2 resultados para Análise cromatográfica
em Repositório Institucional da Universidade Tecnológica Federal do Paraná (RIUT)
Resumo:
The application of roasted coffee oil directly on freeze dried soluble coffee is used to minimize the formation of fine poder which adhere on the glass packaging, which results in a negative visual appearance, as well as contributes to the aromatic impact when opening the packaging. The coffee oil is considered a high cost product obtained from Arabica coffee beans, previosly selected and roasted, by mechanical press. In Brazil the coffee culture and marketing results in the selection of the beans by type of defects and beverage, the volume of exportation works with types of coffee beans with low quantity of defects resulting in a large volume of defective coffee beans trading on the domestic market. Nevertheless, coffees which present defective grains like green, black-green beans present differences in the final flavor of the roasted coffees. The aim of this study was to evaluate the chemical composition of the oils extracted from grains classified as normal, green and black-green, at natural and roasted conditions. The oil was obtained by cold extraction using solvents of different polarities, and yield was calculated as well as its fatty acid composition. The oil of the roasted defective coffee grains was also used to prepare drinks of lyophilized soluble coffee in order to verify if jugdes were able to differenciate the sensory caracteristics of the beverages, in comparison to the product prepared using commercial oil obtained by mechanical pressing. Samples of oil obtained from defective grains showed similar extraction yields compared to hot extraction. Cromatographs of oils of the deffective grains did not showed differences compared to normal grains. In relation to the sensory analysis of the soluble coffee beverages, it was verified that when applying oils of light roasted black-green beans or oils of medium and dark roasted green beans obtained with rapid process, judges had more difficulties to distinguish differences between samples. Economic viability demonstrated that with the actual prices of the coffee beans, the use of defective beans could reduce in 64% the costs of the raw beans.
Resumo:
Trinitrotoluene in the purification step (TNT) produced in industries, are carried out two washes at the end of the process. The first wash is done with vaporized water, which originates from the first effluent called yellow water, then the second washing with the use of sodium sulfite is performed (Na2SO3), generating a second effluent red water. This study aimed to study the individual effects, as well as the association of heterogeneous photocatalysis using TiO2 and biological treatment in air lift reactor using activated sludge (bacterial biomass) for the remediation of wastewater contaminated with nitroaromatic compounds in order to reduce toxicity and adjust the legal parameters according to regulatory agencies for disposal in waterways. The photocatalytic treatment was conducted by factorial design obtaining the best reaction conditions (pH 6.5 and concentration of TiO2 0.1 gL-1), with best results obtained at 360 minutes of reaction, reducing the absorbance 97.00%, 94.20% of the chemical oxygen demand (COD), 67.70% of total phenols, as well as a total reduction of observed peaks and assigned to nitroaromatic compounds by high-performance liquid chromatography. In the biological treatment, there was a 53.40% reduction in absorbance at 275 nm 10.00% 36.00% COD and total phenols in a short time (3 days), while for extended periods (48 days) there was an antagonistic influence on the results so that was the elevation of these parameters (COD and total phenols) instead of reducing. Chromatographic analysis confirmed the effectiveness of the biological degradation by reducing the peaks corresponding to compounds DNT and TNT. The Association of photocatalytic and biological treatments decreased results in the order of 91.10% absorbance, 70.26% of total phenols and 88.87% of COD. While the combination of biological and photocatalytic treatments generated relatively lower efficiencies, with 77.30% of absorbance reduction, 62.10% reduction of total phenols and a decrease of 87.00% of COD. In general, when comparing the chemical and biological processes in isolation, the photocatalytic treatment showed the best results. However, comparing the results of isolation and established associations, the association biological x photocatalysis showed more promising results in the treatment of red water effluent.