Carbon assimilation, herbage accumulation, nutritive value, and grazing efficiency of Mulato II brachiariagrass under continuous stocking

Grazed pastures are the backbone of the Brazilian livestock industry and grasses of the genus Brachiaria (syn. Urochloa) are some of most used tropical forages in the country. Although the dependence on the forage resource is high, grazing management is often empirical and based on broad and non-specific guidelines. Mulato II brachiariagrass (Convert HD 364, Dow AgroSciences, São Paulo, Brazil) (B. brizantha × B. ruziziensis × B. decumbens), a new Brachiaria hybrid, was released as an option for a broad range of environmental conditions. There is no scientific information on specific management practices for Mulato II under continuous stocking in Brazil. The objectives of this research were to describe and explain variations in carbon assimilation, herbage accumulation (HA), plant-part accumulation, nutritive value, and grazing efficiency (GE) of Mulato II brachiariagrass as affected by canopy height and growth rate, the latter imposed by N fertilization rate, under continuous stocking. An experiment was carried out in Piracicaba, SP, Brazil, during two summer grazing seasons. The experimental design was a randomized complete block, with a 3 x 2 factorial arrangement, corresponding to three steady-state canopy heights (10, 25 and 40 cm) maintained by mimicked continuous stocking and two growth rates (imposed as 50 and 250 kg N ha-1 yr-1), with three replications. There were no height × N rate interactions for most of the responses studied. The HA of Mulato II increased linearly (8640 to 13400 kg DM ha-1 yr-1), the in vitro digestible organic matter (IVDOM) decreased linearly (652 to 586 g kg-1), and the GE decreased (65 to 44%) as canopy height increased. Thus, although GE and IVDOM were greatest at 10 cm height, HA was 36% less for the 10- than for the 40-cm height. The leaf carbon assimilation was greater for the shortest canopy (10 cm), but canopy assimilation was less than in taller canopies, likely a result of less leaf area index (LAI). The reductions in HA, plant-part accumulation, and LAI, were not associated with other signs of stand deterioration. Leaf was the main plant-part accumulated, at a rate that increased from 70 to 100 kg DM ha-1 d-1 as canopy height increased from 10 to 40 cm. Mulato II was less productive (7940 vs. 13380 kg ha-1 yr-1) and had lesser IVDOM (581 vs. 652 g kg-1) at the lower N rate. The increase in N rate affected plant growth, increasing carbon assimilation, LAI, rates of plant-part accumulation (leaf, stem, and dead), and HA. The results indicate that the increase in the rate of dead material accumulation due to more N applied is a result of overall increase in the accumulation rates of all plant-parts. Taller canopies (25 or 40 cm) are advantageous for herbage accumulation of Mulato II, but nutritive value and GE was greater for 25 cm, suggesting that maintaining ∼25-cm canopy height is optimal for continuously stocked Mulato II.

Orchestration of energy efficiency capabilities for a sustainable network management

The energy demand for operating Information and Communication Technology (ICT) systems has been growing, implying in high operational costs and consequent increase of carbon emissions. Both in datacenters and telecom infrastructures, the networks represent a significant amount of energy spending. Given that, there is an increased demand for energy eficiency solutions, and several capabilities to save energy have been proposed. However, it is very dificult to orchestrate such energy eficiency capabilities, i.e., coordinate or combine them in the same network, ensuring a conflict-free operation and choosing the best one for a given scenario, ensuring that a capability not suited to the current bandwidth utilization will not be applied and lead to congestion or packet loss. Also, there is no way in the literature to do this taking business directives into account. In this regard, a method able to orchestrate diferent energy eficiency capabilities is proposed considering the possible combinations and conflicts among them, as well as the best option for a given bandwidth utilization and network characteristics. In the proposed method, the business policies specified in a high-level interface are refined down to the network level in order to bring highlevel directives into the operation, and a Utility Function is used to combine energy eficiency and performance requirements. A Decision Tree able to determine what to do in each scenario is deployed in a Software Defined Network environment. The proposed method was validated with diferent experiments, testing the Utility Function, checking the extra savings when combining several capabilities, the decision tree interpolation and dynamicity aspects. The orchestration proved to be valid to solve the problem of finding the best combination for a given scenario, achieving additional savings due to the combination, besides ensuring a conflict-free operation.

Field and laboratory performance evaluation of a field-blended rubber asphalt.

