Monte Carlo modelling of X-ray absorptiometry and its application to body composition studies

This thesis applies Monte Carlo techniques to the study of X-ray absorptiometric methods of bone mineral measurement. These studies seek to obtain information that can be used in efforts to improve the accuracy of the bone mineral measurements. A Monte Carlo computer code for X-ray photon transport at diagnostic energies has been developed from first principles. This development was undertaken as there was no readily available code which included electron binding energy corrections for incoherent scattering and one of the objectives of the project was to study the effects of inclusion of these corrections in Monte Carlo models. The code includes the main Monte Carlo program plus utilities for dealing with input data. A number of geometrical subroutines which can be used to construct complex geometries have also been written. The accuracy of the Monte Carlo code has been evaluated against the predictions of theory and the results of experiments. The results show a high correlation with theoretical predictions. In comparisons of model results with those of direct experimental measurements, agreement to within the model and experimental variances is obtained. The code is an accurate and valid modelling tool. A study of the significance of inclusion of electron binding energy corrections for incoherent scatter in the Monte Carlo code has been made. The results show this significance to be very dependent upon the type of application. The most significant effect is a reduction of low angle scatter flux for high atomic number scatterers. To effectively apply the Monte Carlo code to the study of bone mineral density measurement by photon absorptiometry the results must be considered in the context of a theoretical framework for the extraction of energy dependent information from planar X-ray beams. Such a theoretical framework is developed and the two-dimensional nature of tissue decomposition based on attenuation measurements alone is explained. This theoretical framework forms the basis for analytical models of bone mineral measurement by dual energy X-ray photon absorptiometry techniques. Monte Carlo models of dual energy X-ray absorptiometry (DEXA) have been established. These models have been used to study the contribution of scattered radiation to the measurements. It has been demonstrated that the measurement geometry has a significant effect upon the scatter contribution to the detected signal. For the geometry of the models studied in this work the scatter has no significant effect upon the results of the measurements. The model has also been used to study a proposed technique which involves dual energy X-ray transmission measurements plus a linear measurement of the distance along the ray path. This is designated as the DPA( +) technique. The addition of the linear measurement enables the tissue decomposition to be extended to three components. Bone mineral, fat and lean soft tissue are the components considered here. The results of the model demonstrate that the measurement of bone mineral using this technique is stable over a wide range of soft tissue compositions and hence would indicate the potential to overcome a major problem of the two component DEXA technique. However, the results also show that the accuracy of the DPA( +) technique is highly dependent upon the composition of the non-mineral components of bone and has poorer precision (approximately twice the coefficient of variation) than the standard DEXA measurements. These factors may limit the usefulness of the technique. These studies illustrate the value of Monte Carlo computer modelling of quantitative X-ray measurement techniques. The Monte Carlo models of bone densitometry measurement have:- 1. demonstrated the significant effects of the measurement geometry upon the contribution of scattered radiation to the measurements, 2. demonstrated that the statistical precision of the proposed DPA( +) three tissue component technique is poorer than that of the standard DEXA two tissue component technique, 3. demonstrated that the proposed DPA(+) technique has difficulty providing accurate simultaneous measurement of body composition in terms of a three component model of fat, lean soft tissue and bone mineral,4. and provided a knowledge base for input to decisions about development (or otherwise) of a physical prototype DPA( +) imaging system. The Monte Carlo computer code, data, utilities and associated models represent a set of significant, accurate and valid modelling tools for quantitative studies of physical problems in the fields of diagnostic radiology and radiography.

Torsional Interaction Studies on a Power System Compensated by SSSC and Fixed Capacitor

In this paper, a static synchronous series compensator (SSSC), along with a fixed capacitor, is used to avoid torsional mode instability in a series compensated transmission system. A 48-step harmonic neutralized inverter is used for the realization of the SSSC. The system under consideration is the IEEE first benchmark model on SSR analysis. The system stability is studied both through eigenvalue analysis and EMTDC/PSCAD simulation studies. It is shown that the combination of the SSSC and the fixed capacitor improves the synchronizing power coefficient. The presence of the fixed capacitor ensures increased damping of small signal oscillations. At higher levels of fixed capacitor compensation, a damping controller is required to stabilize the torsional modes of SSR.

