Effect of landfill leachate on cereal nutrition and productivity and on soil properties.

Landfill leachates carry nutrients, especially N and K, which can be recycled in cropping systems. We applied doses of landfill leachate (0 [Control], 32.7, 65.4, 98.1, and 130.8 m3 ha-1 ) three times in 2008 and three times in 2009 on a clay Rhodic Kandiudult soil. In 2009, black oat (Avena strigosa L.) and corn (Zea mays L.) were cropped in succession and assessed for concentration of nutrients in leaves and for shoot biomass and grain yield, respectively. As a positive control, an additional treatment with urea (120 kg ha-1 of N) was studied in corn. Soil was sampled at four depths (down to 60 cm) in three sampling dates to assess chemical and biochemical properties. Concentration of nutrients in leaves, oat biomass (8530?23,240 kg ha-1), and corn grain yield (4703-8807 kg ha-1 ) increased with increasing doses of leachate. There was a transient increase in the concentration of nitrate in soil (3-30 mg kg-1), increasing the risk of N losses by leaching at doses above 120 kg ha-1 N, as revealed by an estimated N balance in the cropping system. Sodium and K in soil also increased with increasing doses of leachate but decreased as rainfall occurred. The activity of dehydrogenase decreased about 30% from the control to the highest dose of leachate and urea, suggesting an inhibitory effect of mineral N on microbial metabolism. Landfill leachate was promising as a source of N and K for crop productivity and caused minor or transient effects on soil properties.

Development of alternative methods for determining soil organic matter.

Soil organic matter (SOM) is important to fertility, since it performs several functions such as cycling, water and nutrient retention and soil aggregation, in addition to being an energy requirement for biological activity. This study proposes new trends to the Embrapa, Walkley-Black, and Mebius methods that allowed the determination of SOM by spectrophotometry, increasing functionality. The mass of 500 mg was reduced to 200 mg, generating a mean of 60 % saving of reagents and a decrease of 91 % in the volume of residue generated for the three methods without compromising accuracy and precision. We were able to optimize conditions for the Mebius method and establish the digestion time of maximum recovery of SOM by factorial design and response surface. The methods were validated by the estimate of figures of merits. Between the methods investigated, the optimized Mebius method was best suited for determining SOM, showing near 100 % recovery.

Sequential exhaustive extraction of a Mollisol soil, and characterizations of humic components, including humin, by solid and solution state NMR.

A comprehensive sequential extraction procedure was applied to isolate soil organic components using aqueous solvents at different pH values, base plus urea (base-urea), and finally dimethylsulfoxide (DMSO) plus concentrated H2SO4 (DMSO-acid) for the humin-enriched clay separates. The extracts from base-urea and DMSO-acid would be regarded as 'humin' in the classical definitions. The fractions isolated from aqueous base, base-urea and DMSO-acid were characterized by solid and solution state NMR spectroscopy. The base-urea solvent system isolated ca. 10% (by mass) additional humic substances. The combined base-urea and DMSO-acid solvents isolated ca. 93% of total organic carbon from the humin-enriched fine clay fraction (<2 ?m). Characterization of the humic fractions by solid-state NMR spectroscopy showed that oxidized char materials were concentrated in humic acids isolated at pH 7, and in the base-urea extract. Lignin-derived materials were in considerable abundance in the humic acids isolated at pH 12.6. Only very small amounts of char-derived structures were contained in the fulvic acids and fulvic acids-like material isolated from the base-urea solvent. After extraction with base-urea, the 0.5 m NaOH extract from the humin-enriched clay was predominantly composed of aliphatic hydrocarbon groups, and with lesser amounts of aromatic carbon (probably including some char material), and carbohydrates and peptides. From the combination of solid and solution-state NMR spectroscopy, it is clear that the major components of humin materials, from the DMSO-acid solvent, after the exhaustive extraction sequence, were composed of microbial and plant derived components, mainly long-chain aliphatic species (including fatty acids/ester, waxes, lipids and cuticular material), carbohydrate, peptides/proteins, lignin derivatives, lipoprotein and peptidoglycan (major structural components in bacteria cell walls). Black carbon or char materials were enriched in humic acids isolated at pH 7 and humic acids-like material isolated in the base-urea medium, indicating that urea can liberate char-derived material hydrogen bonded or trapped within the humin matrix.