Synthesis and characterization of K2Ca5(SO4)6· H2O, the equivalent of görgeyite, a rare evaporite mineral

Görgeyite, K2Ca5(SO4)6··H2O, is a very rare monoclinic double salt found in evaporites related to the slightly more common mineral syngenite. At 1 atmosphere with increasing external temperature from 25 to 150 °C, the following succession of minerals was formed: first gypsum and K2O, followed at 100 °C by görgeyite. Changes in concentration at 150 °C due to evaporation resulted in the formation of syngenite and finally arcanite. Under hydrothermal conditions, the succession is syngenite at 50 °C, followed by görgyeite at 100 and 150 °C. Increasing the synthesis time at 100 °C and 1 atmosphere showed that initially gypsum was formed, later being replaced by görgeyite. Finally görgeyite was replaced by syngenite, indicating that görgeyite is a metastable phase under these conditions. Under hydrothermal conditions, syngenite plus a small amount of gypsum was formed, after two days being replaced by görgeyite. No further changes were observed with increasing time. Pure görgeyite showed elongated crystals approximately 500 to 1000 µ m in length. The infrared and Raman spectra are mainly showing the vibrational modes of the sulfate groups and the crystal water (structural water). Water is characterized by OH-stretching modes at 3526 and 3577 cm–1 , OH-bending modes at 1615 and 1647 cm–1 , and an OH-libration mode at 876 cm–1 . The sulfate 1 mode is weak in the infrared but showed strong bands at 1005 and 1013 cm–1 in the Raman spectrum. The 2 mode also showed strong bands in the Raman spectrum at 433, 440, 457, and 480 cm–1 . The 3 mode is characterized by a complex set of bands in both infrared and Raman spectra around 1150 cm–1 , whereas 4 is found at 650 cm–1.

Capturing Australian indigenous perception of virtual landscape

This short paper presents a means of capturing non spatial information (specifically understanding of places) for use in a Virtual Heritage application. This research is part of the Digital Songlines Project which is developing protocols, methodologies and a toolkit to facilitate the collection and sharing of Indigenous cultural heritage knowledge, using virtual reality. Within the context of this project most of the cultural activities relate to celebrating life and to the Australian Aboriginal people, land is the heart of life. Australian Indigenous art, stories, dances, songs and rituals celebrate country as its focus or basis. To the Aboriginal people the term “Country” means a lot more than a place or a nation, rather “Country” is a living entity with a past a present and a future; they talk about it in the same way as they talk about their mother. The landscape is seen to have a spiritual connection in a view seldom understood by non-indigenous persons; this paper introduces an attempt to understand such empathy and relationship and to reproduce it in a virtual environment.

Interactive lounge : an interdisciplinary approach to the design of a gestural interaction device

Among the many new opportunities that digital technologies are enabling are an increased capacity for viewers to interact not only with the program content, but with an increasingly wide array of other digital applications. Within this context this project has developed a new interaction device (incorporating gestural platform technology) and user interfaces to facilitate interactive access to digital media in a lounge room setting. This paper provides an overview of an interdisciplinary design process applied by Australasian CRC for Interaction Design (ACID) researchers—in order to develop the device and present in detail its unique features.

Controlled flexibility and lifecycle management of business processes through extensibility

Vendors provide reference process models as consolidated, off-the-shelf solutions to capture best practices in a given industry domain. Customers can then adapt these models to suit their specific requirements. Traditional process flexibility approaches facilitate this operation, but do not fully address it as they do not sufficiently take controlled change guided by vendors' reference models into account. This tension between the customer's freedom of adapting reference models, and the ability to incorporate with relatively low effort vendor-initiated reference model changes, thus needs to be carefully balanced. This paper introduces process extensibility as a new paradigm for customizing reference processes and managing their evolution over time. Process extensibility mandates a clear recognition of the different responsibilities and interests of reference model vendors and consumers, and is concerned with keeping the effort of customer-side reference model adaptations low while allowing sufficient room for model change.

The Order Fulfillment Process Model

This appendix describes the Order Fulfillment process followed by a fictitious company named Genko Oil. The process is freely inspired by the VICS (Voluntary Inter-industry Commerce Solutions) reference model1 and provides a demonstration of YAWL’s capabilities in modelling complex control-flow, data and resourcing requirements.

Process configuration in YAWL

This chapter describes how the YAWL meta-model was extended to support the definition of variation points. These variation points can be used to describe different variants of a YAWL process model in a unified, configurable model. The model can then be configured to suit the needs of specific settings, e.g. for a new organization of project.

The YAWL Architecture

The YAWL system is structured as a service-oriented architecture. It is composed of an extensible set of YAWL Services [1], each of which is deployed at a certain endpoint and offers one or multiple interfaces. Some of these services are userfacing, meaning that they offer interfaces to end users, while others offer interfaces to applications or other services.

4th Biennal Europea De Paisatge Barcelona, Spain March 22-26, 2006

Between the 22nd and the 26th of March 2006, Barcelona hosted the 4th Biennal Europea de Paisatge (European Biennial of Landscape Architecture). It comprised a day of presentations for the Rosa Barba Prize for European Landscape Architecture, a day long symposium, and a half day discussion on IBA park projects. Approximately 300 people attended, including sizable groups from Barcelona, France, The Netherlands, Denmark, and Germany. Only three participants from English speaking countries were present, despite simultaneous translation into English throughout.

Configurable multi-perspective business process models

A configurable process model provides a consolidated view of a family of business processes. It promotes the reuse of proven practices by providing analysts with a generic modelling artifact from which to derive individual process models. Unfortunately, the scope of existing notations for configurable process modelling is restricted, thus hindering their applicability. Specifically, these notations focus on capturing tasks and control-flow dependencies, neglecting equally important ingredients of business processes such as data and resources. This research fills this gap by proposing a configurable process modelling notation incorporating features for capturing resources, data and physical objects involved in the performance of tasks. The proposal has been implemented in a toolset that assists analysts during the configuration phase and guarantees the correctness of the resulting process models. The approach has been validated by means of a case study from the film industry.