Associação de sistema biológico do tipo lodo ativado com reatores air lift e fotocatálise heterogênea com TiO2 para a remediação de efluente oriundo da produção industrial de TNT

Trinitrotoluene in the purification step (TNT) produced in industries, are carried out two washes at the end of the process. The first wash is done with vaporized water, which originates from the first effluent called yellow water, then the second washing with the use of sodium sulfite is performed (Na2SO3), generating a second effluent red water. This study aimed to study the individual effects, as well as the association of heterogeneous photocatalysis using TiO2 and biological treatment in air lift reactor using activated sludge (bacterial biomass) for the remediation of wastewater contaminated with nitroaromatic compounds in order to reduce toxicity and adjust the legal parameters according to regulatory agencies for disposal in waterways. The photocatalytic treatment was conducted by factorial design obtaining the best reaction conditions (pH 6.5 and concentration of TiO2 0.1 gL-1), with best results obtained at 360 minutes of reaction, reducing the absorbance 97.00%, 94.20% of the chemical oxygen demand (COD), 67.70% of total phenols, as well as a total reduction of observed peaks and assigned to nitroaromatic compounds by high-performance liquid chromatography. In the biological treatment, there was a 53.40% reduction in absorbance at 275 nm 10.00% 36.00% COD and total phenols in a short time (3 days), while for extended periods (48 days) there was an antagonistic influence on the results so that was the elevation of these parameters (COD and total phenols) instead of reducing. Chromatographic analysis confirmed the effectiveness of the biological degradation by reducing the peaks corresponding to compounds DNT and TNT. The Association of photocatalytic and biological treatments decreased results in the order of 91.10% absorbance, 70.26% of total phenols and 88.87% of COD. While the combination of biological and photocatalytic treatments generated relatively lower efficiencies, with 77.30% of absorbance reduction, 62.10% reduction of total phenols and a decrease of 87.00% of COD. In general, when comparing the chemical and biological processes in isolation, the photocatalytic treatment showed the best results. However, comparing the results of isolation and established associations, the association biological x photocatalysis showed more promising results in the treatment of red water effluent.

A altura de dossel e a adubação nitrogenada da pastagem podem afetar a nutrição nitrogenada do milho, num sistema de integração lavoura pecuária?

We conducted a field experiment near Abelardo Luz, Santa Catarina, from October 2012 to April 2014, to evaluate the effect interaction of nitrogen fertilization and height of canopy over the N nutrition of corn subsequently grown to pasture. The data belonging to this thesis are related to the first two production cycles obtained in sorghum pasture (2012/2013), oat (2013) and corn crop (2013/2014). In the evaluation of forage sorghum and oat it was used the same experimental design, consisting of randomized complete block in a factorial arrangement (2 x 2) with three replications. The first factor was considered canopy height (Low and High) and the second factor was the fertilization of cover crop pasture (0 and 200 kg N.ha-1). In phase I and II, the combination of factors evaluators were prepared in the same experimental unit. For corn crop the design was a randomized complete block in a factorial design (2X2X4X6) with three replications. Factors considered in corn were: canopy height of pasture (Low and High), nitrogen application times (NG - nitrogen in the grains and NP - nitrogen in pasture), nitrogen fertilization in corn (0, 100, 200 and 300 kg N.ha-1) and time (46, 53, 60, 67, 76 and 103 days after sowing the maize). In phases I and II, in general the use of N in the pasture increased the productive potential of the pasture and animal management and canopy height has changed the dynamics of structural components and botanical pasture. In cold conditions for long periods and not acclimatized plants the adoption of high nitrogen fertilization and height high grazing pasture leave vulnerable to damage caused by the freezing of plants. The anticipation of nitrogen fertilization on pasture positively affects the corn crop by increasing the accumulated dry matter and N content in the plant. Nitrogen nutritional content of corn with the anticipation of fertilization in pasture is suitable for obtaining high crop production in integrated crop-livestock system. When used nitrogen only coverage in corn sufficiency level in the nitrogen nutrition is achieved with the use of 100 kg N.ha-1. With the use of 200 kg N ha -1 NG and NP no difference in nitrogen content and nitrogen nutrition index.

Sistema de gestão em segurança e saúde do trabalho (SGSST) integrando a norma OHSAS 18001 e NR-18: proposta para o setor da construção civil

The job security issue is crucial for the development of construction due to the need to ensure the health of workers, which is done by means of laws and production management. Thus, among various other laws, was enacted NR-18, in order to ensure the worker's minimum conditions for the development work. Despite legislative developments on the subject, they have become ineffective against the excessive number of accidents in the construction industry, bringing the company to greater in ensuring the health and safety of its workers. In view of this need for improvement of working environment in a general appearance, both for purposes of ensuring the law obedience as comfort for workers and quality of the organization, the System Health Management and Safety (OHSMS) is a valid tool demonstrates the evolution of business management, as well as OHSAS 18001 which proposes to ensure the efficiency and integration of a system geared to safety and health at work by means of implements and adaptations of it, in order to bring significant improvements to conditions of work, especially in the form of a new culture to be adopted by the company. Addressing the problem, this paper aims to develop a management system by OHSAS 18001 which is consistent with the terms of NR-18 as it is this integration of OHSMS Management System of the company as a usual practice of that aims at an improvement of work safety in the business of Buildings.