Provenance of upper Triassic sandstone, southwest Iberia (Alentejo and Algarve basins): tracing variability in the sources

Laser ablation ICP-MS U–Pb analyses have been conducted on detrital zircon of Upper Triassic sandstone from the Alentejo and Algarve basins in southwest Iberia. The predominance of Neoproterozoic, Devonian, Paleoproterozoic and Carboniferous detrital zircon ages confirms previous studies that indicate the locus of the sediment source of the late Triassic Alentejo Basin in the pre-Mesozoic basement of the South Portuguese and Ossa-Morena zones. Suitable sources for the Upper Triassic Algarve sandstone are the Upper Devonian–Lower Carboniferous of the South Portuguese Zone (Phyllite–Quartzite and Tercenas formations) and the Meguma Terrane (present-day in Nova Scotia). Spatial variations of the sediment sources of both Upper Triassic basins suggest a more complex history of drainage than previously documented involving other source rocks located outside present-day Iberia. The two Triassic basins were isolated from each other with the detrital transport being controlled by two independent drainage systems. This study is important for the reconstruction of the late Triassic paleogeography in a place where, later, the opening of the Central Atlantic Ocean took place separating Europe from North America.

Evidence formulti-cycle sedimentation and provenance constraints from

Laser ablation ICP-MS U–Pb analyses were conducted on detrital zircons of Triassic sandstone and conglomerate from the Lusitanian basin in order to: i) document the age spectra of detrital zircon; ii) compare U–Pb detrital zircon ages with previous published data obtained from Upper Carboniferous, Ordovician, Cambrian and Ediacaran sedimentary rocks of the pre-Mesozoic basement of western Iberia; iii) discuss potential sources; and iv) test the hypothesis of sedimentary recycling. U–Pb dating of zircons established a maximum depositional age for this deposit as Permian (ca. 296Ma),which is about sixty million years older compared to the fossil content recognized in previous studies (Upper Triassic). The distribution of detrital zircon ages obtained points to common source areas: the Ossa–Morena and Central Iberian zones that outcrop in and close to the Porto–Tomar fault zone. The high degree of immaturity and evidence of little transport of the Triassic sediment suggests that granite may constitute primary crystalline sources. The Carboniferous age of ca. 330 Ma for the best estimate of crystallization for a granite pebble in a Triassic conglomerate and the Permian–Carboniferous ages (ca. 315Ma) found in detrital zircons provide evidence of the denudation of Variscan and Cimmerian granites during the infilling of continental rift basins in western Iberia. The zircon age spectra found in Triassic strata are also the result of recycling from the Upper Carboniferous Buçaco basin,which probably acted as an intermediate sediment repository.U–Pb data in this study suggest that the detritus from the Triassic sandstone and conglomerate of the Lusitanian basin is derived fromlocal source areas with features typical of Gondwana,with no sediment from external sources from Laurussia or southwestern Iberia.

Provenance of Holocene beach sand in the Western Iberian

Detrital zircons from Holocene beach sand and igneous zircons from the Cretaceous syenite forming Cape Sines (Western Iberian margin) were dated using laser ablation – inductively coupled plasma – mass spectrometry. The U–Pb ages obtained were used for comparison with previous radiometric data from Carboniferous greywacke, Pliocene–Pleistocene sand and Cretaceous syenite forming the sea cliff at Cape Sines and the contiguous coast. New U–Pb dating of igneous morphologically simple and complex zircons from the syenite of the Sines pluton suggests that the history of zircon crystallization was more extensive (ca 87 to 74 Ma), in contrast to the findings of previous geochronology studies (ca 76 to 74 Ma). The U–Pb ages obtained in Holocene sand revealed a wide interval, ranging from the Cretaceous to the Archean, with predominance of Cretaceous (37%), Palaeozoic (35%) and Neoproterozoic (19%) detrital-zircon ages. The paucity of round to subrounded grains seems to indicate a short transportation history for most of the Cretaceous zircons (ca 95 to 73 Ma) which are more abundant in the beach sand that was sampled south of Cape Sines. Comparative analysis using the Kolmogorov–Smirnov statistical method, analysing sub-populations separately, suggests that the zircon populations of the Carboniferous and Cretaceous rocks forming the sea cliff were reproduced faithfully in Quaternary sand, indicating sediment recycling. The similarity of the pre- Cretaceous ages (>ca 280 Ma) of detrital zircons found in Holocene sand, as compared with Carboniferous greywacke and Pliocene–Pleistocene sand, provides support for the hypothesis that detritus was reworked into the beach from older sedimentary rocks exposed along the sea cliff. The largest percentage of Cretaceous zircons (provenance and sediment recycling in modern and ancient detrital sedimentary sequences.

Provenance and technological analysis of selected cuneiform tablets from the late second millennium BC

The aim of the present study is to examine a group of clay tablets by thin-section petrography and thermogravimetric analysis in order to assess specific problems related to their provenance and manufacture technology. Two sets of documents dating to the fourteenth-thirteenth centuries BC will be considered separately throughout the thesis, with different research questions in mind for each case study. The petrographic data will be compared when possible with the chemical composition of the tablets, determined by pXRF and/or INAA in previous studies. On the whole, this dissertation is an attempt to combine textual, archaeological, petrographic, chemical and thermogravimetric information in order to get a better understanding of the materiality and the historical implications of the objects under examination; Resumo: O objetivo do presente estudo é examinar um grupo de tabuletas de argila por petrografia e análise termogravimétrica, a fim de avaliar problemas específicos relacionados com a sua proveniência e tecnologia de fabricação. Dois conjuntos de documentos que datam dos séculos XIV-XIII a.C. serão considerados separadamente ao longo da tese, com diferentes questões de pesquisa em mente para cada estudo de caso. Os dados petrográficos serão comparados quando possível com a composição química das tabuletas, determinada por pXRF e/ou INAA em estudos anteriores. No seu conjunto, esta dissertação é uma tentativa de combinar informação textual, arqueológica, petrográfica, química e termogravimétrica a fim de obter uma melhor compreensão da composição material e das implicações históricas dos objetos em análise.