ALICE is one of four major experiments of particle accelerator LHC installed in the European laboratory CERN. The management committee of the LHC accelerator has just approved a program update for this experiment. Among the upgrades planned for the coming years of the ALICE experiment is to improve the resolution and tracking efficiency maintaining the excellent particles identification ability, and to increase the read-out event rate to 100 KHz. In order to achieve this, it is necessary to update the Time Projection Chamber detector (TPC) and Muon tracking (MCH) detector modifying the read-out electronics, which is not suitable for this migration. To overcome this limitation the design, fabrication and experimental test of new ASIC named SAMPA has been proposed . This ASIC will support both positive and negative polarities, with 32 channels per chip and continuous data readout with smaller power consumption than the previous versions. This work aims to design, fabrication and experimental test of a readout front-end in 130nm CMOS technology with configurable polarity (positive/negative), peaking time and sensitivity. The new SAMPA ASIC can be used in both chambers (TPC and MCH). The proposed front-end is composed of a Charge Sensitive Amplifier (CSA) and a Semi-Gaussian shaper. In order to obtain an ASIC integrating 32 channels per chip, the design of the proposed front-end requires small area and low power consumption, but at the same time requires low noise. In this sense, a new Noise and PSRR (Power Supply Rejection Ratio) improvement technique for the CSA design without power and area impact is proposed in this work. The analysis and equations of the proposed circuit are presented which were verified by electrical simulations and experimental test of a produced chip with 5 channels of the designed front-end. The measured equivalent noise charge was <550e for 30mV/fC of sensitivity at a input capacitance of 18.5pF. The total core area of the front-end was 2300?m × 150?m, and the measured total power consumption was 9.1mW per channel.

Noise and PSRR improvement technique for TPC readout front-end in CMOS. technology.

ALICE is one of four major experiments of particle accelerator LHC installed in the European laboratory CERN. The management committee of the LHC accelerator has just approved a program update for this experiment. Among the upgrades planned for the coming years of the ALICE experiment is to improve the resolution and tracking efficiency maintaining the excellent particles identification ability, and to increase the read-out event rate to 100 KHz. In order to achieve this, it is necessary to update the Time Projection Chamber detector (TPC) and Muon tracking (MCH) detector modifying the read-out electronics, which is not suitable for this migration. To overcome this limitation the design, fabrication and experimental test of new ASIC named SAMPA has been proposed . This ASIC will support both positive and negative polarities, with 32 channels per chip and continuous data readout with smaller power consumption than the previous versions. This work aims to design, fabrication and experimental test of a readout front-end in 130nm CMOS technology with configurable polarity (positive/negative), peaking time and sensitivity. The new SAMPA ASIC can be used in both chambers (TPC and MCH). The proposed front-end is composed of a Charge Sensitive Amplifier (CSA) and a Semi-Gaussian shaper. In order to obtain an ASIC integrating 32 channels per chip, the design of the proposed front-end requires small area and low power consumption, but at the same time requires low noise. In this sense, a new Noise and PSRR (Power Supply Rejection Ratio) improvement technique for the CSA design without power and area impact is proposed in this work. The analysis and equations of the proposed circuit are presented which were verified by electrical simulations and experimental test of a produced chip with 5 channels of the designed front-end. The measured equivalent noise charge was <550e for 30mV/fC of sensitivity at a input capacitance of 18.5pF. The total core area of the front-end was 2300?m × 150?m, and the measured total power consumption was 9.1mW per channel.

Free living astigmatid mites (Astigmatina): new taxa, rearing and use for mesostigmatid (Mesostigmata) predatory mite production

The cohort Astigmatina is divided in two major groups: Psoroptidia, composed mainly by feather and fur mites, and Non-psoroptidia, a dominant component of the acarofauna in ephemeral habitats. In these environments Astigmatina usually are saprophages or feed on fungi or bacteria. Astigmatina protonymphs undergo a complete reorganization of the body structure leading to the production of heteromorphic deutonymphs, generally specialized for dispersion through phoresy using arthropods and vertebrates as phoronts. Although most Astigmatina occur in natural environments, some species live in anthropic environments, such as food deposits, where some of them became pests; some Astigmatina infest subterraneous plant organs. Despite their economic and ecological importance, studies on the diversity and taxonomy of Astigmatina in Brazil have been rare over the last decades. The general objective of this thesis was to collaborate to the knowledge of the diversity and to evaluate the potential practical uses of these mites in Brazil. For this, new genera and species were described, method for rearing dust mites was studied and the efficiency of Astigmatina as prey for edaphic predators was evaluated. A new species of Thyreophagus (Astigmatina: Acaridae) was described based on specimens collected in Brazil, the association of three other species of this genus with stored food was reviewed and a key to all species of this genus was prepared. The genus Neotropacarus (Astigmatina: Acaridae), commonly found on plant leaves, was reviewed with the redescription of two species and description of new species collected in Brazil and from the Philippines. Two new genera and seven new species of Acaridae associated with the bee family Apidae was described and a key to Acaridae genera in subfamily Horstiinae was prepared. Several species of Astigmatina were evaluated as prey for predatory mites Stratiolaelaps scimitus (Womersley) (Mesostigmata: Laelapidae) and Protogamasellopsis zaheri Abo-Shnaf, Castilho and Moraes (Mesostigmata: Rhodacaridae), which oviposited on all evaluated astigmatids, with Tyrophagus putrescentiae (Schrank) and Aleuroglyphus ovatus (Tropeau) (Acaridae) being the most suitable prey. Seven foods and two development period, 30 and 60 days, after the introduction of 400 females of two important dust mite species, Blomia tropicalis van Bronswijk, de Cock e Oshima and Dermatophagoides pteronyssinus (Trouessart) were evaluate. With the most suitable foods, the population growth were higher than 20.2 and 15.3 for B. tropicalis and D. pteronyssinus, respectively.