Getting that piece of paper : mental health nurses' experience of undertaking doctoral studies in Victoria, Australia

The aim of this study was to explore the experience of mental health nurses undertaking doctoral studies. The study was conducted in Victoria, Australia. A descriptive exploratory approach to inquiry was used for this study. Participants were mental health nurses who had successfully completed a doctoral qualification. Eligibility for inclusion required participants to be residing in Victoria (irrespective of where their doctoral studies were undertaken) and to have conducted their research within the domain of mental health and/or currently employed in the field of mental health nursing. Of the 20 potential participants invited, 16 accepted the invitation. Five emergent themes were explicated from narrative analyses. These themes were being a trail blazer, positioning for professional advancement, achieving a balance between competing priorities, maintaining a commitment to the development of the profession, and a point of affirmation. An understanding of the experience of undertaking doctoral studies can be used to influence the development of strategies to encourage more mental health nurses to consider undertaking a doctoral degree.

Fuzzy logic power system stabilizer in multimachine stability studies

Power system stabilizers (PSS) work well at the particular network configuration and steady state conditions for which they were designed. Once conditions change, their performance degrades. This can be overcome by an intelligent nonlinear PSS based on fuzzy logic. Such a fuzzy logic power system stabilizer (FLPSS) is developed, using speed and power deviation as inputs, and provides an auxiliary signal for the excitation system of a synchronous motor in a multimachine power system environment. The FLPSS's effect on the system damping is then compared with a conventional power system stabilizer's (CPSS) effect on the system. The results demonstrate an improved system performance with the FLPSS and also that the FLPSS is robust

Gas boosted solar water heaters : Queensland case studies of installation practices in new homes

Because of the greenhouse gas emissions implications of the market dominating electric hot water systems, governments in Australia have implemented policies and programs to encourage the uptake of solar water heaters (SWHs) in the residential market as part of climate change adaptation and mitigation strategies. The cost-benefit analysis that usually accompanies all government policy and program design could be simplistically reduced to the ratio of expected greenhouse gas reductions of SWH to the cost of a SWH. The national Register of Solar Water Heaters specifies how many renewable energy certificates (RECs) are allocated to complying SWHs according to their expected performance, and hence greenhouse gas reductions, in different climates. Neither REC allocations nor rebates are tied to actual performance of systems. This paper examines the performance of instantaneous gas-boosted solar water heaters installed in new residences in a housing estate in south-east Queensland in the period 2007 – 2010. The evidence indicates systemic failures in installation practices, resulting in zero solar performance or dramatic underperformance (estimated average 43% solar contribution). The paper will detail the faults identified, and how these faults were eventually diagnosed and corrected. The impacts of these system failures on end-use consumers are discussed before concluding with a brief overview of areas where further research is required in order to more fully understand whole of supply chain implications.

Thermal studies of D.C. traction motors

This paper describes a thorough thermal study on a fleet of DC traction motors which were found to suffer from overheating after 3 years of full operation. Overheating of these traction motors is attributed partly because of the higher than expected number of starts and stops between train terminals. Another probable cause of overheating is the design of the traction motor and/or its control strategy. According to the motor manufacturer, a current shunt is permanently connected across the motor field winding. Hence, some of the armature current is bypassed into the current shunt. The motor then runs above its rated speed in the field weakening mode. In this study, a finite difference model has been developed to simulate the temperature profile at different parts inside the traction motor. In order to validate the simulation result, an empty vehicle loaded with drums of water was also used to simulate the full pay-load of a light rail vehicle experimentally. The authors report that the simulation results agree reasonably well with experimental data, and it is likely that the armature of the traction motor will run cooler if its field shunt is disconnected at low speeds

Panel studies of new venture creation : a review and suggestions for future research

We review all journal articles based on “PSED-type” research, i.e., longitudinal, empirical studies of large probability samples of on-going, business start-up efforts. We conclude that the research stream has yielded interesting findings; sometimes by confirming prior research with a less bias-prone methodology and at other times by challenging whether prior conclusions are valid for the early stages of venture development. Most importantly, the research has addressed new, process-related research questions that prior research has shunned or been unable to study in a rigorous manner. The research has revealed an enormous and fascinating variability in new venture creation that also makes it challenging to arrive at broadly valid generalizations. An analysis of the findings across studies as well as an examination of those studies that have been relatively more successful at explaining outcomes give good guidance regarding what is required in order to achieve strong and credible results. We compile and present such advice to users of existing data sets and designers of new projects in the following areas: Statistically representative and/or theoretically relevant sampling; Level of analysis issues; Dealing with process heterogeneity; Dealing with other heterogeneity issues, and Choice and interpretation of dependent variables.

