Efeito de agentes de controle sobre a qualidade reprodutiva de rainhas de Apis mellifera L. (Hymenoptera: Apidae) africanizadas

The agriculture with the use of products with less environmental impact is expanding. In it, the producers offer their products without the use of synthetic chemical inputs, solving the phytosanitary problems with the use of biological or alternative control agents such as parasites, predators, entomopathogenic, alternative products, plant extracts and essential oils. These products can be considered safe to non-target organisms, but studies are needed to find these features on natural enemies and on the beneficial insects such as bees, common frequenter of cultures. In this sense, this study aims to evaluate the effects of control over reproductive quality queens of Apis mellifera L. (Hymenoptera: Apidae) Africanized. For this, it tested the action of control products on the production of A. mellifera queens, using the commercial entomopathogenic fungus Boveril® 1,0x108 (Beauveria bassiana) and aqueous extract of pomegranate (Punica granatum) at a concentration of 5% sterile distilled water with Tween (0.01%) and sterile distilled water (controls). The treatments were incorporated into a tissue type gauze, wrapped in an acrylic plate and packed inside minirrecrias type colonies for the production of queens on the day before the transfer of larvae. The next day were introduced battens with 30 domes with larvae to produce queens, so the workers have contacted the agent tested. From the emergence of all the queens, they were monitored to determine the measures of body weight (mg), length and width of wing and abdomen, length, width and height of the chest (mm) as well as the time of emergence of queens. The next step was evaluated the influence of the control agents in production creates, performing measurements of creating areas in cm2 for six straight weeks. It was found that the area creates Queens did not differ among the treatments. Histological analysis of hipofaringeanas of workers glands that came into contact with the control agents and the midgut of virgin queens were also held. Histological analysis differences were observed in the tissues when the treatments were compared with the respective controls.

Medidas de concentração de radônio proveniente de argamassas de cimento portland, gesso e fosfogesso

Portland cement being very common construction material has in its composition the natural gypsum. To decrease the costs of manufacturing, the cement industry is substituting the gypsum in its composition by small quantities of phosphogypsum, which is the residue generated by the production of fertilizers and consists essentially of calcium dihydrate and some impurities, such as fluoride, metals in general, and radionuclides. Currently, tons of phosphogypsum are stored in the open air near the fertilizer industries, causing contamination of the environment. The 226 Ra present in these materials, when undergoes radioactive decay, produces the 222Rn gas. This radioactive gas, when inhaled together with its decay products deposited in the lungs, produces the exposure to radiation and can be a potential cause of lung cancer. Thus, the objective of this study was to measure the concentration levels of 222Rn from cylindrical samples of Portland cement, gypsum and phosphogypsum mortar from the state of Paraná, as well as characterizer the material and estimate the radon concentration in an environment of hypothetical dwelling with walls covered by such materials. Experimental setup of 222Rn activity measurements was based on AlphaGUARD detector (Saphymo GmbH). The qualitative and quantitative analysis was performed by gamma spectrometry and EDXRF with Au and Ag targets tubes (AMPTEK), and Mo target (ARTAX) and mechanical testing with x- ray equipment (Gilardoni) and the mechanical press (EMIC). Obtained average values of radon activity from studied materials in the air of containers were of 854 ± 23 Bq/m3, 60,0 ± 7,2 Bq/m3 e 52,9 ± 5,4 Bq/m3 for Portland cement, gypsum and phosphogypsum mortar, respectively. These results extrapolated into the volume of hypothetical dwelling of 36 m3 with the walls covered by such materials were of 3366 ± 91 Bq/m3, 237 ± 28 Bq/m3 e 208 ± 21 Bq/m3for Portland cement, gypsum and phosphogypsum mortar, respectively. Considering the limit of 300 Bq/m3 established by the ICRP, it could be concluded that the use of Portland cement plaster in dwellings is not secure and requires some specific mitigation procedure. Using the results of gamma spectrometry there were calculated the values of radium equivalent activity concentrations (Raeq) for Portland cement, gypsum and phosphogypsum mortar, which were obtained equal to 78,2 ± 0,9 Bq/kg; 58,2 ± 0,9 Bq/kg e 68,2 ± 0,9 Bq/kg, respectively. All values of radium equivalent activity concentrations for studied samples are below the maximum level of 370 Bq/kg. The qualitative and quantitative analysis of EDXRF spectra obtained with studied mortar samples allowed to evaluate quantitate and the elements that constitute the material such as Ca, S, Fe, and others.

Uma nova abordagem do método Level Set baseada em conhecimento a e priori da forma

The analysis of fluid behavior in multiphase flow is very relevant to guarantee system safety. The use of equipment to describe such behavior is subjected to factors such as the high level of investments and of specialized labor. The application of image processing techniques to flow analysis can be a good alternative, however, very little research has been developed. In this subject, this study aims at developing a new approach to image segmentation based on Level Set method that connects the active contours and prior knowledge. In order to do that, a model shape of the targeted object is trained and defined through a model of point distribution and later this model is inserted as one of the extension velocity functions for the curve evolution at zero level of level set method. The proposed approach creates a framework that consists in three terms of energy and an extension velocity function λLg(θ)+vAg(θ)+muP(0)+θf. The first three terms of the equation are the same ones introduced in (LI CHENYANG XU; FOX, 2005) and the last part of the equation θf is based on the representation of object shape proposed in this work. Two method variations are used: one restricted (Restrict Level Set - RLS) and the other with no restriction (Free Level Set - FLS). The first one is used in image segmentation that contains targets with little variation in shape and pose. The second will be used to correctly identify the shape of the bubbles in the liquid gas two phase flows. The efficiency and robustness of the approach RLS and FLS are presented in the images of the liquid gas two phase flows and in the image dataset HTZ (FERRARI et al., 2009). The results confirm the good performance of the proposed algorithm (RLS and FLS) and indicate that the approach may be used as an efficient method to validate and/or calibrate the various existing equipment used as meters for two phase flow properties, as well as in other image segmentation problems.