assess 10 different brands to find the relationship between chemical composition and texture profile analysis (TPA). Thus, the chemical composition, energy value, total nitrite, lipid oxidation and physical parameters (color and texture) were evaluated. The product exhibited great variability in moisture content, lipid and protein because the different formulations, processing and intrinsic and extrinsic characteristics of raw material. The utilization of offal provided higher cholesterol and iron levels, and the high content of collagen was accountable for the shear force responses (7.84 ± 1.68 N). The product showed higher amount of sodium, due to the use of additives, but calcium levels were compatible with other sausages. There was a predominance of polyunsaturated fatty acids and polyunsaturated fatty acids/saturated fatty acids ratio was more favorable than other sausage in the same category. Nitrite assured preservation effects and thus lower product levels of oxidation were observed. The high Water Activity and pH 6.5 showed that the product is susceptible to growth of pathogens and requires cooling for preservation. Its brownish occurred due to cooking and production of metmyoglobin. There was a strong positive correlation between collagen and attributes of TPA, especially for chewiness (r = 0.855). The use of Hierarchical Cluster Analysis and Principal Component Analysis were able to separate three groups based on the amount of collagen and texture attributes, especially hardness, gumminess and chewiness.

Caracterização química, atividade antioxidante e antimicrobiana do óleo essencial de Baccharis oreophila Malme

The Baccharis oreophila Malme belongs to the Asteraceae family. In Brazil are reported 120 species of Baccharis, most located in the South and Southeast regions, the latter presents the highest prevalence, especially in the state of São Paulo. Asteraceae is well known for the production of essential oils, which are liquid, volatile and aromatic substances produced by plants specialized for metabolism possess antibacterial, antifungal, and antioxidant properties. Thus, this study aimed, perform chemical and evaluate the antimicrobial and antioxidant activity of essential oil from dried leaves of B. oreophila collected in winter in Piraquara, Paraná. Obtaining essential oil was given by hydrodistillation in Clevenger apparatus, in triplicate, and the analysis was done using a gas chromatograph coupled to mass spectrometry GC / MS. The identification of the components was made based on retention indices calculated from the co-injection of a series of n-alkanes, followed by comparison of their mass spectra with literature. The antimicrobial activity was assessed by disk diffusion method and microdilution. The antioxidant activity was evaluated by the methods DPPH equivalent Trolox, ABTS and FRAP equivalent Trolox equivalent ferrous sulfate. The essential oil showed 0.47% yield. They identified 57 components (89.38%), 1.51% were classified as hydrogenated monoterpenes, oxygenated monoterpenes 15.14%, 34.84% and 37.87% hydrogenated sesquiterpenes sesquiterpenes oxygenates. As the major components were detected kusimono (16.37%), spathulenol (16.12%), the δ-cadinene (5.68%) and bicyclogermacrene (4.09%). The antimicrobial activity of essential oil was performed for the microorganisms Escherichia coli ATCC 25922, Staphylococcus aureus ATCC 25923, Candida albicans ATCC 18804 and Candida tropicalis ATCC 13803, the results showed that the essential oil showed activity against S. aureus Inhibitory Concentration minimum (CIM) 1250 g/mL. In the evaluation of antioxidant activity essential oil showed antioxidant potential for the three methods evaluated, with values of 1,468 m.mol.L-1, 7.126 m.mol.L-1 and 45.515 m.mol.L-1 for ABTS, DPPH and FRAP, respectively. These results demonstrate that the essential oil of B. oreophila showed antimicrobial potential against S. aureus and interesting antioxidant activity, especially for the reducing power of iron ion, demonstrating their potential for future industrial applications. It is important to emphasize that were not observed in the literature reports highlighting such biological properties of B. oreophila oil.

Acetilação do exopolissacarídeo (1→6)-β-D-glucana (lasiodiplodana): derivatização química e caracterização

Lasiodiplodan is an exocellular β-glucan with biological functionalities such as antioxidant, antiproliferative, hypocholesterolemic, protective activity against DNA damage induced by doxorubicin and hypoglycemic activity. Chemical derivatization of polysaccharide macromolecules has been considered as a potentiating mechanism for bioactivity. In this context, this work proposes the derivatization of lasiodiplodan by acetylation. Acetic anhydride was used as derivatizing agent and pyridine as catalyst and reaction medium. The derivatives obtained were evaluated by its water solubility, degree of substitution (DS), antioxidant potential, and characterized by infrared spectroscopy (FT-IR), thermal analysis, differential scanning calorimetry, X-ray diffraction and scanning electron microscopy. Acetylated derivatives with different degrees of substitution (1.26; 1.03; 0.66 and 0.48) were obtained, and there was correlation between the concentration of derivatizing agent and DS. FT-IR spectroscopy analysis confirmed the insertion of acetyl groups into derivatized macromolecules (LAS-AC) through of specific bands concerning to carbonyl group (C = O) and increase in C-O vibration. SEM analysis indicated that native lasiodiplodan presents morphological structure in the form of thin films with translucent appearance and folds along its length. Derivatization led to morphological changes in the polymer, including aspects thickness, translucency and agglomeration. Thermal analysis indicated the native sample and derivative with DS 0.48 presented three weight loss stages. The first stage occurred until 125 ° C (loss of water) and there were two consecutive events of weight loss (200 ° C - 400 ° C) attributed to molecule degradation. Samples with DS 1.26; 1.03 and 0.66 demonstrated four weight loss stages. The first stage occurred until 130 ° C (loss of water), following by two consecutive events of weight loss (200 ° C - 392 ° C) attributed to degradation of the biopolymer. The fourth stage was between 381 ° C and 532 ° C (final decomposition) with exothermic peaks between 472 ° C and 491 ° C. X-ray diffraction patterns showed that native and acetylated lasiodiplodan have amorphous structure with semicrystalline regions. Derivatization did not contribute to increased solubility of the macromolecule, but potentiated its antioxidant capacity. Acetylation of lasiodiplodan allowed to obtaining a new macromolecule with higher antioxidant potential than the native molecule and with technological properties applicable in various industrial sectors.

Estudo experimental do escoamento bifásico líquido gás em golfadas com leve mudança de direção

Gas-liquid two-phase flow is very common in industrial applications, especially in the oil and gas, chemical, and nuclear industries. As operating conditions change such as the flow rates of the phases, the pipe diameter and physical properties of the fluids, different configurations called flow patterns take place. In the case of oil production, the most frequent pattern found is slug flow, in which continuous liquid plugs (liquid slugs) and gas-dominated regions (elongated bubbles) alternate. Offshore scenarios where the pipe lies onto the seabed with slight changes of direction are extremely common. With those scenarios and issues in mind, this work presents an experimental study of two-phase gas-liquid slug flows in a duct with a slight change of direction, represented by a horizontal section followed by a downward sloping pipe stretch. The experiments were carried out at NUEM (Núcleo de Escoamentos Multifásicos UTFPR). The flow initiated and developed under controlled conditions and their characteristic parameters were measured with resistive sensors installed at four pipe sections. Two high-speed cameras were also used. With the measured results, it was evaluated the influence of a slight direction change on the slug flow structures and on the transition between slug flow and stratified flow in the downward section.