Multicultural education, global studies and studies of Asia

Like other nations, Australia has experienced significant change in the past few decades as its society has become increasingly diverse. The new cultures and traditions that result from ethnic and religious diversity have both enriched Australian society and presented it with some challenges. Other challenges have resulted from increased globalisation. For example, the economic fallout from the recent global financial crisis indicates that global issues can impact across a range of levels, from multinational corporations and nation-states to local sites and individual livelihoods. Some suggest that Australia fared better than other nations during this economic crisis because of its export trade with China. Although this is disputed by economists, it highlights another facet of change that is impacting on Australian society and this relates to Australia’s growing engagement with the nations of Asia. There is increasing awareness in education systems that if young people are to achieve their potential as future citizens they need to be able to negotiate the cultural, social, political and economic ties that connect them to the global and regional community through work, leisure and citizenship. Multicultural education, global studies and studies of Asia play a particular part in helping young people to: • appreciate cultural diversity within and beyond their own nation • imagine with some accuracy how others view their world • participate in shaping a better future. This chapter explores the origins, distinctions and common features of each approach.

Cultural economic geography and global media studies : the rise of asian media capitals?

This paper considers the scope to develop an approach to the spatial dimensions of media and culture that is informed by cultural-economic geography. I refer to cultural-economic geography as that strand of research in the field of geography that has been informed on the one hand by the ‘cultural turn’ in both geographical and economic thought, and which focuses on the relationship between, space, knowledge and identity in the spheres of production and consumption, and on the other to work by geographers that has sought to map the scale and significance of the cultural or creative industries as new drivers of the global economy. The paper considers the extent to which this work enables those engaged with urban cultural policy to get beyond some of the impasses that have arisen with the development of “creative cities” policies derived from the work of authors such as Richard Florida as well as the business management literature on clusters. It will frame these debates in the context of recent work by Michael Curtin on media capitals, and the question of whether cities in East Asia can emerge as media capitals from outside of the US-Europe-dominated transnational cultural axis.

Democracy, participation and convergent media : case studies in contemporary online news journalism in Australia

The shift from 20th century mass communications media towards convergent media and Web 2.0 has raised the possibility of a renaissance of the public sphere, based around citizen journalism and participatory media culture. This paper will evaluate such claims both conceptually and empirically. At a conceptual level, it is noted that the question of whether media democratization is occurring depends in part upon how democracy is understood, with some critical differences in understandings of democracy, the public sphere and media citizenship. The empirical work in this paper draws upon various case studies of new developments in Australian media, including online- only newspapers, developments in public service media, and the rise of commercially based online alternative media. It is argued that participatory media culture is being expanded if understood in terms of media pluralism, but that implications for the public sphere depend in part upon how media democratization is defined.

Democracy, participation and convergent media : case studies in contemporary online news journalism in Australia

The shift from 20th century mass communications media towards convergent media and Web 2.0 has raised the possibility of a renaissance of the public sphere, based around citizen journalism and participatory media culture. This paper will evaluate such claims both conceptually and empirically. At a conceptual level, it is noted that the question of whether media democratization is occurring depends in part upon how democracy is understood, with some critical differences in understandings of democracy, the public sphere and media citizenship. The empirical work in this paper draws upon various case studies of new developments in Australian media, including online-only newspapers, developments in public service media, and the rise of commercially based online alternative media. It is argued that participatory media culture is being expanded if understood in terms of media pluralism, but that implications for the public sphere depend in part upon how media democratization is defined.

Aligning communication, cultural and media studies research and scholarship with industry and policy : Australian instances

This article reflects on aspects of what is claimed to be the distinctiveness of Australian communication, cultural and media studies, focusing on two cases – the cultural policy debate in the 1990s, and the concept of creative industries in the 2000s – and the relations between them, which highlight the alignment of research and scholarship with industry and policy and with which the author has been directly involved. Both ‘moments’ have been controversial; the three main lines of critique of such alignment of research and scholarship with industry and policy (its untoward proximity to tenets of the dominant neo-liberal ideology; the evacuation of cultural value by the economic; and the possible loss of critical vocation of the humanities scholar) are debated.